Bedienungsanleitung Henny Penny 691

Inhaltszusammenfassung zur Seite Nr. 1

Model 691
SECTION 4. TROUBLESHOOTING
4-1. TROUBLESHOOTING GUIDE
Problem Cause Correction
• Plug fryer in
Power switch ON but fryer • Open circuit
• Check breaker or fuse at wall
completely inoperative
• Turn OFF and allow fryer to cool to
Pressure not exhausting at • Solenoid or exhaust line clogged
release the pressure in frypot; have
end of cook cycle
all lines, solenoid, and exhaust tank
cleaned
• Turn OFF and allow fryer to cool to
Operating pressure too high • Deadweight assembly

Inhaltszusammenfassung zur Seite Nr. 2

Model 691 4-2. ERROR CODES In the event of a control system failure, the digital display will show an error message which are coded: “E-4”, “E-5”, “E-6”, “E-10”, “E-15”, “E-20A-D”, “E-41”, “E-46”, “E-47”, “E-48”, “E-70B”, and “E-92”. A constant tone is heard when an error code is displayed; and to silence this tone, press any of the product buttons. DISPLAY CAUSE PANEL BOARD CORRECTION “E-4” Control board Turn switch to OFF position, then turn switch back to ON; overheating if display

Inhaltszusammenfassung zur Seite Nr. 3

Model 691 4-2. ERROR CODES (Continued) DISPLAY CAUSE PANEL BOARD CORRECTION “E-41” Programming Turn switch to OFF position, then back to ON; if display failure shows “E-41”, the control should be re-initialized (see Pro- gramming section); if the error code persists, replace the control panel “E-46” Eeprom memory Turn switch to OFF position, then back to ON; if display write error shows “E-46”, the control should be re-initialized (see Pro gramming section); if the error code persists, r

Inhaltszusammenfassung zur Seite Nr. 4

Model 691 THIS PAGE INTENTIONALLY LEFT BLANK. 4-4 803