Bedienungsanleitung Rane RPM 26z

Inhaltszusammenfassung zur Seite Nr. 1

HARDWARE MANUAL RPM 26z
PROGRAMMABLE MULTIPROCESSOR
RPM 26z
PROGRAMMABLE
MULTIPROCESSOR
12 LOCK A B 1 2 3 4 5 6 24
INPUT AES3 OUTPUT PRESET VIP ETHERNET STATUS POWER
QUICK START
This section is intended to help you make the physical connec-
Now click on the Poll button in the toolbar. A device name
tions and software manipulations necessary to get up and run-
and IP address should appear under the Live folder in the
ning with your sleek new RPM 26z. If you don’t read the entire
Project window

Inhaltszusammenfassung zur Seite Nr. 2

Front Panel Description RPM 26z PROGRAMMABLE MULTIPROCESSOR 12 LOCK A B 1 2 3 4 5 6 24 INPUT AES3 OUTPUT PRESET VIP ETHERNET STATUS POWER 1 2 1 3 4 5 6 7 1 Signal/Overload LED meters indicate the presence of significant audio signal or overload for Inputs and Outputs. These 3-color meters indicate the available headroom once the analog signal has been converted to digital: -4 dBFS (red, near clipping), -12 dBFS (yellow, high normal level), and -48 dBFS (green, low level). The analog signal lev

Inhaltszusammenfassung zur Seite Nr. 3

Audio Connections Digital (AES3) Input For each Input or Output Euroblock connector: AES3 is a popular 2-channel (stereo) digital audio interface com- • Connect the (positive) audio line to the ‘+’ terminal. monly found on professional digital audio equipment (digital • Connect the (negative) audio line to the ‘–’ terminal. mixers, DAT machines, etc.). Each channel of the AES3 digital • Connect the cable shield to the ground terminal. stream is treated independently within the RPM 26z. For

Inhaltszusammenfassung zur Seite Nr. 4

Remote Level Control Using Potentiometers VIP CONNECTION The VIP inherently prefers linear taper 10 kΩ potentiometers, (examples for VIP pin 1) which provide a nice audio taper “feel” for the end user. When used with suitable twisted pair wiring, the 10 kΩ value also of - pin 1 REF fers acceptable noise immunity and very long cable lengths. pin 1 20 kΩ (linear) AMX and Crestron Control There are two ways to control a Drag Net device from an AMX GND GND or Crestron system. Use either Ethernet