Bedienungsanleitung Invacare Solara Jr 1108526

Inhaltszusammenfassung zur Seite Nr. 1

Solara jr.™ Ventilator Tray
Assembly, Installation and Operating Instructions
Kit No. 1108526
SAVE THESE INSTRUCTIONS
NOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact Carrier/Invacare
for further instructions.
SAFETY SUMMARY
To ensure the safe and proper installation and use of the Ventilator Tray, these instructions
MUST be followed:
GENERAL WARNING
DO NOT install this equipment without first reading and understanding this
instruction sheet and the Solara jr.

Inhaltszusammenfassung zur Seite Nr. 2

INSTALLING THE VENTILATOR TRAY (FIGURE 1) 1. Remove and discard the two (2) SIDE mounting screws and washers securing the REAR crossmember to the base frame (DETAIL “A”). 2. Remove the REAR crossmember from the base frame (DETAIL “A”). 3. Remove and set aside the two (2) mounting screws and locknuts from the FRONT cross- member of the base frame (DETAIL “A”). 4. Remove and set aside the two (2) mounting screws and locknuts from the CENTER crossmember of the base frame (DETAIL “A”). 5. Remove the

Inhaltszusammenfassung zur Seite Nr. 3

DETAIL “A” Plug Buttons (STEP 5) REAR Ventilator Tray Crossmember (STEP 9) Mounting Screw (STEPS 6 and 9) Tilt Slide Housing (STEP 6) REAR Side Mounting Screw (STEP 1) Crossmember UPPER Frame Tube (STEP 8) (STEP 2) FRONT Crossmember Mounting Screw (STEP 3) Locknut (STEP 6) Washer (STEP 1) Side Mounting Locknut (STEP 3) Screw (STEP 1) FRONT Crossmember CENTER Crossmember Mounting Screw (STEP 4) CENTER Crossmember Locknut (STEP 4) DETAIL “B” REAR Upright FRONT Mounting Screws (STEP 10) Ventilator

Inhaltszusammenfassung zur Seite Nr. 4

USING THE VENTILATOR TRAY (FIGURE 2) NOTE: The ventilator tray straps are installed on the ventilator tray before the ventilator tray is shipped. 1. Position all six (6) strap slides on the outside of the ventilator tray. 2. Position the ventilator battery in the front portion of the ventilator tray. 3. Secure the two (2) battery straps around the top of the ventilator battery and clip together. 4. Position the ventilator in the rear portion of the ventilator tray. 5. Secure the four (4) ventila