Inhaltszusammenfassung zur Seite Nr. 1
By Swisher
OWNER’S
MANUAL
MODEL NO.
LS67526S
LOG SPLITTER
Safety
IMPORTANT
Assembly
Read and follow all Safety
Precautions and Instructions
Operation
before operating this
equipment.
Service and Adjustment
Repair Parts
Rev.07.23.2003
1602 CORPORATE DRIVE, WARRENSBURG, MISSOURI 64093 PHONE 660-747-8183 Made In The
FAX 660-747-8650
USA
Manufacturing quality lawn care equipment since 1945
ONLS03S
Inhaltszusammenfassung zur Seite Nr. 2
LIMITED WARRANTY The manufacturer’s warranty to the original consumer purchaser is: This product is free from defects in materials and workmanship for a period of two (2) years from the date of purchase by the original consumer purchaser. We will repair or replace, at our discretion, parts found to be defective due to materials or workmanship. This warranty is subject to the following limitations and exclusions: 1) Engine Warranty All engines utilized on our products have a separate
Inhaltszusammenfassung zur Seite Nr. 3
SAFETY PRECAUTIONS This Safety Alert Symbol indicates important messages in this manual. When you see this symbol, carefully read the message that follows and be alert to the possibility of personal injury. Read this manual completely. This machine can amputate hands, feet, and throw objects. Failure to observe the following safety instructions could result in serious injury or death. WARNING: The engine exhaust from this product contains chemicals known to the s
Inhaltszusammenfassung zur Seite Nr. 4
Fluid escaping from a very small hole can be almost invisible. Do not check for leaks with your hand. Escaping fluid under pressure can have sufficient force to penetrate skin, causing serious personal injury. Leaks can be located by passing a piece of cardboard or wood over the suspected leak and looking for discoloration. IF injured by escaping fluid, see a doctor at once. Serious infection or reaction can develop if proper medical treatment is not administered immediately. • Spli
Inhaltszusammenfassung zur Seite Nr. 5
TOWING SAFETY • Do not allow persons to ride on splitter. Do not carry any cargo or wood on your splitter. It may fall off and endanger vehicles that are following you. • Be sure jack stand is in the travel position and coupling secure. This must also be retracted so not to interfere while towing. Retract kickstand by removing pin, rotating up, and replacing pin. • Never exceed 45 MPH while towing your splitter. Be extra cautious when traveling over rough terrain, especially
Inhaltszusammenfassung zur Seite Nr. 6
OPERATION Intended use: This log splitter is intended and designed to only split wood. NEVER use for any other purposes. Doing so can cause injury or VOID THE WARRANTY. ASSEMBLY INSTRUCTIONS This log splitter has been partially assembled at the factory. Refer to the drawings and part lists should it become necessary to disassemble the unit for repair or replacement of parts. Inspect all components for damage. WARNING: Exercise extreme caution, as parts are very heavy. Sufficient
Inhaltszusammenfassung zur Seite Nr. 7
FILLING THE HYDRAULIC RESERVOIR Fill the hydraulic reservoir with at least five gallons of Dextron III Automatic Transmission fluid or 10W AW hydraulic fluid. After the hydraulic reservoir and the engine crankcase are filled correctly with their respective oils, start the engine. Remember to set the throttle and turn on the fuel shut-off valve. The hydraulic pump should prime itself. With the engine running, move the hydraulic valve lever toward the wedge. This will cause the cylinder t
Inhaltszusammenfassung zur Seite Nr. 8
STANDARD HORIZONTAL TO VERTICAL The Standard Splitter has 2 operating positions: Horizontal, Vertical. Remove pin from below beam. Do not remove bolt and nut. Rotate beam into vertical position and pin so beam cannot fall into horizontal position. DO NOT TOW IN VERTICAL POSITION! IMPORTANT: When operating splitter in wooded areas, obtain a spark arrestor for the exhaust system. See your local engine dealer. When preparing logs, cut ends as square as possible. The maximum len
Inhaltszusammenfassung zur Seite Nr. 9
BEAM DETAIL 5 2 3 32 1 ITEM # DESCRIPTION PART # 26 1 CLIP PIN NB642 27 4 2 STEEL PIN 7293 31 3 HYDRAULIC FITTING 7291 4 STATIONARY LINE ASSEMBLY 7288 6 9 5 RAM CYLINDER 7354 7 10 6 1/2-13 X 3 GR5 BOLT NB131 12 8 11 7 SPLITTING WEDGE 7233 3 8 1/2-13 X 2 1/2 GR5 CARRIAGE BOLT NB643 20 25 15 9 RETURN LINE FITTING 7329 17 10 1/2-13 JAM 2-WAY LOCK NUT NB121 21 13 14 11 2-WAY PIPE NIPPLE 7292 22 19 12 MASTER CHAIN LINK 7424 24 13 COTTER PIN NB597 23 14 VALVE INLET FITTING 7387 15 VALVE CONTROL W/ LEV
Inhaltszusammenfassung zur Seite Nr. 10
SEE DETAIL 1 3 A B 5 4 2 13 6 9 7 12 A 8 17 11 8 15 14 19 6 10 B 16 24 21 Overhead Valve Engine 26 25 20 22 See Detail (Page 9) 23 21 5 21 34 51 24 6 56 28 36 40 30 34 35 41 42 52 37 56 43 41 55 46 29 44 47 53 57 48 31 33 45 32 39 38 17 16 51 48 49 18 27 50 54 ASSEMBLY DETAIL Parts List Page 11 10
Inhaltszusammenfassung zur Seite Nr. 11
SERVICE PARTS Please have Model and Serial Numbers ready when ordering parts. Color cannot be guaranteed on service parts. ITEM # DESCRIPTION PART # ITEM # DESCRIPTION PART # 1 RETURN HOSE 54" 7290 29 TIRE / WHEEL 7296 2 PRESSURE HOSE 48" 7289 30 COTTER PIN 2203CP 3 #12 HOSE CLAMP LS5001 31 WHEEL DUST COVER 2203DC 4 HYDRAULIC RESERVOIR 7319 32 CASTLE NUT 2203CN 5 1/2-13 X 3 1/2 GR5 BOLT NB577 33 WASHER 2203W 6 1/2-13 NYLOCK NUT NB281 34 TAPERED BEARING 2203B 7 RESERVOIR VENT PLUG 7379 35 BEARING
Inhaltszusammenfassung zur Seite Nr. 12
LOG SPLITTER HOW TO ORDER REPAIR PARTS: OWNER’S Each Log Splitter has its own serial number. Each engine has MANUAL its own serial number. The serial number for the Log Splitter will be found on the right hand side of the hydraulic oil reservoir. The serial number for the engine will be found on the top of the blower fan housing. All Log Splitter parts listed herein may be ordered directly from Swisher Mower & Machine Co. Inc., your nearest Swisher dealer, or from our website. MODEL NO
