Inhaltszusammenfassung zur Seite Nr. 1
BATCH TOASTER
Models MBT208/MBT240
Place this chapter in the Toaster
Section of your Equipment Manual.
MANUFACTURED
EXCLUSIVELY FOR
®
MCDONALDS
BY
®
TOASTMASTER
A Middleby Company
1400 Toastmaster Drive
Elgin, IL 60120
PHONE: 1 (847) 741-3300
FAX: 1 (847) 741-4406
24-hour Service Hotline: 1 (800) 238-8444
TABLE OF CONTENTS
WARRANTY STATEMENT .........................................................................................................................................................
Inhaltszusammenfassung zur Seite Nr. 2
INTRODUCTION SAFETY Batch Toaster Information WARNING: IN CASE OF FIRE The Model MBT208/MBT240 Batch Toaster is a com- In case of fire, IMMEDIATELY disconnect the toaster mercial batch toaster designed to uniformly toast En- from its electrical power supply. glish muffins, bagels, and other bakery products in Use only fire extinguishers which are suitable for use large quantities. Up to six individual program settings on electric equipment, such as CO . 2 can be selected and programmed to toas
Inhaltszusammenfassung zur Seite Nr. 3
SPECIFICATIONS Overall Dimensions Width 17-1/2 (445mm) Depth (inc. rear cord clearance, peel removed) 28 (711mm) Depth (inc. rear cord clearance, peel in toaster) 32 (813mm) Height (inc. legs) 10-1/2 (267mm) Toasting Area Dimensions Width, Loading Area of Peel 11-1/4 (286mm) Length, Loading Area of Peel 16-1/2 (419mm) Vertical Clearance Above Peel in Toasting Chamber 1-3/4 (44mm) Toaster Information Approximate Net Wt. 58.0 lbs. (26.3kg) Approximate Shipping Wt. 69.4 lbs. (31.5kg) Constru
Inhaltszusammenfassung zur Seite Nr. 4
INSTALLATION IMPORTANT handle to the right side of the toaster, perform the It is the customers responsibility to report any con- following procedure: cealed or non-concealed damage to the freight com- Rotate the door handle in a COUNTER- pany. CLOCKWISE direction until it is free of its mounting shaft. See Figure 1. IMPORTANT The Batch Toaster may only be installed in a single- Remove the round metal plug that covers the unit, countertop configuration. handle mounting hole on the right si
Inhaltszusammenfassung zur Seite Nr. 5
2. Check that the appropriate receptacle is available Electrical Connection for the power cord plug. 3. Insert the power cord plug into its receptacle. IMPORTANT An electrical schematic for the toaster is provided 4. If required by national or local codes, connect an at the back of this Manual. equipotential ground wire to the lug next to the The electrical connection to the toaster requires a circuit breaker/fused disconnect. Consult appli- symbol (shown in Figure 3). The equipotential c
Inhaltszusammenfassung zur Seite Nr. 6
SET-UP, OPERATION, AND CLOSE PROCEDURES CAUTION - HOT SURFACES 8. Wait for the preset time to elapse. The control DURING OPERATION, THE PEEL AND will beep 5 times at 1-second intervals when the TOASTER ARE HOT. USE CAUTION AS YOU preset time reaches , and the display will HANDLE THE PEEL AND OPERATE THE TOASTER flash to show that the end of the preset time has TO AVOID INJURY. been reached. 9. Push the key. Setup 10. Pull the door handle forward to open the door. 1. Replace the lower deck in
Inhaltszusammenfassung zur Seite Nr. 7
Programming When programming mode is active, push the The Batch Toaster is pre-programmed with standard key to toggle the display between the menu programs at the factory. Perform the following following settings: steps ONLY if you wish to change a programs settings. a. IMPORTANT Programming a new menu program will OVERWRITE #:## is the currently-programmed set time. an existing program. Do not overwrite a program that When this display is shown, the set time can you wish to keep! be adjust
Inhaltszusammenfassung zur Seite Nr. 8
4. Cleaning the Toaster Close WARNING 1. Switch the switch to the OFF (O) position. WHEN CLEANING THE TOASTER, The fan will remain in operation to allow the toaster NEVER APPLY ENOUGH LIQUID TO STAND IN PLACE ON THE UNIT. DO NOT SPRAY, RINSE, to cool. OR SUBMERGE THE TOASTER. EXCESSIVE 2. After the fan stops, switch the circuit breaker/fused MOISTURE IN THE UNIT WILL CAUSE A SE- disconnect to the OFF (O) position. VERE ELECTRICAL HAZARD AND MAY OTH- ERWISE DAMAGE THE TOASTER. 3. Cleaning
Inhaltszusammenfassung zur Seite Nr. 9
TROUBLESHOOTING CORRECTIVE ACTION PROBLEM PROBABLE CAUSE Allow toaster to preheat until (ready) ap- Product is toasted Toaster was not adequately pears in the display. This should occur about 15 too dark or too preheated. minutes after electrical power is restored to the light. toaster. Enter Programming Mode to increase or decrease Preset toasting time is incor- the toasting time as necessary. Refer to the Pro- rect. gramming section of this Manual. Bakery products must be at room temperatur
Inhaltszusammenfassung zur Seite Nr. 10
PARTS IDENTIFICATION AND FUNCTION 10 11 14 36 33 32 13 36 31 12 2 27 34 21 19 4 41 18 20 35 16 28 40 36 30 23 28 24 42 3 8 17 28 15 6 7 36 25 9 26 24 22 29 10 28 5 28 28 37 1 30 39 38
Inhaltszusammenfassung zur Seite Nr. 11
Parts List AS SHOWN ON THE PREVIOUS PAGE: Item Part No. Qty. Description Item Part No. Qty. Description 1 41706 1 PANEL, LEFT SIDE 23 41840 1 PANEL, INSULATION COVER, RIGHT 2 39806 1 PANEL, RIGHT SIDE 24 41921 2 INSULATION, PRE-CUT 3 32458 1 PANEL, REAR 25a 41771 12 HEATING ELEMENT, 208V TOAST- 4 41902 1 PANEL, SSR MOUNTING ERS - 104V/204W 5 39804 1 LOWER DECK 25b 41842 12 HEATING ELEMENT, 230V TOAST- ERS - 115V/204W 6 42482 1 CONTROL PANEL 26 41841 1 RETAINER PANEL, HEATERS 7 41837 1 DECAL, CON
Inhaltszusammenfassung zur Seite Nr. 12
ORDERING AND SERVICE INFORMATION IMPORTANT You Batch Toaster comes with a warranty from Toastmaster. Terms and conditions of this warranty are described on the front cover of this Manual. During this warranty period, all parts replacement and servic- ing should be performed by your Toastmaster Authorized Service Agent. A service agency listing is sup- plied with your toaster. Service that is performed by parties other than your Toastmaster Authorized Ser- vice Agent will void your toasters
Inhaltszusammenfassung zur Seite Nr. 13
NOTES 13
Inhaltszusammenfassung zur Seite Nr. 14
ELECTRICAL WIRING DIAGRAM POWER 470k OHMS ON/OFF SEE (I/O) NOTE TERMINAL SWITCH BELOW TSTAT BLOCK 1µF NC HI LIMIT FAN TSTAT NO COOL DN CONTACTOR HEATING 12 3 4 56 78 9 10 11 12 ELEMENTS TIMER BOARD AC R3 R2 R1 12V+ IN TRANSFORMER 230Vp : 24Vs 0.5A FUSE - - - RELAY 1 RELAY 2 RELAY 3 + + + Wiring Diagram Notes: Capacitor and resistor inside dashed box are used ONLY on European MBT240 Heating elements are numbered back-to-front Relay 1 powers elements 1, 4, 7, and 10 Relay 2 controls elem
Inhaltszusammenfassung zur Seite Nr. 15
ELECTRICAL SCHEMATIC GND L1 L2 (E) (X) (Y) SEE 470k OHMS NOTE BELOW 1µF TSTAT NO COOL DOWN FAN TSTAT NC POWER ON/OFF (I/O) SWITCH 2 POLE HIGH LIMIT C1 C2 C 0.5A FUSE TFRMR 230Vp:24Vs TIMER BOARD +12V R1 R2 R3 SSR 1 SSR 2 SSR 3 HEATING ELEMENTS HEATING ELEMENTS HEATING ELEMENTS Schematic Notes: Capacitor and resistor inside dashed box are used ONLY on European MBT240 15
Inhaltszusammenfassung zur Seite Nr. 16
Toastmaster 1400 Toastmaster Drive Elgin, IL 60120 USA (847)741-3300 FAX (847)741-4406 Middleby Corp 24-Hour Service Hotline 1-800-238-8444 www.middleby.com A Middleby Company 16
