Bedienungsanleitung Butler PIG DESIGN 92647

Inhaltszusammenfassung zur Seite Nr. 1

ROUND PARK BENCH
Pig Design
92647
ASSEMBLY INSTRUCTIONS
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
®
Copyright © 2005 by Harbor Freight Tools . All rights reserved. No portion of this manual
or any artwork contained herein may be reproduced in any shape or form without the
express written consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353
Manual Revised 04/05

Inhaltszusammenfassung zur Seite Nr. 2

SPECIFICATIONS Item Description Construction Cast-Iron Frame w/Black Finish Finished Slats Varnished Wooden Slats Design Lazy Pig Eating Daisies Seat Size 20-1/4"W X 17-1/2"D X 23-1/2"H–16-1/4"H from ground Overall Dimensions 24-1/8"L X 21-3/4"W X 34-5/8"H Weight 60 Lbs. Weight Capacity 330 Lbs. SAVE THIS MANUAL You will need the manual for the safety warnings and precautions, assembly instructions, operating and maintenance procedures, parts list and diagram. Keep your invoice with this manual

Inhaltszusammenfassung zur Seite Nr. 3

12. THIS PRODUCT IS MANUFACTURED OF CAST IRON. Do not force any part of the assembly and do not overtighten the bolts. Serious damage can occur. Do not stand on this Bench. Use only for intended purpose. The Park Bench is made for children. Children need to be supervised. Injury could occur if Park Bench is overloaded. Use caution! 13. STORE IDLE EQUIPMENT. When not in use, products must be stored in a dry location to inhibit damage from moisture and salt air. 14. TIPPING HAZARD. Do not jump

Inhaltszusammenfassung zur Seite Nr. 4

2. Attach the Round Back Assembly (1) to the End Pieces left and right (2). Use Bolts (5) to attach. Hand tighten only. See Figure 2. Round Back Assembly (1) End Piece (2) Bolt (5) Bolt (5) Bolt (8) Bolt (8) Figure 2 3. With the assistance of another person, carefully turn the Bench upside down and attach the Support Bracket (6) with the Self Tap Screws (7) in the two center predrilled holes. Screw into the second wood slat counting from the back of the seat. Use Bolts, Nuts and Washers (5) to s

Inhaltszusammenfassung zur Seite Nr. 5

4. Tighten all hardware at this time (maintain the 90° angle while tightening all hardware). Check periodically to be sure all hardware stays tightened. PARTS LIST PART # DESCRIPTION QTY 1 Round Back Assembly 1 2 2 End Pieces Left & Right 3 5 Seat Slats 4 10 Bolt 6 x 30mm, Nuts 6mm, & Washers 6mm 5 4 Bolt 6 x 20mm, & Washers 6mm 1 6 Support Bracket 7 2 Self Tap Screw 4 x 10mm 8 4 Bolt 8 x 30mm, Nuts 8mm, & Washers 8mm ASSEMBLY ILLUSTR