Bedienungsanleitung Harbor Freight Tools 02628 CYCLETREE

Inhaltszusammenfassung zur Seite Nr. 1

CYCLETREE
Model 02628
ASSEMBLY and OPERATING INSTRUCTIONS
(Bicycle’s not included)
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
®
Copyright © 2002 by Harbor Freight Tools . All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools .
For technical questions and replacement parts, please call 1-800-444-3353

Inhaltszusammenfassung zur Seite Nr. 2

Specifications Overall Dimensions 30” Square Base-Top of “T” Bar is 66” from the Base Beam Hang Bar Dimensions 36” Height & 17-1/2’ Length per side, 7/8” Diameter Base Post Dimensions 1-3/16” Sq. x 35-1/8” L x 1/16” Thick Center Post Dimensions 1” Sq. x 36” L x 1/16” Thick Casters 7/8” W x 3” Diameter Save This Manual You will need the manual for the safety warnings and precautions, assembly instructions, operating and maintenance procedures, parts list and diagram. Keep your invoice with this

Inhaltszusammenfassung zur Seite Nr. 3

10. Stay alert. Watch what you are doing, use common sense. Do not assemble the Cycle- tree when you are tired. 11. Check for damaged parts. Before using this movable bicycle rack, any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment and binding of moving parts; any broken parts or mounting fixtures; and any other condition that may affect proper operation. Any part that is damaged should be

Inhaltszusammenfassung zur Seite Nr. 4

Assembly Refer to the Assembly Drawing on Page 6. 1. Form a square by facing both of the Base Brackets (#1) toward each other, and inserting both of the Base Channeled Supports (#2) into the Base Brackets (#1), lining up the holes on all four corners. 2. Put each of the Casters (#3) through the holes on the four corners of the base frame you just constructed, from the bottom, so that the square frame sits on them. 3. Place Strut A (#6) on a top of the threaded caster bolt making sure the end

Inhaltszusammenfassung zur Seite Nr. 5

Maintenance 1. Periodically check that the hardware is tight. Tighten if necessary. Parts List Part No. Description Qty. 1 Base Bracket 2 2 Base Channeled Supports 2 3 Castor 3" 4 4 Flat Washer Ø10 4 5 Nut M10 4 6 Strut A 2 7 Base Beam 2 8 Strut B

Inhaltszusammenfassung zur Seite Nr. 6

Assembly Drawing Page 6 REV 12/03; 12/06 SKU 2628