Inhaltszusammenfassung zur Seite Nr. 1
Inhaltszusammenfassung zur Seite Nr. 2
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS…………………………………………………1 PREPARING YOUR ICE MAKER FOR USE IMPORTANT SAFETY TIPS.……………………………………………………………….2 GETTING TO KNOW YOUR UNIT… …… …… …… …… …… …… …… …… …… …… …… …… …… …… …… …… …… …… …… …… …....3 3 OPERATING PROCEDURES & MAINTENANCE UNPACKING YOUR ICE MAKER ..………….…………………………………………...4 CONNECTING YOUR ICE MAKER……………….……….……………………………..4 CLEANING AND MAINTAINING YOUR ICE MAKER….……………………………….4 USING YOUR ICE MAKER……………….……..………………………………………
Inhaltszusammenfassung zur Seite Nr. 3
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTI and INTROO DNS UCTION Your safety and the safety of others is very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol: ! All safety messages will follow the safety alert symbol and the word “DANGER” or “WARNING”. DANGER ! WARNING ! These words mean: You can be k
Inhaltszusammenfassung zur Seite Nr. 4
PREPARING YOUR ICE MAKER FOR USE IMPORTANT SAFETY TIPS When using electrical appliances, basic safety precautions should be followed to reduce the risk of fire, electric shock, and/or injury to persons or property. Read all instructions before using any appliance. Do not operate this or any other appliance with a damaged cord. Connect to properly polarized outlets only. No other appliance should be plugged into the same outlet. Be sure that the plug is fully inserted into the receptacl
Inhaltszusammenfassung zur Seite Nr. 5
GETTING TO KNOW YOUR UNIT 3
Inhaltszusammenfassung zur Seite Nr. 6
OPERATING PROCEDURES & MAINTENANCE UNPACKING YOUR ICE MAKER 1. Remove the exterior and interior packaging. Check that ice basket and ice scoop are included. If any parts are missing, please contact the vendor. 2. Clean the interior with lukewarm water and a soft cloth. Take out the ice basket and clean it. 3. Find a location for your ice maker that is protected from direct sunlight and other sources of heat (i.e., stove, furnace, radiator). Place the ice maker on a level surface. Make
Inhaltszusammenfassung zur Seite Nr. 7
USING YOUR ICE MAKER 1. Select the size of the ice cube by pressing the “Size” button. If the room temperature is lower than 60°F, it is best to select the small or medium ice size, otherwise the ice cubes might stick together. 2. Open the cover, remove the ice basket and pour water into tank. Keep water level below the “Fill Line”. 3. Press “On” on the control panel to begin the ice making cycle. 4. The ice making cycle lasts 7 to 15 minutes, depending on the size of the ice cubes sel
Inhaltszusammenfassung zur Seite Nr. 8
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Stop the ice maker, fill it with water, Low water level. and then restart it. Open the drain cap on the back of the unit and drain out a small There is some air in the amount of water. Replace the drain The “Add Water” lines. cap and attempt to use the unit indicator is on. again. The unit is filled with Add a little bit of salt to the water or distilled water- or some use water from a different source other type of water w
Inhaltszusammenfassung zur Seite Nr. 9
TECHNICAL SPECIFICATIONS & CIRCUIT DIAGRAM TECHNICAL SPECIFICATIONS Model IP300P Model IP300P Climate Type N Climate Type N Protection Class I Protection Class I Power 110V~120V/60Hz Power 110V~120V/60Hz Rated Current 3.5 A Rated Current 3.5 A Power Input 150W Power Input 150W Refrigerant R134a/3oz Refrigerant R134a/3oz Size (HXWXD) 12InX15InX15In Size (HXWXD) 12InX15InX15In CIRCUIT DIAGRA
Inhaltszusammenfassung zur Seite Nr. 10
For information on EdgeStar and to view our full line of products, please visit our website: http://www.edgestar.com EdgeStar Products Box 81336 Austin, Texas 78708-1336 Toll Free: 1-866-319-5473
