Bedienungsanleitung Henny Penny 561

Inhaltszusammenfassung zur Seite Nr. 1

Model 500/561/600
SECTION 4. TROUBLESHOOTING
4-1. TROUBLESHOOTING GUIDE
Problem Cause Correction
• Fryer plugged in
Power switch ON but fryer • Open Circuit
• Check breaker or fuse at wall
completely inoperative
• Turn OFF and allow fryer to cool to
Pressure not exhausting at • Solenoid or Exhaust line clogged
release the pressure in frypot; have
end of cook cycle
all lines, solenoid, and exhaust tank
cleaned
• Turn OFF and allow fryer to cool to
Operating pressure too high • Deadweigh

Inhaltszusammenfassung zur Seite Nr. 2

Model 500/561/600 4-2. ERROR CODES In the event of a control system failure, the digital display will show an “Error Message.” These messages are coded: “E4”, “E5”, “E6”, “E10”, “E15”, “E20”, “E31”, “E41”, “E46”, “E54”, and E-70-A & B. A constant tone is heard when an error code is displayed, and to silence this tone, press any button. DISPLAY CAUSE PANEL BOARD CORRECTION “E-4” Control board Turn switch to OFF position, then turn switch back to overheating ON; if display shows

Inhaltszusammenfassung zur Seite Nr. 3

Model 500/561/600 4-2. ERROR CODES (Continued) DISPLAY CAUSE PANEL BOARD CORRECTION “E-41”, Programming Turn switch to OFF, then back to ON; if display shows any “E-46” failure of the error codes, try to reinitialize the control (Special Program Section) if error code persists, replace the control board; refer to Technical Manual “E-20 C” Ignition modules Press the timer button to try the ignition process again; if not responding “E-20 C” persists, check the ignition module,