Bedienungsanleitung Fisher-Price BARBIE M5727

Inhaltszusammenfassung zur Seite Nr. 1

M5727
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required.
Tools required for assembly: Phillips Screwdriver,
Hammer and Scrap Block of Wood (not included).
Age: 2-5 years
Weight limit: 55 lbs (25 kg).
www.fi sher-price.com

Inhaltszusammenfassung zur Seite Nr. 2

Consumer Information WARNING CAUTION To avoid serious injury: This product contains small parts • Adult supervision is required. in its unassembled state. Adult assembly is required. • Never use near cars and other motor vehicles, near streets, steps, sloped IMPORTANT! driveways, hills, roadways, alleys, swimming • Please save all packaging material until assembly is pool areas or other bodies of water. complete to ensure that no parts are discarded. • Always wear shoes or sneakers. • Please

Inhaltszusammenfassung zur Seite Nr. 3

Assembly PUSH Straight Axle Assembly Seat Frame 3 Bottom View • Turn the frame upside down. 1 • Insert the straight axle assembly through the holes in the rear of the frame. • Fit the seat onto the frame. • Push firmly near the back end of the seat to "snap" it into place. Bushing Wheel (Grooved Side Down) (Flat Side First) Rear Wheel Straight Axle (Indented Side Down) Bushing Wheel Hub (Smooth Side First) (Flat Side Down) Wheel Hub (Pointed End First) 4 • Turn the assembly upright. • Slide a

Inhaltszusammenfassung zur Seite Nr. 4

Assembly Pedal Axle Tab Pedal Hub Pedal Hub 7 • Fit two pedal hubs onto the pedal axle tabs. Make sure the tabs fit into the slot in each pedal hub. • While holding the pedal hubs on the pedal axle, insert the pedal axle into the hole in the center of the front wheel. • Press the pedal hubs into the center of the front wheel until they are flush with the surface of the front wheel. 5 • Repeat this procedure on the other side with the other two pedal hubs. • Fit the cap nut on the end of the

Inhaltszusammenfassung zur Seite Nr. 5

Assembly Fork Post Handlebar Front Fork Post Handlebar Back ¾" Screw ¾" Screw 2¼" Screw Fork Cover 9 • Insert the fork post up through the hole in the neck of the 10 frame. Make sure the fork is positioned so that the fork covers face the rear wheels. • Fit the handlebar front to the fork post. Hint: The handlebar front is designed to assemble to the fork post one way. • Fit the handlebar back to the fork post and handlebar front. Hold them together firmly. • First, insert the remaining #8 x

Inhaltszusammenfassung zur Seite Nr. 6

™ Label Decoration Consumer Information • Periodically, check the plastic parts and if broken or cracked, dispose of them properly. • Periodically, check all fasteners regularly to be sure they are tight. If the fasteners are not tight, tighten them 4 as necessary. • To clean, use a mild soap and water solution and a clean cloth. Rinse clean with water to remove soap residue. IMPORTANT! It is a good practice to start training children very young regarding the importance of helmet use. Whe