Bedienungsanleitung Honeywell Photoelectronic Smoke/Temperature Detector 5808W3

Inhaltszusammenfassung zur Seite Nr. 1

I56-2768-001R
5808W3 Photoelectronic Smoke/Temperature
Detector with Built-in Wireless Transmitter

INSTALLATION AND SETUP GUIDE
Table 1: Detector LED Modes
General Information
Before installing detectors, please thoroughly read these
Green LED Red LED
Piezoelectric
installation instructions and Manual A05-1003-002, Guide for
Horn
Proper Use of System Smoke Detectors, which provides detailed
information on detector spacing, placement, zoning, wiring, and
Power-up Off
Blinks every

Inhaltszusammenfassung zur Seite Nr. 2

Battery Installation and Replacement detector counter-clockwise on the base until it snaps open. Then return to clockwise position until the detector snaps To replace the battery: into place. 1. Remove the detector from its mounting base by twisting the 6. When the serial number is displayed, transmit from the detector counterclockwise. Remove the battery, and dispose detector a second time by activating the tamper switch properly. again as described in Step 5. The current loop numbe

Inhaltszusammenfassung zur Seite Nr. 3

C. Direct Heat Method (Hair dryer of 1000-1500 watts) Dust covers are an effective way to limit the entry of dust into the smoke detector sensing chamber during construction. However, they may not completely prevent airborne dust particles from Direct the heat toward either side thermistor. Be sure to hold the heat source about 12 inches from the detector to avoid damage to entering the detector. Therefore, it is recommended that the the plastic. The detector will reset only after it has

Inhaltszusammenfassung zur Seite Nr. 4

7. Replace the detector cover by placing it over the screen/sensing Maintenance chamber and turning it clockwise until it snaps into place. NOTE: Before performing maintenance on the detector, notify the proper authorities and the central station that maintenance is 8. Reinstall the battery into the battery compartment noting being performed and the system will be temporarily out of service. proper orientation. Disable the zone or system undergoing maintenance to prevent any unwanted al