Inhaltszusammenfassung zur Seite Nr. 1
Installation Instructions
Built-In Coffee Maker
Single
Double Single Double Decaf Large Hot Cappuccino
Espresso
Espresso Latté Latté Coffee Coffee Water Steamer
e24CM75GSS e24CM76GSS 102221 Rev. C-2
Inhaltszusammenfassung zur Seite Nr. 2
2 Before You Begin ReAD THeSe INSTRUCTIONS NOTe Installer: Leave these instructions with the owner. Owner use. before completely Guide Care and : Use Maker Coffee your Read s a h o s l a t I . e c n a i l p p a s i h t g n i t a r e p o r o f n o i t a m r o f n i y t e f a s t n a t r o p m i s n i a t n o c t I m your coffee maker. many suggestions for getting the best results fro maker. Read all instructions before installing the coffee l l i w e d i u g s i h T . s n o i t c u r t s n i
Inhaltszusammenfassung zur Seite Nr. 3
Finding Information TABle OF CONTeNTS Installation ...............................................................10 Before You Begin ...................................................... 2 Before You Start .................................. 10 Finding Information ............................................... Tools Needed for Installation ........... 11 Important Safety Instructions ........... 4 Plumbing Installation .......................... 12 Installing the Cabinet Glides ..........
Inhaltszusammenfassung zur Seite Nr. 4
4 Safety IMPORTANT SAFeTY INSTRUCTIONS Safety Precautions safety the read you until appliance this operate or install to attempt not Do a h t i w d e l e b a l e r a e d i u g s i h t t u o h g u o r h t s m e t i y t e f a S . e d i u g s i h t n i s n o i t u a c e r p Warning or Caution based on the risk type. Definitions l a i t n e t o p o t u o y t r e l a o t d e s u s i t I . l o b m y s t r e l a y t e f a s e h t s i l o b m y s s i h T d i o v a o t w o l l o f t a h t s e g a s s
Inhaltszusammenfassung zur Seite Nr. 5
Safety 5 WARNING To reduce the risk of fire, electrical shock, or injury when using your coffee maker, follow basic safety precautions including the following: Read all instructions before operating the coffee maker. IMPORTANT: Before performing any type of service or installation, make sure that electric power to the coffee maker is disconnected. IMPORTANT: To avoid the possibility of explosion or fire, do not store or use combustible, flammable, or explosive liquids or vapors (such as gaso
Inhaltszusammenfassung zur Seite Nr. 6
6 Safety General Safety Precautions (continued) WARNING • Do not tamper with the controls. • Clean the coffee maker thoroughly according to the Flushing Out the Coffee Maker section in the use and care guide before operating it for the first time. • When installing or cleaning the mechanical parts of the coffee maker, exercise care with hands and arms around the metal edges. • Many metal surfaces behind the front panel and inside the brewing compartment are hot when power is on. Exercise car
Inhaltszusammenfassung zur Seite Nr. 7
Preparing for Installation 7 Pl ANNING THe lOCATION 4” X 12” (100mm - 300mm) Ventilation Cut-Out in Cabinet Back 24” 1” Min. (610mm) (26mm) 22 1/8” - 22 3/8” Steam Barrier (562mm - 568mm) (provided) 3/4” (19mm) Min. Side Walls 20 3/4” 3/4” (19mm) (527mm) Level Support Platform 1/8” Optimal Water (3mm) and Electrical 17 7/8” Supply Location 22 3/16” (454mm) (564mm) Screw 8 places (provided) 3/4” (19mm) Min. Side Walls 8”” 1” Min. (26mm) (203mm) 1” (26mm) IMPORTANT: • All statutory regulations, lo
Inhaltszusammenfassung zur Seite Nr. 8
Preparing for Installation IMPORTANT: • DO NOT install the coffee maker in an unrestrained, free-standing cabinet. • During normal operation, the user must have access to the top of the unit. The user needs to be able to pour coffee into the coffee bins on top and, on model E24CM75GSS, be able to remove the water tank for filling and cleaning. Install the coffee maker low enough so that the user can reach the top of the unit easily when it is slid out of the cabinet. • When installing the
Inhaltszusammenfassung zur Seite Nr. 9
Preparing for Installation DIMeNSIONS 22 1/16 (56.0cm) 18 3/16” (44.0cm) 17 9/16” (44.5cm) 18 3/16” (46.2cm) 21 9/16” (54.8cm) 23 1/2” (59.6cm) 13/16” (2.0cm) ” 0 - , ” 6 1 / 1 + : s e c n a r e l o t l l A unless otherwise stated. TeCHNICAl S PeCIFICATIONS Power Requirements 120 Vac, 60Hz, 20A grounded, dedicated circuit required Total Connected Load 1.8kW (15A) Power Cord Length 60 inches Unit Weight 110 lbs. Shipping Weight 139 lbs. Fresh Water Capacity 5 Liters/1.3 Gallons (Model E24CM7
Inhaltszusammenfassung zur Seite Nr. 10
10 Installation BeFORe YOU START Remove the coffee maker from the packaging and inspect it for damage. Do not install a damaged maker. To prevent damage to the control panel door, do not set the appliance on the floor or counter prior to installation. Check to make sure all parts are included. PARTS lIST • Steam barrier with mounting screws • 2 guide assemblies with mounting screws • 6” metal shims, 1/16” (1mm) • Three foot 1/4” to 3/4” flexible water supply hose(E24CM76GSS) • Use & care guide
Inhaltszusammenfassung zur Seite Nr. 11
Installation 11 TOOl S NeeDeD FOR INSTAll ATION • Phillips screwdriver • Measuring tape • Level • Drill with 1/16” drill bit STeAM BARRIeR INSTAll ATION • Position the steam barrier inside the top of the cut-out. Push it towards the back wall until the back edge lines up with the back of the cabinet. • Attach it with the eight (8) provided screws. Steam Barrier (provided)
Inhaltszusammenfassung zur Seite Nr. 12
Installation 12 Pl UMBING INSTAll ATION CAUTION To prevent damage to the coffee maker due to hard water, prior to installation check the water hardness for the building where you will be installing the coffee maker. If necessary have a qualified water treatment specialist install a water treatment system. The water treatment system must be installed between the house plumbing and the coffee maker. Determine Water Hardness l a c o l e h t l l a C . s s e n d r a h r e t a w e h t e n i m r e
Inhaltszusammenfassung zur Seite Nr. 13
Installation 1 To house water supply To coffee maker Filter head everpure Filter Cartridge electrolux ACCFIl T-24 Filter Kit with Filter Installed
Inhaltszusammenfassung zur Seite Nr. 14
Installation 14 Install Ing the Cab Inet g l Ides he n t glides o t. The ne bi The cabinet glides mount to the inside of the ca he em allows t syst uide coffee maker slide into the cabinet glides. The g ns coffee bi he oading t for l coffee maker to slide in and out of the cabinet and for maintenance. to install the cabinet glides: • Determine the number of metal shims required to mount the cabinet glide assemblies according to the chart and diagrams below. The appliance is supplied with s
Inhaltszusammenfassung zur Seite Nr. 15
Installation 15 • Put the two (2) cabinet 4” (100mm) glide assemblies, and Cabinet Back Cutout for shims if necessary, as Air Circulation shown on the inside surfaces of the cabinet. Position them 3 1/2” (9.0cm) from the front edge of the cutout opening. • Insert the screws in the holes of the glides 3 1/2” without tightening them (8.9cm) completely. • Make sure the outside 3 9/16” distance between the (9.0cm) fixing angles is 22 1/8” (56.2cm) and that the 18” glides are level. C
Inhaltszusammenfassung zur Seite Nr. 16
Installation 16 INSTAll ING THe UNIT IN THe CABINeT • While supporting the coffee maker from below, insert it into the cabinet cutout. As you insert it into the cabinet, line up the glides on the appliance with the cabinet glides. The appliance should glide on the rails when slight pressure is applied to the front of the coffee maker. If it does not glide smoothly, check the distance between the glides again. • As you slide the coffee maker into the cabinet the locking tab on the glides wil
Inhaltszusammenfassung zur Seite Nr. 17
Installation 17 CONNeCTING THe Pl UMBING (e24CM76GSS) WARNING • To prevent damage to the coffee system due to hard water, prior to installation, check the water hardness for the building where you will be installing the coffee maker. See page 12 • To avoid leaks, do not overtighten fittings. • Insert the 3/4” gasket into the 3/4” fitting on the water supply hose. Make sure it is properly seated. • Connect the 3/4” end of the hose to the water inlet on the back of the coffee maker. • Insert
Inhaltszusammenfassung zur Seite Nr. 18
Installation 1 veRIFYING OPeRATION WARNING • Read the use and care guide completely before operation. • To keep the grinder from jamming, pour only roasted, unflavored coffee beans into the coffee bean container. • Plug the coffee maker into the dedicated, properly grounded, 3-prong power receptacle. • Test the lights by turning the light switch on and off. It is located on the brewing compartment ceiling, on the far right. • Turn on the power switch. It is located near the middle of the br
Inhaltszusammenfassung zur Seite Nr. 19
Installation 1 Troubleshooting (Continued) 4. Check the Solutions to Common Problems section of the use and care guide. 5. Repeat the verification process. 6. If the appliance still does not work, contact an authorized Electrolux at the phone number inside the front cover. INSTAll ATION CHeCKl IST WARNING • To ensure a safe and proper installation, the following checklist should be completed by the installer to ensure that no part of the installation has been overlooked. • Proper installat
Inhaltszusammenfassung zur Seite Nr. 20
® www.electroluxusa.com 1-877-4Electrolux www.electroluxca.com
