Inhaltszusammenfassung zur Seite Nr. 1
Operator’s Manual
2-Cycle Garden
Cultivator
SAVE THESE INSTRUCTIONS DO NOT THROW AWAY
P/N 769-02280 (1/06)
Inhaltszusammenfassung zur Seite Nr. 2
INTRODUCTION THANK YOU TABLE OF CONTENTS Thank you for buying this quality product. This modern Service Information . . . . . . . . . . . . . . . . . . . . . . . . .2 outdoor power tool will provide many hours of useful service. You will find it to be a great labor-saving device. Rules for Safe Operation . . . . . . . . . . . . . . . . . . . . .3 This operator’s manual provides you with easy-to- Know Your Unit . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 understand operating instruct
Inhaltszusammenfassung zur Seite Nr. 3
RULES FOR SAFE OPERATION The purpose of safety symbols is to attract your SYMBOL MEANING attention to possible dangers. The safety symbols, and their explanations, deserve your careful attention and understanding. The safety warnings do not by Failure to obey a DANGER: themselves eliminate any danger. The instructions or safety warning will warnings they give are not substitutes for proper result in serious injury to yourself or to accident prevention measures. others. Always follow the safety p
Inhaltszusammenfassung zur Seite Nr. 4
RULES FOR SAFE OPERATION • Always stop the engine and allow it to cool before filling • Do not touch the engine or muffler. These parts get the fuel tank. Never remove the cap of the fuel tank, or extremely hot from operation. They remain hot for a add fuel, when the engine is hot. Never operate the unit short time after you turn off the unit. without the fuel cap securely in place. Loosen the fuel • Do not operate the engine faster than the speed tank cap slowly to relieve any pressure in the t
Inhaltszusammenfassung zur Seite Nr. 5
RULES FOR SAFE OPERATION SAFETY AND INTERNATIONAL SYMBOLS This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's manual for complete safety, assembly, operating and maintenance and repair information. SYMBOL MEANING SYMBOL MEANING • SAFETY ALERT SYMBOL • ON/OFF STOP CONTROL Indicates danger, warning or caution. ON / START / RUN May be used in conjunction with other symbols or pictographs. • WARNING - READ • ON/OFF
Inhaltszusammenfassung zur Seite Nr. 6
RULES FOR SAFE OPERATION KNOW YOUR UNIT STOP/OFF (O) Application • Cultivating sod and light to medium soil • Cultivating in garden areas, around trees, etc. Handgrip Handlebar On/Off Stop Control Throttle Control Handgrip START/ON (I) Handlebar Knob Throttle Fuel Cap Cable and Switch Wires Starter Rope Grip Handlebar Blue Choke Knob Primer Bulb Lever Shaft Tube Grip Tine Guard Air Filter/ Muffler Cover Gearbox Muffler Spark Plug Wheel Bracket Tines Assembly 6
Inhaltszusammenfassung zur Seite Nr. 7
ASSEMBLY INSTRUCTIONS ASSEMBLING THE UNIT INSTALLING THE WHEEL BRACKET ASSEMBLY Before operating, position the unit’s handlebars. If the wheel bracket assembly is not installed, or if you NOTE: You may also need to reposition the wheel height ever need to remove or reinstall it, follow the ensuing before using the cultivator. Refer to the Adjusting instructions. Tine Depth section. Begin by carefully unpacking the contents and making To avoid injury from sure that nothing is damaged. WARNING: th
Inhaltszusammenfassung zur Seite Nr. 8
OIL AND FUEL INFORMATION OIL AND FUEL MIXING INSTRUCTIONS Old and/or improperly mixed fuel are the main reasons for the unit not running properly. Be sure to use fresh, clean unleaded fuel. Follow the instructions carefully for + the proper fuel/oil mixture. Definition of Blended Fuels Today's fuels are often a blend of gasoline and UNLEADED GAS 2 CYCLE OIL oxygenates such as ethanol, methanol, or MTBE (ether). Alcohol-blended fuel absorbs water. As little as 1% 1 GALLON US 3.2 FL. OZ. water in
Inhaltszusammenfassung zur Seite Nr. 9
STARTING/STOPPING INSTRUCTIONS Operate this unit only OFF (O) WARNING: in a well- ventilated outdoor area. Carbon monoxide exhaust fumes can be lethal in a confined area. Avoid accidental WARNING: starting. Make sure you are in the starting position when pulling the starter rope (Fig. 8). To avoid serious injury, Throttle Control ON (I) the operator and unit must be in a stable On/Off Stop Control position while starting. Fig. 6 STARTING INSTRUCTIONS 1. Mix gas with oil. Fill fuel tank with fuel
Inhaltszusammenfassung zur Seite Nr. 10
OPERATING INSTRUCTIONS OPERATING TIPS ADJUSTING TINE DEPTH Tine adjustment will vary depending on the type of soil Dress properly to being cultivated and how it will be used. Generally, WARNING: reduce the risk of adjusting the tines to break the soil 4 to 6 inches is injury when operating this unit. Do not recommended for most gardens. Adjust the tines as wear loose clothing or jewelry. Wear eye follows: and ear/hearing protection. Wear heavy 1. Stop the engine and disconnect the spark plug wi
Inhaltszusammenfassung zur Seite Nr. 11
MAINTENANCE AND REPAIR INSTRUCTIONS MAINTENANCE SCHEDULE NOTE: Maintenance, replacement, or repair of the emission control devices and system may be performed by Perform these required maintenance procedures at the any non-road engine repair establishment, individual frequency stated in the table. These procedures should or authorized service dealer. also be a part of any seasonal tune-up. In order to assure peak performance of your engine, NOTE: Some maintenance procedures may require inspectio
Inhaltszusammenfassung zur Seite Nr. 12
MAINTENANCE AND REPAIR INSTRUCTIONS AIR FILTER MAINTENANCE Removing the Air Filter/Muffler Cover To avoid serious WARNING: personal injury, always turn the unit off and allow it to cool before you clean or service it. 1. Place the blue choke lever in Position 2. Air Filter NOTE: The blue choke lever must be in Position 2 (Fig. 13) to remove the air filter/ muffler cover. Inside Muffler 2. Remove the four (4) screws securing the air Cover filter/muffler cover (Fig. 13). Use a # T20 Torx bit screw
Inhaltszusammenfassung zur Seite Nr. 13
MAINTENANCE AND REPAIR INSTRUCTIONS Adjust Idle Speed Adjuster If the exhaust WARNING: deflector assembly is If after checking the fuel mixture and cleaning the air not tightened securely, it could fall off causing filter the engine still will not idle, adjust the idle speed screw as follows: damage to the unit and possible serious personal injury. 1. Start the engine and let it run for about 2-3 minutes at a high speed (full throttle) to warm up. Refer to the Starting/Stopping Instructions. NOT
Inhaltszusammenfassung zur Seite Nr. 14
MAINTENANCE AND REPAIR INSTRUCTIONS TRANSPORTING • Allow the engine to cool before transporting. 0.020 in. • Secure the unit while transporting. (0.5 mm) • Drain the fuel tank before transporting. • Tighten fuel cap before transporting. Fig. 18 MOVING THE UNIT 4. Install a correctly gapped spark plug in the cylinder 1. Allow the unit to cool before moving. head. Tighten by turning the 5/8 in. socket clockwise 2. Loosen the knobs on the handlebar. until snug. 3. Fold the handlebars down as shown
Inhaltszusammenfassung zur Seite Nr. 15
TROUBLESHOOTING ENGINE WILL NOT START CAUSE ACTION Empty fuel tank Fill fuel tank with properly mixed fuel Primer bulb wasn't pressed enough Press primer bulb fully and slowly 10 times Engine is flooded Squeeze the trigger and pull the starter rope Old or improperly mixed fuel Drain gas tank and add fresh fuel mixture Fouled spark plug Replace or clean the spark plug Plugged spark arrestor Clean or replace spark arrestor ENGINE WILL NOT IDLE CAUSE ACTION Air filter is plugged Replace or clean th
Inhaltszusammenfassung zur Seite Nr. 16
SPECIFICATIONS ENGINE* Engine Type........................................................................................................................................... Air-Cooled, 2-Cycle Displacement .............................................................................................................................................................. 31 cc Idle Speed RPM .................................................................................................................
Inhaltszusammenfassung zur Seite Nr. 17
NOTES 17
Inhaltszusammenfassung zur Seite Nr. 18
NOTES 18
Inhaltszusammenfassung zur Seite Nr. 19
California / EPA Emission Control Warranty Statement Your Warranty Rights and Obligations The California Air Resources Board, the Environmental Protection Agency and MTD LLC (MTD) are pleased to explain the emission control system warranty on your 2005 and later small off-road engine. New small off-road engines must be designed, built and equipped to meet stringent anti-smog standards. MTD must warrant the emission control system on your small off-road engine for the periods of time listed belo
Inhaltszusammenfassung zur Seite Nr. 20
MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by MTD No implied warranty, including any implied warranty of LLC (“MTD”) with respect to new merchandise purchased and merchantability or fitness for a particular purpose, used in the United States, its possessions and territories. applies after the applicable period of express written warranty above as to the parts as identified. No other MTD warrants this product against defects in material and express warrant
