Inhaltszusammenfassung zur Seite Nr. 1
YFPRE1817E
Installation & Operation Manual
YFPRE1817E
Frymaster, a member of the Commercial Food Equipment Service Association, recommends
using CFESA Certified Technicians.
24-Hour Service Hotline 1-800-551-8633
JULY 09
*8196383*
www.frymaster.com E-mail: service@frymaster.com
Inhaltszusammenfassung zur Seite Nr. 2
NOTICE IF, DURING THE WARRANTY PERIOD, THE CUSTOMER USES A PART FOR THIS ENODIS EQUIPMENT OTHER THAN AN UNMODIFIED NEW OR RECYCLED PART PURCHASED DIRECTLY FROM FRYMASTER DEAN, OR ANY OF ITS AUTHORIZED SERVICE CENTERS, AND/OR THE PART BEING USED IS MODIFIED FROM ITS ORIGINAL CONFIGURATION, THIS WARRANTY WILL BE VOID. FURTHER, FRYMASTER DEAN AND ITS AFFILIATES WILL NOT BE LIABLE FOR ANY CLAIMS, DAMAGES OR EXPENSES INCURRED BY THE CUSTOMER WHICH ARISE DIRECTLY OR INDIRECTLY, IN WHOLE OR IN
Inhaltszusammenfassung zur Seite Nr. 3
DANGER The front ledge of this appliance is not a step! Do not stand on the appliance. Serious injury can result from slips or contact with the hot cooking oil/shortening. DANGER Do not store or use gasoline or other flammable liquids or vapors in the vicinity of this or any other appliance. DANGER The crumb tray in fryers equipped with a filter system must be emptied into a fireproof container at the end of frying operations each day. Some food particles can spontaneously comb
Inhaltszusammenfassung zur Seite Nr. 4
YFPRE18E Electric Fryer Installation and Operation Manual TABLE OF CONTENTS CHAPTER 1: Introduction 1.1 General Information.......................................................................................................... 1-1 1.2 Safety Information............................................................................................................. 1-1 1.3 Computer Information........................................................................................
Inhaltszusammenfassung zur Seite Nr. 5
YFPRE18E ELECTRIC FRYERS CHAPTER 1: INTRODUCTION 1.1 General Read the instructions in this manual thoroughly before attempting to operate this equipment. This manual covers current configurations of YFPRE18E. 1.2 Safety Information Before attempting to operate your unit, read the instructions in this manual thoroughly. Throughout this manual, you will find notations enclosed in double-bordered boxes similar to the one below. DANGER Hot cooking oil causes severe
Inhaltszusammenfassung zur Seite Nr. 6
the equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their own expense. The user is cautioned that any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. If necessary, the user should consult the dealer or an experienced radio and television technician for additional suggestions. The user may find
Inhaltszusammenfassung zur Seite Nr. 7
1.6 Shipping Damage Claim Procedure What to do if your equipment arrives damaged: Please note that this equipment was carefully inspected and packed by skilled personnel before leaving the factory. Frymaster does not assume responsibility for damage or loss incurred in transit. The freight company assumes full responsibility for safe delivery upon acceptance of the equipment. 1. File Claim for Damages Immediately—Regardless of extent of damage. 2. Visible Loss or Damage—Be sure
Inhaltszusammenfassung zur Seite Nr. 8
YFPRE18E ELECTRIC FRYER CHAPTER 2: INSTALLATION INSTRUCTIONS 2.1 General Proper installation is essential for the safe, efficient, trouble-free operation of this appliance. Qualified, licensed, and/or authorized installation or service personnel, as defined in Section 1.6 of this manual, should perform all installation and service on Frymaster equipment. Failure to use qualified, licensed, and/or authorized installation or service personnel (as defined in Section 1.6 of this
Inhaltszusammenfassung zur Seite Nr. 9
DANGER This appliance must be connected to a power supply having the same voltage and phase as specified on the rating plate located on the inside of the appliance door. DANGER All wiring connections for this appliance must be made in accordance with the wiring diagram(s) furnished with the appliance. Refer to the wiring diagram(s) affixed to the inside of the appliance door when installing or servicing this equipment. DANGER Frymaster appliances equipped with legs are for stat
Inhaltszusammenfassung zur Seite Nr. 10
2.2 Power Requirements Three (3) Phase Requirements MINIMUM WIRE WIRE AMPS MODEL VOLTAGE SIZE SERVICE (per leg) AWG (mm) YFPRE1817E 208 3 6 (4.11) 48 240 3 6 (4.11) 41 480 3 6 (4.11) 21 220/380 4 6 (4.11) 26 240/415 4 6 (4.11) 24 230/400 4 6 (4.11) 25 2.3 After Fryers Are Positioned At the Frying Station DANGER No structural material on the fryer should be altered or removed to accommodate placement of the fryer under a hood. Questions? Call the Frymas
Inhaltszusammenfassung zur Seite Nr. 11
DANGER Hot oil can cause severe burns. Avoid contact. Under all circumstances, oil must be removed from the fryer before attempting to move it to avoid oil spills, falls and severe burns. This fryer may tip and cause personal injury if not secured in a stationary position. 2. Close fryer drain-valve(s) and fill frypot with water to the bottom oil level line. 4. Clean, and fill frypot(s) with cooking oil. (See Equipment Setup and Shutdown Procedures in Chapter 3.) 2-4
Inhaltszusammenfassung zur Seite Nr. 12
YFPRE18E ELECTRIC FRYER CHAPTER 3: OPERATING INSTRUCTIONS FINDING YOUR WAY AROUND THE YFPRE18E ELECTRIC FRYER Basket Hanger Lift Rod Tilt Housing Top Cap Bezel Control Panel YUM Wingstreet controller Fuse shown. Power Switch Drain Drain and Filter Handles Filter Pan Built-in Filtration Unit TYPICAL CONFIGURATION (YFPRE1817E SHOWN) NOTE: The appearance of your fryer may differ slightly from that shown depending upon the configuration and date of manuf
Inhaltszusammenfassung zur Seite Nr. 13
3.1 Equipment Setup and Shutdown Procedures Setup DANGER Never operate the appliance with an empty frypot. The frypot must be filled to the fill line with water, oil or shortening before energizing the elements. Failure to do so will result in irreparable damage to the elements and may cause a fire. DANGER Remove all drops of water from the frypot before filling with oil. Failure to do so will cause spattering of hot liquid when the oil is heated to cooking temperature.
Inhaltszusammenfassung zur Seite Nr. 14
3.2 Controllers This fryer will be equipped the following YUM Wingstreet controller: CAUTION If this is the first time the fryer is being used after installation, refer to the frypot Boil-Out Procedure on Page 5-2. Refer to the separate Frymaster Wingstreet Controller User’s Manual furnished with your fryer for the specific controller operating instructions. An overview for the controller is provided below. 3–3
Inhaltszusammenfassung zur Seite Nr. 15
3–4
Inhaltszusammenfassung zur Seite Nr. 16
YFPRE18E ELECTRIC FRYER CHAPTER 4: BUILT-IN FILTRATION WARNING Drawings and photos used in this manual are intended to illustrate operational, cleaning and technical procedures and may not conform to on-site management operational procedures. WARNING The on-site supervisor is responsible for ensuring that operators are made aware of the inherent hazards of operating a hot oil filtration system, particularly the aspects of oil filtration, draining and cleaning procedures.
Inhaltszusammenfassung zur Seite Nr. 17
YFPRE18E ELECTRIC FRYER CHAPTER 4: BUILT-IN FILTRATION 4. 1 General Frymaster YFPRE18E fryers come equipped with a built-in filtration system. Photos used in the procedure illustrations may differ slightly from the filter unit that came with the frying system. The following procedures apply to all YFPRE18E fryers equipped with built-in filter systems. 4.2 Filtration Preparation On initial installation and before each use, remove all loose parts from the filter, wash the
Inhaltszusammenfassung zur Seite Nr. 18
YFPRE18E ELECTRIC FRYER CHAPTER 4: BUILT-IN FILTRATION 4.2.1 Assembling the Filter (cont.) Assemble the filter as follows: 1. Place the support grid in the bottom of filter pan. 2. Place the filter pad on top of the grid, encircling the pick-up tube with the notch in the filter pad. 3. Position the hold-down ring on top of the filter pad. The notch goes around the pick-up tube. 4. Place the crumb screen in the filter pan. Allow Support grid properly placed in filter
Inhaltszusammenfassung zur Seite Nr. 19
YFPRE18E ELECTRIC FRYER CHAPTER 4: BUILT-IN FILTRATION 4.2.2 Installing the Filter Slide the filter inside the fryer cabinet. Ensure the male-female slip-fitting coupling is fully engaged. The filter pan is shown partially inserted under the fryer. 4.3 Daily Filtration Operation DANGER Use caution and wear proper protective clothing. The oil to be filtered is at or near 350°F (177°C). Ensure all hoses are connected properly and drain handles are in
Inhaltszusammenfassung zur Seite Nr. 20
YFPRE18E ELECTRIC FRYER CHAPTER 4: BUILT-IN FILTRATION 4.3.2 Filtering Tools Assemble tools to be used for filtering. These are supplied with the filter starter kit included with the fryer/filter system: • Frypot/Filter Brush - used to clean frypot and filter pan sides and bottom and to dislodge sediment during filtration or shortening/oil change. • Clean-Out Rod (design may vary) - used to dislodge heavy debris in the drain tube (when needed). • Filter Pad – Frymaster pa
