Inhaltszusammenfassung zur Seite Nr. 1
LEGEND
Legend 3-Wheel Scooter
Legend 4-Wheel Scooter
Inhaltszusammenfassung zur Seite Nr. 2
SAFETY GUIDELINES WARNING! An authorized Pride Provider or qualified technician must perform the initial setup of this scooter and must perform all of the procedures in this manual. The symbols below are used throughout this owner's manual and on the scooter to identify warnings and important information. It is very important for you to read them and understand them completely. WARNING! Indicates a potentially hazardous condition/situation. Failure to follow designated procedures can cause eithe
Inhaltszusammenfassung zur Seite Nr. 3
CONTENTS I. INTRODUCTION......................................................................................................................... 4 II. SAFETY ......................................................................................................................................... 6 III. EMI/RFI ........................................................................................................................................ 18 IV. SPECIFICATIONS ............................
Inhaltszusammenfassung zur Seite Nr. 4
I. INTRODUCTION I. INTRODUCTION SAFETY PRIDE OWNERS CLUB WELCOME to Pride Mobility Products Corporation (Pride). The product you have purchased combines state-of the-art components with safety, comfort, and styling in mind. We are confident that these design features will As an owner of a Pride product, you are encouraged to enroll in the Pride Owners Club. Complete and return your enclosed product registration card or visit Pride's web site at www.pridemobility.com. provide you with the conveni
Inhaltszusammenfassung zur Seite Nr. 5
II. SAFETY II. SAFETY PRODUCT SAFETY SYMBOLS The symbols below are used on the scooter to identify warnings, mandatory actions, and prohibited actions. It is Use only AGM or Gel-Cell batteries. very important for you to read and understand them completely. Read and follow the information in the owner’s manual. Front-to-rear plug orientation. Do not allow unsupervised children to play near the scooter while the batteries are charging. Do not raise or lower the power seat while the scooter is in m
Inhaltszusammenfassung zur Seite Nr. 6
II. SAFETY II. SAFETY GENERAL Do not use batteries with different amp-hour (Ah) capacities. Do not mix old and new batteries. Always replace both batteries at the same time. MANDATORY! Do not operate your new scooter for the first time without completely reading and understanding this owner’s manual. Do not lift the mobility product while seated in it. Your scooter is a state-of-the-art life-enhancement device designed to increase mobility. Pride provides an exten- sive variety of products to be
Inhaltszusammenfassung zur Seite Nr. 7
II. SAFETY II. SAFETY When climbing an incline, try to keep your scooter moving. If you must stop, start up again slowly, and then Perform the following inspections prior to using your scooter: accelerate cautiously. When driving down an incline, do so by setting the speed adjustment dial to the slowest ! Check for proper tire inflation (if equipped with pneumatic tires). setting and driving in the forward direction only. If your scooter starts to move down the incline faster than you ! Check al
Inhaltszusammenfassung zur Seite Nr. 8
II. SAFETY II. SAFETY OUTDOOR DRIVING SURFACES When you approach an incline, it is best to lean forward. See figures 2 and 2A. This shifts the center of gravity of you and your scooter toward the front of the scooter for improved stability. Your scooter is designed to provide optimum stability under normal driving conditions—dry, level surfaces com- posed of concrete, blacktop, or asphalt. However, Pride recognizes that there will be times when you will encoun- ter other surface types. For this
Inhaltszusammenfassung zur Seite Nr. 9
II. SAFETY II. SAFETY INCLEMENT WEATHER PRECAUTIONS ELEVATORS Exposure of your scooter to inclement weather conditions should be avoided whenever possible. If suddenly Modern elevators have a door edge safety mechanism that, when pushed, reopens the door(s). caught up in rain, snow, severe cold or heat while operating your scooter, proceed to shelter at the earliest ! If you are in the doorway of an elevator when the door(s) begin to close, push on the rubber door edge or opportunity. Thoroughly
Inhaltszusammenfassung zur Seite Nr. 10
II. SAFETY II. SAFETY REACHING AND BENDING MOTOR VEHICLE TRANSPORT Avoid reaching or bending while driving your scooter. Bending forward creates the risk of accidental throttle Pride recommends that you do not remain seated in your scooter while traveling in a motor vehicle. The control lever contact. Bending to the side while seated creates the risk of tipping. It is important to maintain a stable scooter should be stowed in the trunk of a car or in the back of a truck or van with the batterie
Inhaltszusammenfassung zur Seite Nr. 11
Length III. EMI/RFI IV. SPECIFICATIONS ELECTROMAGNETIC AND RADIO FREQUENCY INTERFERENCE (EMI/RFI) WARNING! Laboratory tests have shown that electromagnetic and radio frequency waves 20" can have an adverse affect on the performance of electrically-powered mobility vehicles. Electromagnetic and Radio Frequency Interference can come from sources such as cellular phones, mobile two- way radios (such as walkie-talkies), radio stations, TV stations, amateur radio (HAM) transmitters, wireless compute
Inhaltszusammenfassung zur Seite Nr. 12
IV. SPECIFICATIONS V. YOUR SCOOTER TILLER CONSOLE Model Numbers 3-wheel:SC3000, 4-wheel:SC3400 The tiller console houses all of the controls needed to drive your scooter. See figure 5. 4 Available Colors Painted: Champagne (Standard) 2 Overall Length 3-wheel: 45.5 in., 4-wheel: 47 in. WARNING! Do not expose the tiller console to moisture. In the event that the tiller console 2 Overall Width 24 in. does become exposed to moisture, do not attempt to operate your scooter until the tiller console h
Inhaltszusammenfassung zur Seite Nr. 13
V. YOUR SCOOTER V. YOUR SCOOTER REAR SECTION Running Lights Switch The onboard battery charger (not shown), the charger power cord receptacle, the batteries (not shown), the main This switch controls your scooter’s front (upper) and rear running lights. circuit breaker reset button, the ammeter, the manual freewheel lever, the anti-tip wheels, and the motor/transaxle ! Toggle the switch forward to turn on your scooter’s running lights. assembly are located on the rear section of your scooter. Se
Inhaltszusammenfassung zur Seite Nr. 14
VI. BATTERIES AND CHARGING V. YOUR SCOOTER Manual Freewheel Lever Your scooter requires two long-lasting, 12-volt, deep-cycle batteries that are sealed and maintenance free. They Whenever you need or want to push your scooter for short distances, you can put it in freewheel mode. are recharged by an on-board charging system. ! Charge your scooter’s batteries prior to using it for the first time. 1. Remove the key from the key switch. 2. Pull up on the manual freewheel lever to disable the drive
Inhaltszusammenfassung zur Seite Nr. 15
VI. BATTERIES AND CHARGING VI. BATTERIES AND CHARGING How often must I charge the batteries? PROHIBITED! Do not allow unsupervised children to play near the scooter while the batteries Two major factors must be considered when deciding how often to charge your scooter’s batteries: are charging. Pride recommends that you do not charge the batteries while the scooter is occupied. ! All day scooter use on a daily basis. ! Infrequent or sporadic scooter use. WARNING! If your battery charger has not
Inhaltszusammenfassung zur Seite Nr. 16
VI. BATTERIES AND CHARGING VI. BATTERIES AND CHARGING How do I change a battery? It may take a few days for the temperature of your scooter’s batteries to stabilize and adjust to their new room or ambient temperature. WARNING! Contact your authourized Pride Provider if you have any questions regarding the batteries in your scooter. More importantly, it takes a few charging cycles (partial draining followed by full recharging) to establish the critical WARNING! Do not replace the batteries while
Inhaltszusammenfassung zur Seite Nr. 17
VII. OPERATION VII. OPERATION BEFORE GETTING ONTO YOUR SCOOTER ! Pull on the right handgrip to steer your scooter to the right. ! Have you fully charged the batteries? See VI. “Batteries and Charging.” ! Move the tiller to the center position to drive straight ahead. ! Is the manual freewheel lever in the drive (down) position? Never leave the manual freewheel lever pulled up ! To stop, slowly release the throttle control lever. The electronic brakes will automatically engage when your unless y
Inhaltszusammenfassung zur Seite Nr. 18
VIII. COMFORT ADJUSTMENTS VIII. COMFORT ADJUSTMENTS SEATBACK ADJUSTMENT WARNING! Remove the key from the key switch before adjusting the tiller or the seat. WARNING! Do not operate your scooter with the seatback in a reclined position. Never attempt to adjust the tiller or the seat while the scooter is in motion. WARNING! Always keep your back pressed firmly against the seat back while adjusting it. To adjust your scooter's reclining seat, perform these steps. See figure 10A. TILLER ANGLE AD
Inhaltszusammenfassung zur Seite Nr. 19
VIII. COMFORT ADJUSTMENTS I X . DISASSEMBLY AND ASSEMBLY POWER SEAT (OPTIONAL) DISASSEMBLY Your scooter may be equipped with a power seat option, a power seat switch will be located on the tiller console. You can disassemble the scooter into seven pieces: the seat, the front section, the rear section, the rear shroud, the See figure 5. The power seat will be equipped with one of two operating systems. Refer to figures 12 and 13 to basket, and the batteries. See figure 14. No tools are required
Inhaltszusammenfassung zur Seite Nr. 20
I X . DISASSEMBLY AND ASSEMBLY I X . DISASSEMBLY AND ASSEMBLY ASSEMBLY 6. Unplug both black and white 2-pin battery harnesses. See figure 17. 7. Unplug the front-to-rear harness. See figure 18. 1. Position the front and rear sections of your scooter as shown in figure 23. WARNING! Failure to unplug both battery harnesses and the front-to-rear harness prior to 2. Align the lower slots of the front section with the cor- separating the front and rear sections could result in permanent damage to
