Bedienungsanleitung Southbend SB1314

Inhaltszusammenfassung zur Seite Nr. 1

Instruction Sheet
Model SB1314
High Precision 6" Lathe Chuck
Grease fitting for
Hardened steel jaws
complete internal
for durability and
lubrication
extreme clamping
Chucks are heavy! Get assistance when
force and grip
installing or removing the chuck from the
lathe. Wear heavy duty leather boots for
Designed for
foot and toe protection, and keep hands and
up to
fingers away from all pinch points. Ignoring
4000 RPM
this warning can lead to a severe crushing
Universal
injury or fing

Inhaltszusammenfassung zur Seite Nr. 2

M f g . S i n c e 3 / 1 0 M o d e l S B 1 3 1 4 INSTRUCTIONS 6. Remove the back plate from the lathe and Operation and Safety place it on a workbench. • Chuck Key Safety: A chuck key left in the chuck can become a dangerous projectile 7. Set the chuck on the back plate, and roughly when the spindle is started. Always remove align the chuck using the alignment set the chuck key after using it. Develop a habit screws. of not taking your hand off of a chuck key unless it is away fro

Inhaltszusammenfassung zur Seite Nr. 3

M f g . S i n c e 3 / 1 0 M o d e l S B 1 3 1 4 INSTRUCTIONS Care & Maintenance 3 6 5 ! Always disconnect machine from power before 4 performing maintenance or serious personal injury may 7 result. For optimum performance from your chuck, 1 Note: Each jaw is marked follow the maintenance schedule below, and 1, 2, or 3 to correspond never hammer on the chuck, jaws, or a workpiece to its marked slot in the clamped in the chuck. Never subject the chuck to 2 chuck abrasives, flame, or

Inhaltszusammenfassung zur Seite Nr. 4

M f g . S i n c e 3 / 1 0 M o d e l S B 1 3 1 4 INSTRUCTIONS Troubleshooting If you need replacement parts, or if you are unsure how to do any of the solutions given here, feel free to call us at (360) 734-1540. Symptom Possible Cause Possible Solution The chuck has 1. Jaw is in wrong position. 1. Reinstall jaws in correct order and position on scroll hard spots or binds gear. completely. 2. Lack of lubrication, rust, burrs, or 2. Disassemble, de-burr, clean, and lubricate chuck. metal s