Inhaltszusammenfassung zur Seite Nr. 1
EN FR ES
Inhaltszusammenfassung zur Seite Nr. 2
CONTENTS Contents The blower is used for blowing away leaves and other debris on the ground. When op- Introduction ................... 2 erating the blower, the operator must stand with both feet firmly on the ground. Key to symbols .................. 3 Safety instructions ............... 4 The Emissions Compliance Period referred Description ..................... 6 to on the Emissions Compliance label indi- Fuel handling .................... 11 cates the number of operating hours for which the
Inhaltszusammenfassung zur Seite Nr. 3
KEY TO SYMBOLS Checks and/or main- WARNING! The blower tenance shall be may throw objects at carried out after high velocity that can XX having switched off ricochet and hit the op- X the engine and discon- erator. This may cause nected the spark plug. serious eye damage. Cleaning at regular The blower operator X intervals is required. must make sure that no bystanders or animals come nearer than 50 feet (15 me- XX Approved protective ters). X goggles or visor must Whenever several be worn. oper
Inhaltszusammenfassung zur Seite Nr. 4
SAFETY INSTRUCTIONS Personal safety equipment Muffler Persons who use the blower shall wear the The muffler is designed to give the lowest following safety equipment: possible noise level and to direct the en- gine’s exhaust fumes away from the opera- 1. Approved ear protection. tor. Mufflers fitted with catalytic converters 2. Approved eye protection. are also designed to reduce harmful ex- 3. Approved protective gloves. haust components. 4. Boots or work shoes with a non--slip sole. 5. Face ma
Inhaltszusammenfassung zur Seite Nr. 5
SAFETY INSTRUCTIONS S Be careful, particularly if left hand opera- tion is applied. Avoid any direct body con- tact with inlet cover area. Keep jewelry, loose clothing, or clothing with loosely hanging straps, ties, tassels, etc., away from inlet cover area. S Do not operate the blower while standing on a ladder or a stand. Other safety measures S Operate the blower only at reasonable hours, i.e. not early in the morning or late at night when people might be disturbed. Comply with times listed i
Inhaltszusammenfassung zur Seite Nr. 6
DESCRIPTION The blower 3 2 4 23 1 9 7 17 21 20 22 8 6 16 11 15 18 10 19 14 25 24 10 12 5 13 1. Shoulder strap (125BV ) 13. Fan impeller X--SERIES 2. Throttle trigger 14. Standard nozzle 3. STOP switch 15. High velocity nozzle 4. Variable speed control 16. Blower tube 5. Fan housing 17. Tube clamp bolt 6. Fuel cap 18. Tube clamp nut 7. Air filter 19. Muffler 8. Choke 20. Ground wire 9. Primer bulb 21. Starter handle 10. Inlet cover 22. Starter device 11. Vacuum handle 23. Carburetor adjustment sc
Inhaltszusammenfassung zur Seite Nr. 7
DESCRIPTION Accessories (125B and 125BV ) X--SERIES X--SERIES 26 21 23 22 25 24 21. Vacuum device with collection components consisting of items 22--26 below 22. Collection bag tube 23. Collection bag 24. Vacuum tube in two sections 25. Screw 26. Shoulder strap 545154658 Rev. 2 7/10/07 English---7
Inhaltszusammenfassung zur Seite Nr. 8
DESCRIPTION Other equipment Safety equipment The following equipment on the blower is designed for protecting personnel and Throttle trigger materials. These components should S The speed and the output of the engine receive special attention whenever you are regulated by the throttle trigger (C). operate, inspect and service the blower. Stop switch S The stop switch (A) is used to stop the engine. A C Variable speed control S The variable speed control (D) is de- signed to allow setting engine
Inhaltszusammenfassung zur Seite Nr. 9
DESCRIPTION Ground wire S The nozzles (L)have a bayonet mount for connection to the blower tube. Air is S The ground wire (G) reduces static channeled through the blower tube to the build--up during operation in dry condi- tions. nozzles, where the air discharge velocity increases and the air stream discharge pattern is formed to provide best perfor- G mance. The length of the blower tube can be adjusted by twisting the nozzle to the left to disengage the bayonet mount and sliding the nozzle to
Inhaltszusammenfassung zur Seite Nr. 10
DESCRIPTION Choke Adjusting the carburetor S The choke (Q) is located below the air NOTFOR ALLMODELS filter cover and should be used every S There are three adjusting screws (R) for time the engine is cold--started. adjusting the carburetor: S Low speed jet S High speed jet S Adjustment screw for idling S Adjusting the carburetor involves adapt- ing the engine to local operating condi- tions, e.g. climate, altitude, gasoline and type of two--stroke engine oil used. For details about carburetor a
Inhaltszusammenfassung zur Seite Nr. 11
FUEL HANDLING S Always start by filling half the amount of Fuel mixture the gasoline to be used. Then add the CAUTION! The machine is equipped with entire amount of oil. Mix (shake) the fuel a two--stroke engine and must always be mixture. Add the remaining amount of run using a mixture of gasoline and two-- gasoline. stroke engine oil. It is important to accu- S Mix (shake) the fuel mixture thoroughly rately measure the amount of oil to be before filling the machine’s fuel tank. mixed to ensure
Inhaltszusammenfassung zur Seite Nr. 12
STARTING AND STOPPING Starting: Hold the body of the machine on the ground using your left hand (CAUTION! Not with your foot!). Firmly grip the starter rope handle with your right hand. DO NOT squeeze throttle trigger. Slowly pull out the cord until you feel some resistance (the starter pawls grip); then quickly and powerfully pull the cord. WARNING: Never wrap the starter cord around your hand. Min. 10 ft. Pull starter handle until engine attempts to (3 m) run, but no more than 3 pulls. Move ch
Inhaltszusammenfassung zur Seite Nr. 13
USING THE BLOWER To blow away debris on the ground Fitting the blower tube and nozzle on the blower WARNING: When fitting the blow- er tube and nozzle, the engine must be switched off. The blower tube (T) has a pegged slot mounting system to the unit. To install or remove the blower tube (or collection bag tube for 125BV ), the tube clamp X--SERIES bolt must be removed. Align slot in the blower air outlet with the raised rib on the tube and insert tube until the holes in the tube and housing ali
Inhaltszusammenfassung zur Seite Nr. 14
USING THE BLOWER 1. Open the collection bag. Insert the WARNING: Never start the blower collection bag tube from inside the bag to if the inlet cover is not closed, is fit in the vacuum inlet opening of the bag damaged or cannot be closed as shown. Ensure elastic is seated in (except if the vacuum tube is fitted). groove. Close the zipper on the bag. 2. Remove the blower tube and install the WARNING: Do not operate the collection bag tube. Install and tighten blower while standing on a ladder or
Inhaltszusammenfassung zur Seite Nr. 15
USING THE BLOWER Vacuuming WARNING: Always check that Before vacuuming, put on the required the collection bag is intact and the safety equipment. zipper is closed before starting the blower. Never use a damaged bag. WARNING: When working with There is risk of injury due to flying the blower, wear the required per- debris. Be careful, particularly if left sonal safety equipment: hand operation is applied. Avoid any 1. Hearing protection. direct body contact with the ex- 2. Eye protection. haust
Inhaltszusammenfassung zur Seite Nr. 16
MAINTENANCE Maintenance Safety The owner is responsible for the perfor- BB mance of all required maintenance as defined in the operator’s manual. Disconnect the spark plug before perform- ing maintenance, except carburetor adjust- ments. WARNING: Improper mainte- nance could result in serious engine damage or in serious injury. Carburetor Your Husqvarna product has been designed and manufactured to specifications that re- duce harmful emissions. After the engine has used 8--10 tanks of fuel, the
Inhaltszusammenfassung zur Seite Nr. 17
MAINTENANCE CC DD FF EE WARNING: Mufflers fitted with catalytic converters get very hot duringuseandremainsofor some time after stopping. This also ap- plies at idle speed. Contact can re- sult in burns to the skin. Remember theriskof fire! Air filter WARNING: Bear in mind that: Engine exhaust fumes contain car- bon monoxide, which can cause carbon monoxide poisoning. For The air filter (GG) must be regularly cleaned this reason you should not start or to remove dust and dirt in order to avoid:
Inhaltszusammenfassung zur Seite Nr. 18
MAINTENANCE Weekly maintenance Spark plug S Check the condition of the starter device, the starter cord and the tensioning spring. Replace damaged parts. S Check the condition of the air intake at The spark plug condition is influenced by: the starter device. Remove debris if it is S Incorrect carburetor adjustment. clogged. S An incorrect fuel mixture (too much or in- S Clean the outside of the spark plug. Re- correct type of oil). move it and check the electrode gap. Ad- S Poor quality gasolin
Inhaltszusammenfassung zur Seite Nr. 19
TECHNICAL DATA Technical data 125B 125B 125BV X--SERIES X--SERIES Engine 3 Cylinder volume, cu.in./cm 1.7/28 1.7/28 1.7/28 Cylinder bore, inch/mm 1.4/35 1.4/35 1.4/35 Stroke, inch/mm 1.130/28.7 1.130/28.7 1.130/28.7 Idle speed, rpm 2,800--3,200 2,800--3,200 2,800--3,200 Max. speed - blowing, rpm: 8,600 8,600 8,600 Max. speed - vacuuming, rpm: ---- 7,500 7,500 Max. engine output, acc. to ISO 8893, hp/kW 1.1/0.8 1.1/0.8 1.1/0.8 Catalytic converter muffler Yes Yes Yes Speed--regulated ignition syst
Inhaltszusammenfassung zur Seite Nr. 20
WARRANTY STATEMENT SECTION1: LIMITEDWARRANTY THESE PRODUCTS EXCEPT TO THE EX- TENT PROHIBITED BY APPLICABLE LAW. Husqvarna warrants Husqvarna product to ANY IMPLIED WARRANTY OR MER- the original purchaser to be free from defects in material and workmanship from the date of CHANTABILITY OR FITNESS FOR A PAR- TICULAR PURPOSE ON THESE PROD- purchase for the “Warranty Period” of the UCTS IS LIMITED IN DURATION TO THE products as set forth below: Lifetime Warranty: Ignition coils and mo- WARRANTY PER
