Bedienungsanleitung Kenmore 131801800

Inhaltszusammenfassung zur Seite Nr. 1

Pre-lnstallation Requirements .......................... 2
Kenmore
Electrical Requirements ..................................... 2
Grounding Requirements ................................. 2
Water Supply Requirements .............................. 2
Drain Requirements .......................................... 2
Rough-In Dimensions .......................................... 3
Location Of Your Washer .................................. 4
Unpacking ...................................................

Inhaltszusammenfassung zur Seite Nr. 2

. _For your safety the information in Since your washer is equipped with a power supply this manual must be followed to minimize the risk of cord having an equipment-grounding conductor and a grounding plug, the plug MUST be plugged into fire or explosion orto prevent property damage, an appropriate, copper wired receptacle that is personal injury or loss of life. properly installed and grounded in accordance with - Do not store or use gasoline or other flammable all local codes and ordinances o

Inhaltszusammenfassung zur Seite Nr. 3

ROUGH-IN DIMENSIONS 26_ (67.9) <_60 __. <___ 17_ (152.4) (43.2) 24 ¾ 1 (7.3) 2 _. r (62.9) -(2.54) (5.1) [_ o )- 36 (91.5) Water l'Li Inlets Under 31% Poj;r Counter (80.3) 34% (87.9) BACK SIDE i K Roller Wheels inch (cm) Adjustable Legs UNDER COUNTER INSTALLATION If an under counter* installation is desired, the washer MUST have a top sheet kit installed, P/N 131445600. Kit is available from Sears Parts Department. *Custom sized countertop is required. +_ 60 ___ 17 26¾ (43.2)-_ (152.4) <-- (67.

Inhaltszusammenfassung zur Seite Nr. 4

LOCATION OF YOUR WASHER DO NOT INSTALL YOUR WASHER: 3. Remove the styrofoam base. 1. In an area exposed to drippingwater or outside 4. Carefully return the washer to an upright position weather conditions.The ambient temperature and remove the carton. should never be below 60 degrees F (15.6 degrees 5. Carefully move the washer to within 4 feet (122cm) C) for proper washer operation. of the final loCation. 2. In an area where it will come in contact with 6. Remove the following from the back sid

Inhaltszusammenfassung zur Seite Nr. 5

INSTALLATION 1. Run some water from the hot and cold faucets to flush the water lines and remove particles that might clog up Cable the water valve screens. Tie . Connect the inlet hose ends to the HOT and COLD water faucets tightly by hand, then tighten another 2/3 turn with pliers. Turn the water on and check for leaks. 6. Plug the power cord into a grounded outlet. NOTE: Check to ensure the power is off at a NOTE: Use only new hoses provided with this unit. , circuit breaker/fuse box before p