Inhaltszusammenfassung zur Seite Nr. 1
Instruction booklet
WASHER DRYER
Contents
GB
GB
Installation, 2-3
English
Unpacking
Remove the transit fixings
Levelling
Water connections
Drainage and electrical connections
Technical details
Washer dryer description, 4-5
Control panel
LEDs
Starting and programmes, 6-9
Briefly: how to start a programme
Programmes table
Setting the temperature
Setting the spin speeds
A1600WD
Functions
A1400SWD
Drying section
A1400WD
A1200WD
Detergents and laundry, 10
Detergent dispenser
Preparing your laundry
S
Inhaltszusammenfassung zur Seite Nr. 2
Installation ! Keep this instruction manual in a safe place for ! Packaging materials are not childrens toys. GB future reference. Should the appliance be sold, transferred or moved, make sure the instruction manual accompanies the washer dryer to inform the new Levelling owner as to its operation and features. ! Read these instructions carefully: they contain vital 1. Install the machine on a flat sturdy floor, without information on installation, use and safety. resting it up against walls,
Inhaltszusammenfassung zur Seite Nr. 3
Installation Drainage connections The first wash cycle GB A. Connect the drain Once the appliance has been installed and before you B hose, without kinking it, use it for the first time, run a wash cycle without to a draining duct or a detergent and no laundry, setting the 90˚C A wall drain fixed at a programme without a pre-wash cycle. height between 65 and 100cm from the floor. Use the curved bracket, Technical Details if reqired. Models A1600WD, A1400SWD, B. Alternatively, place A1400WD,
Inhaltszusammenfassung zur Seite Nr. 4
Washer Dryer Description Control panel - Models A1600 and A1400 GB FUNCTION ON/OFF Buttons Button PROGRESS INDICATOR ON-OFF/DOOR LOCK LEDs Programme key LED TEMPERATURE PROGRAMME DRYING Knob START/RESET Detergent dispenser Knob Knob Button Control panel - Model A1200 FUNCTION ON/OFF Buttons Button PROGRESS INDICATOR ON-OFF/DOOR LOCK LEDs Programme key LED TEMPERATURE PROGRAMME DRYING Knob START/RESET Detergent dispenser Knob Knob Button TEMPERATURE knob: Detergent dispenser: To set the temperatu
Inhaltszusammenfassung zur Seite Nr. 5
Washer Dryer Description Additional feature - Models A1600WD, A1400SWD LEDs GB and A1400WD only: Your machine has a delay timer function and there are PROGRESS INDICATOR LEDs: additional markings alongside the LEDs. These light up to indicate the DELAY TIMER set: progress of the selected programme. If the Delay Timer function When the programme is started has been enabled (see the light corresponding to the Starting and first cycle is lit and as the Programmes), once you programme progresses,
Inhaltszusammenfassung zur Seite Nr. 6
Starting and Programmes Briefly: starting a programme 5. Set the spin speed (see Personalisation). GB 6. Add the detergent and any fabric softener (see 1. Switch the machine on by pressing the ON/OFF Detergents and Laundry). button , for at least 2 seconds. All the LEDs will 7. Start the programme by pressing the light up for a few seconds and the ON-OFF / DOOR START/RESET button for at least 2 seconds. LOCK LED will begin to flash. 8. When the programme is finished, the 2. Load
Inhaltszusammenfassung zur Seite Nr. 7
Personalisation Setting the temperature Functions GB To enable a function: Turn the TEMPERATURE knob to set the wash 1. press the button corresponding to the desired temperature (see Programme table). function, according to the table below. The temperature can be lowered, or even set to cold 2. the function is enabled when the corresponding wash . LED is illuminated. The rapid flashing of the button indicates that the Setting the spin speed corresponding function cannot be selected for
Inhaltszusammenfassung zur Seite Nr. 8
Drying Section Drying programmes ! If your machine is not permanently plumbed in, turn GB on the cold water supply and hook the drain hose Independent drying programme: over the sink to enable the condensing action to work. 1. Remove the wet laundry and in drum dosing ball (if ! The dryer is intended for use only where water is used) until the correct ‘Drying Weight Load’ (see used for the cleaning process. table below) is left in the drum. Close the door until it clicks shut. ! Be careful not
Inhaltszusammenfassung zur Seite Nr. 9
Drying Section A typical wash and dry programme: 7. Select either the ‘Timed’ or ‘Sensor’ dry option you GB require (Sensor dry is only available on Models 1. Sort your laundry into groups with the same wash A1600 and A1400). and dry care labels. 8. Press the START/RESET button to begin the 2. Load the machine, making sure that items are not programme. trapped in the door. Close the door by pushing it - During the programme status lights will illuminate until it clicks. to indicate
Inhaltszusammenfassung zur Seite Nr. 10
Detergents and Laundry How much does your laundry weigh? Detergent dispenser GB 1 sheet 400-500g ! Do not put any items into the drawer, other than 1 pillow case 150-200g detergents designed to be released from the drawer, 1 tablecloth 400-500g as they may cause damage or blockage. 1 bathrobe 900-1200g 1 towel 150-250g 1. Pre-wash detergent compartment. Maximum 200ml powder Special items or 100ml liquid 1 2 Curtains: fold curtains and place them in a pillow 2. Main wash detergent case or mesh ba
Inhaltszusammenfassung zur Seite Nr. 11
Precautions and advice Saving on detergent, water, energy and time ! The machine was designed and built in compliance GB with the applicable international safety regulations. To avoid wasting resources, the machine should The following information is provided for your safety be used with a full load. A full load instead of two and should consequently be read carefully. half loads allows you to save up to 50% on energy. The pre-wash cycle is only necessary on extremely soiled garments. Avo
Inhaltszusammenfassung zur Seite Nr. 12
Care and maintenance Switching off the electricity Caring for your appliance door and GB drum Turn off the water tap after every wash. This will limit the wear of your appliances water system Always leave the appliance door ajar to prevent and also prevent leaks. unpleasant odours from forming. Unplug your appliance when cleaning it and during all maintenance operations. Checking the water inlet hose Cleaning Check the water inlet hose at least once a year. If you see any cracks, replac
Inhaltszusammenfassung zur Seite Nr. 13
Troubleshooting One day your machine seems not to be working. Before you call your Service Centre (see Service), go through the GB following troubleshooting suggestions: Problem: Possible causes / Solution: The machine won’t start? The appliance is not fully plugged into the socket. There has been a power failure. The wash cycle won’t The appliance door is not shut properly. start? The ON/OFF button has not been pressed, for at least 2 seconds. The START/RESET button has not be
Inhaltszusammenfassung zur Seite Nr. 14
Troubleshooting Problem: Possible causes / Solution: GB The washer dryer vibrates The transit fixings were not removed correctly (see Installation). too much during the spin The washer dryer is not level (see Installation). cycle? The washer dryer is closed in, between furniture cabinets and the wall (see Installation). The washer dryer leaks? The water inlet hose is not connected correctly (see Installation). The detergent dispenser is obstructed, clean it (see Care and Maintenance
Inhaltszusammenfassung zur Seite Nr. 15
Service Before calling the Service Centre: Spare Parts GB Use the troubleshooting guide to see if you can This appliance is a complex machine. Repairing it solve the problem yourself (see Troubleshooting). yourself or having a non-authorised person try to repair If not, turn off the appliance and call the Service it could cause harm to one or more persons, could Centre closest to you. damage the machine and could invalidate the spare parts warranty. Call an authorised technician if you expe
Inhaltszusammenfassung zur Seite Nr. 16
195050451.01 06/2005 - SIMLEX . Four Ashes, Wolverhampton
