Bedienungsanleitung Harbor Freight Tools 46407

Inhaltszusammenfassung zur Seite Nr. 1

WOOD LATHE STAND
Model 46407
SET up AND OpErATiNg iNSTrucTiONS
®
Designed for Harbor Freight Tools
Wood Lathe #36066
Diagrams within this manual may not be drawn proportionally.
Due to continuing improvements, actual product may differ slightly from the product described herein.
®
Distributed exclusively by Harbor Freight Tools .
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
read this material before using this product.
Failure to do so can r

Inhaltszusammenfassung zur Seite Nr. 2

Specifications Overall Dimensions 56” L x 18” W x 31-1/8” H Base Mounting Holes 4, .39” holes @ 8-1/2” apart from center Leg Distance 49” x 15” with .31” mounting holes on each leg Weight 21 lb. Save This Manual You will need the manual for the safety warnings and precautions, assembly in- structions, operating and maintenance procedures, parts list and diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front cover. Keep the manual and invoice in a s

Inhaltszusammenfassung zur Seite Nr. 3

plications for which this Lathe Stand was designed. Do not modify this Lathe Stand and do not use this tool for a purpose for which it was not intended. 11. Stay alert. Watch what you are doing, use common sense. Do not use any Lathe Stand when you are tired. 12. check for damaged parts . Before using any tool, any part that appears damaged should be carefully checked to determine that it will operate prop- erly and perform its intended function. Any part that is damaged should be properly

Inhaltszusammenfassung zur Seite Nr. 4

Assembly refer to the Assembly Drawing on page 6. Note: The only tool necessary is an adjustable wrench. It is advised to always tighten hardware by hand until the unit is complete, then tighten with the wrench. 1. Take a Base plate (2) and attach a Leg A (3) to one side of it using four sets of Bolts (7), Spring Washers (9), Flat Washers (8), and Nuts (10). 2. On the opposite side of the Base plate (2), attach a Leg B (4) using a set of Bolts (7), Spring Washers (9), Flat Washers (8), an

Inhaltszusammenfassung zur Seite Nr. 5

Maintenance 1. Clean dirt, grease, or wood chippings off of the stand with a cloth or brush. 2. Periodically tighten all of the hardware. parts List part Description Qty. 1 Adapter Plate 2 2 Base Plate 2 3 Leg A 2 4 Leg B 2 5 Leg Mounting A 2 6 Leg Mounting B 2 7 Bolt 24 8 Flat Washer 32 9 Spring Washer 32 10 Nut 32 pLEASE rEAD THE FOLLOWiNg cArEFuLLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTR

Inhaltszusammenfassung zur Seite Nr. 6

Assembly Drawing SKU 46407 Page 6