Inhaltszusammenfassung zur Seite Nr. 1
INSTALLATION &
OPERATION MANUAL
VW SERIES DRAWER WARMERS
MODELS
VW1S ML-126500
VW2S ML-126502
VW3S ML-126504
VW4S ML-126506
VW1SB ML-126501
VW2SB ML-126503
VW3SB ML-126505
VW4SB ML-126507
VW1D ML-126508
VW2D ML-126510
VW3D ML-126512
VW4D ML-126514
VW1DB ML-126509
VW2DB ML-126511
VW3DB ML-126513
VW4DB ML-126515
VW1C ML-126516
VW2C ML-126518
VW1CB ML-126517
VW2CB ML-126519
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201-0696, TEL. (502) 778-2791
FORM 31086 Rev. A (12-98)
– 1 –
Inhaltszusammenfassung zur Seite Nr. 2
TABLE OF CONTENTS GENERAL............................................................................................................................................. 3 INSTALLATION .................................................................................................................................... 3 Unpacking ................................................................................................................................. 3 Location ................................
Inhaltszusammenfassung zur Seite Nr. 3
Installation, Operation and Care of MODEL VW SERIES DRAWER WARMERS PLEASE KEEP THIS MANUAL FOR FUTURE USE GENERAL Vulcan-Hart Drawer Warmers are produced with quality workmanship and material. Proper installation, usage, and maintenance of your drawer warmer will result in many years of satisfactory performance. It is suggested that you thoroughly read this entire manual and carefully follow all of the instructions provided. The VW Series Drawer Warmers provide an efficient means of holding a v
Inhaltszusammenfassung zur Seite Nr. 4
LOCATION For efficient drawer warmer operation, choose a location that will provide easy loading and unloading without interfering with the final assembly of food orders. The installation location must allow adequate clearances for servicing and proper operation. INSTALLATION CODES AND STANDARDS The drawer warmer must be installed in accordance with: In the United States of America: 1. State and local codes. 2. National Electrical Code, ANSI/NFPA-70 (latest edition). Copies may be obtained from
Inhaltszusammenfassung zur Seite Nr. 5
Electrical Table Model Voltage Phase NEMA Plug VW1S, VW2S, VW3S, VW1SB, 110/120 5-15 1 VW2SB, VW3SB, VW1D, VW2D, 208/240 6-15 VW3D, VW1DB, VW2DB, VW3DB 110/120 5-15 VW4S, VW4SB, VW4D, VW4DB 1 208/240 6-20 110/120 5-15 VW1C, VW2C, VW1CB, VW2CB 1 208/240 6-15 – 5 –
Inhaltszusammenfassung zur Seite Nr. 6
WIRING DIAGRAMS – 6 – VW1D, VW1DB, VW1S, VW1SB VW2D, VW2DB, VW2S, VW2SB
Inhaltszusammenfassung zur Seite Nr. 7
– 7 – VW3D, VW3DB, VW3S, VW3SB VW4D, VW4DB, VW4S, VW4SB
Inhaltszusammenfassung zur Seite Nr. 8
– 8 – VW1C, VW1CB VW2C, VW2CB
Inhaltszusammenfassung zur Seite Nr. 9
OPERATION WARNING: THE DRAWER WARMER AND ITS PARTS ARE HOT. BE VERY CAREFUL WHEN OPERATING, CLEANING OR SERVICING THE DRAWER WARMER. CONTROLS (Fig. 1) OPERATOR INDICATOR LIGHT FULL RANGE THERMOSTAT PL-41269-1 Fig. 1 OPERATOR INDICATOR LIGHT – Lit when heat is supplied to drawer warmer. FULL RANGE THERMOSTAT – Acts as the ON/OFF switch to the drawer warmer system. • Turn to desired temperature setting to turn ON. • Turn counterclockwise until it stops to turn OFF. THERMOMETER (not shown) – Indic
Inhaltszusammenfassung zur Seite Nr. 10
OPERATING DRAWER WARMER 1. Connect electric power supply. 2. Turn thermostat knob to desired setting. • Heating elements begin heating. • Operator indicator light is lit. 3. Thermometer will indicate the interior temperature of the drawer warmer. 4. Once desired temperature is reached, heating elements will cycle on and off. • Operator light will cycle on and off with the heating elements. • Temperature in drawer warmer may fluctuate as the heating elements cycle on and off. 5. Monitor the food
Inhaltszusammenfassung zur Seite Nr. 11
CLEANING WARNING: UNPLUG ELECTRICAL POWER SUPPLY BEFORE CLEANING. Clean drawer warmer interior with a mild soap and water whenever food spill occurs. Never use harsh chemicals or abrasive pads to clean drawer warmer. Daily 1. Allow drawer warmer to cool before cleaning. 2. Clean drawers and the interior of the drawer warmer with a mild soap and water. 3. Rinse and dry with a soft dry cloth. 4. Clean exterior of drawer warmer with a clean damp cloth. MAINTENANCE WARNING: THE DRAWER WARMER AND
Inhaltszusammenfassung zur Seite Nr. 12
NOTES – 12 – FORM 31086 Rev. A (12-98) PRINTED IN U.S.A.
