Bedienungsanleitung Rowenta Professional DE 873

Inhaltszusammenfassung zur Seite Nr. 1

Professional
Instructions for use
Made in Germany

Inhaltszusammenfassung zur Seite Nr. 2

IMPORTANT SAFEGUARDS When using your iron, basic safety precautions should always be followed, including the following: Read all instructions before using the iron. 1. Use iron only for its intended use. 2. To protect against a risk of electric shock, do not immerse the iron in water or other liquids. 3. The iron should always be turned to Minimum (Min) before plugging or unplugging from outlet. Never yank cord to disconnect from outlet, instead grasp plug and pull to disconnect. 4. Do not allow

Inhaltszusammenfassung zur Seite Nr. 3

SPECIAL INSTRUCTIONS 1. This is a 1200 watt or 1400 watt appliance (check rating on iron heel). To avoid a circuit overload, do not operate another high wattage appliance on the same circuit. 2. If an extension cord is absolutely necessary, a 12- ampere cord should be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that it can not be pulled or tripped over. 3. After the iron has cooled, wrap the cord loosely around the handle. 4. Your Rowenta applian

Inhaltszusammenfassung zur Seite Nr. 4

CDEF G H I B A Made in Germany L K J n Description: A Water filling inlet B Spray nozzle C Burst of steam button D Spray button E Variable steam control F Indicator light G Temperature control dial H Swivelling cord protector I Supply cord J Transparent water tank K Soleplate according to model – Stainless steel – Titan Plus L Water level indicator Features vary by model. Check packaging or markings on iron for exact features 4

Inhaltszusammenfassung zur Seite Nr. 5

Made in Germany BEFORE USE j Please read the instructions for use and the Important Safeguards carefully. j Slowly peel the protective cover off the soleplate. j It is normal for a small amount of smoke to be produced the first time the iron is used. This will quickly disappear. 3-WAY AUTO-OFF (NOT ON ALL MODELS) j If the iron is not moved while it is Made in Germany switched on, an internal safety switch will turn it off. It will turn off in 8 minutes if left vertically or in 30 seconds if lef

Inhaltszusammenfassung zur Seite Nr. 6

To avoid automatic switch off while the iron is heating up, always keep the iron on its heel. Start at low temperature and graduate to high temperature. For delicate fabrics we recommend carrying out a test on an unobtrusive part of the garment (inner seam). SETTING VARIABLE STEAM CONTROL Set the variable steam control to required steam volume. Steam can only be produced when the thermostat is in the red cotton/linen zone. Allow iron to heat up (light goes out) before activating the variable ste

Inhaltszusammenfassung zur Seite Nr. 7

Made in Germany Made in Germany VERTICAL STEAM (NOT ON ALL MODELS) j The iron can also be used vertically. This is especially useful for getting wrinkles out of hanging clothes, curtains, tapestries, etc. j Hold iron vertical, close to but not touching fabric. j Hold hem and pull gently downward on the fabric. j Press burst of steam button, a strong burst of steam penetrates deep into the fabric. WARNING: Never iron clothes while they are being worn! DRY IRONING j Sliding the variable steam con

Inhaltszusammenfassung zur Seite Nr. 8

SOFTENED WATER: There are many types of household water softeners and the water from many of them is perfectly acceptable for use in an iron. However, some types of softeners, particularly those that use chemicals such as salt, can cause the iron to leak or spit during use. If you experience this type of problem, we recommend that you try using inexpensive bottled spring water or untreated tap water. Never use 100% pure distilled water. Once you have changed water it will take several uses to co