Bedienungsanleitung Razor EN_130402

Inhaltszusammenfassung zur Seite Nr. 1

TM
OWNER’S MANUAL
read and understand this entire manual before riding!
Do not return to Store!
this does not affect your statutory rights.
note: manual illustrations are for demonstration purposes only. illustrations
may not refl ect exact appearance of actual product. Specifi cations subject to
change without notice.
Please have your 21 character product i.D. code ready before
contacting razor for warranty assistance and/or replacement parts.
Product i.D. Code: _____________ - ____________ -

Inhaltszusammenfassung zur Seite Nr. 2

ContentS Safety Warnings .............................................................................. 1-2 Repair and Maintenance......................................................................4 Before You Begin..................................................................................2 Check Before Riding .............................................................................5 Assembly Instructions ..........................................................................3

Inhaltszusammenfassung zur Seite Nr. 3

Safety WarningS PROPER RIDING ATTIRE WARNING: ALWAYS INSPECT SCOOTER PRIOR TO RIDING. Properly Always ensure rider is wearing proper protective equipment, such as an inspecting and maintaining your scooter can reduce the risk of injury. Always approved safety helmet. A helmet may be legally required by local law or inspect your scooter before riding and regularly maintain it. regulation in your area. Always wear shoes and keep shoelaces tied and out of the way of the wheels. Never ride ba

Inhaltszusammenfassung zur Seite Nr. 4

aSSemBly inS tru CtionS q attaching the Handlebar Warning: Failure to Tools Required: 5 mm Allen Wrench properly install and tighten the clamp may cause the rider to lose 1 Using a 5 mm Allen wrench, 2 With the front wheel pointed control and fall. If you are having loosen the bolts on the collar straight ahead, the handlebars difficulty understanding these clamp and slide clamp upward square to the front wheel and instructions, please contact Razor on the handlebar. With a the Razor

Inhaltszusammenfassung zur Seite Nr. 5

rePair anD maintenanCe q replacing the t ires/t ubes Tools Required: 5 mm Allen Wrench Nuts Bearings Wheel Hub Fastener Bolts 1 Completely deflate the tire. Use 2 Assemble the hub using the Inner Tube a 5 mm Allen wrench to remove the diagram at right. Tighten bolts Bearings Tire four bolts on the hub. Remove the using 5 mm Allen wrench. worn/damaged tire or inner tube Re-inflate. (Do not exceed 60 PSI.) and replace it with a new one. Note: Be careful not to lose the four nuts on the oppo

Inhaltszusammenfassung zur Seite Nr. 6

CHeCk Before riDing q Collar Clamp q t ires Using a 5 mm Allen wrench, check that the clamp bolts are tightened securely. Check the pressure of your tires and inspect them for any signs of damage. Check your front and rear bolts to ensure they are tight. q Wheels and Bearings It is the responsibility of the owner or guardian to periodically inspect the wheels for wear and tear, the axle for proper tightness, and bearings for side-to-side play and loose parts. When a wheel or wheel bearing dev

Inhaltszusammenfassung zur Seite Nr. 7

Inhaltszusammenfassung zur Seite Nr. 8

Safety reminDerS Pre-riDe CHeCkliS t loose Parts / t ire Care Be Careful! Check and secure all fasteners before every ride. Make You will see people on TV and maybe even people you know doing q q sure the collar clamp is locked properly in place before riding. tricks and stunts. These are people who have been practicing on Inspect tires for signs of wear or damage. Measure and scooters for a very long time. Don’t try something until you are adjust the PSI of the tires accordingly. Do not