Inhaltszusammenfassung zur Seite Nr. 1
www.nordictrack.com
Model No. NTL99011.2
Serial No. USER’S MANUAL
Write the serial number in the space
above for reference.
Serial Number
Decal
QUESTIONS?
If you have questions, or if parts
are damaged or missing, DO NOT
CONTACT THE STORE; please
contact Customer Care.
IMPORTANT: Please register this
product (see the limited warranty
on the back cover of this manual)
before contacting Customer Care.
CALL TOLL-FREE:
1-800-TO-BE-FIT
(1-800-862-3348
Inhaltszusammenfassung zur Seite Nr. 2
TABLE OF CONTENTS WARNING DECAL PLACEMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 IMPORTANT PRECAUTIONS ................................................................. 3 BEFORE YOU BEGIN. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 PART IDENTIFICATION CHART. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 3
IMPORTANT PRECAUTIONS WARNING: To reduce the risk of serious injury, read all important precautions and instructions in this manual and all warnings on your treadmill before using your treadmill. ICON as- sumes no responsibility for personal injury or property damage sustained by or through the use of this product. 1. Before beginning any exercise program, con- other electrical devices, except for low-power sult your physician. This is especially impor- devices such as cell phone char
Inhaltszusammenfassung zur Seite Nr. 4
20. Never leave the treadmill unattended while 25. DANGER: Always unplug the power it is running. Always remove the key, unplug cord immediately after use, before clean- the power cord, and press the power switch ing the treadmill, and before performing the into the off position when the treadmill is not maintenance and adjustment procedures in use. (See the drawing on page 5 for the described in this manual. Never remove the location of the power switch.) motor hood unless instruct
Inhaltszusammenfassung zur Seite Nr. 5
BEFORE YOU BEGIN Thank you for selecting the revolutionary reading this manual, please see the front cover of this ® NORDICTRACK C 900 PRO treadmill. The C 900 manual. To help us assist you, please note the product PRO treadmill offers an impressive selection of fea- model number and serial number before contacting us. tures designed to make your workouts at home more The model number and the location of the serial num- enjoyable and effective. And when you’re not exercis- ber decal are shown
Inhaltszusammenfassung zur Seite Nr. 6
PART IDENTIFICATION CHART Use the drawings below to identify small parts used for assembly. The number in parentheses below each draw- ing is the key number of the part, from the PART LIST near the end of this manual. The number following the key number is the quantity used for assembly. Note: If a part is not in the hardware kit, check to see if it is preat- tached. Extra hardware may be included. 1/4" Star #10 Star 5/16" Star Washer (5)–4 3/8" Star Washer (32)–4 3/8" Nut (12)–2 Washer (11)–4
Inhaltszusammenfassung zur Seite Nr. 7
ASSEMBLY • Assembly requires two persons. • To identify small parts, see page 6. • Place all parts in a cleared area and remove the • Assembly requires the following tools: packing materials. Do not dispose of the packing materials until you finish all assembly steps. the included hex key • The underside of the walking belt is coated with one adjustable wrench high-performance lubricant. After shipping, there may be some lubricant on top of the walking belt one Phillips s
Inhaltszusammenfassung zur Seite Nr. 8
3. Identify the Left Upright (89), which is marked 3 “Left.” Have a second person hold the Left Upright near the Base (94). 81 89 See the inset drawing. Tie the wire tie in the Left Upright (89) securely around the end of the Wire Upright Wire (81). Then, pull the other end of the 81 Tie wire tie until the Upright Wire is routed through the Left Upright. Wire Tie 89 81 94 4. Hold the Left Upright (89) against the Base (94). 4 Be careful not to pinch any wires. Insert two 3/8" x 2
Inhaltszusammenfassung zur Seite Nr. 9
5. Identify the Left Base Cover (82) and the Right 5 Base Cover (83). Slide the Left Base Cover onto the Left Upright (89). Slide the Right Base Cover onto the Right Upright (90). Do not press the Base Covers into place yet. 93 90 Slide the Console Base Back (93) onto the Uprights (89, 90). 83 89 82 6. Attach the left handrail assembly (B) to the Left 6 37 Upright (89) with two 5/16" x 2 1/2" Screws (37) and two 5/16" Star Washers (11). Be careful 11 not to pinch the Upright Wire (81
Inhaltszusammenfassung zur Seite Nr. 10
7. Start four #10 x 3/4" Screws (9) with four #10 7 Star Washers (32) into the Pulse Bar (112) and 9 C the Left and Right Handrails (88, 87). 99 E 32 Wire Slide the Pulse Bar (112) as far in the direc- Tie tion shown as possible, and then tighten the #10 x 3/4" Screws (9). Do not overtighten the 112 Screws. 81 9 Remove the wire tie from the Upright Wire (81). 32 87 Insert the pulse wire (E) from the Pulse Bar (112) through the looped Cable Tie (99) on the right handrail assembly (C)
Inhaltszusammenfassung zur Seite Nr. 11
9. Remove the two #8 x 1 1/4" Screws (107) and 9 slide the Left Handrail Cover (79) back about 1 in. The Screws will be reattached in step 81 16. Note: It is not necessary to move the Left Console Handrail Insert (84). 99 Assembly With the help of a second person, hold the con- sole assembly near the left handrail assembly (B). Route the Upright Wire (81) around the back of the console assembly as shown, and insert the end of the Upright Wire through the indicated looped Cable Tie
Inhaltszusammenfassung zur Seite Nr. 12
11. Set the console assembly onto the brackets on 11 the Handrails (87). Be careful not to pinch any Console wires. Assembly Attach the console assembly with the four 1/4" x 1/2" Screws (4) that you removed in step 8 87 87 and four 1/4" Star Washers (5). Start all four Screws and then tighten them. 5 5 4 4 12. Set the Console (103) onto the Console Base 12 (64). Make sure none of the wires from the Console are pinched. Attach the Console (103) to the Console Base 103 (64) with si
Inhaltszusammenfassung zur Seite Nr. 13
13. Connect the ground wires (G), the 8-pin wires 13 (F), the 10-pin wires (E), and the four speaker 103 wires (H) from the Console (103). Note: The Upright Wire (81) has 8 pins, the pulse wire (E) has 10 pins, and the speaker wires (H) have 2 pins. G F 81 E See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CON- NECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TU
Inhaltszusammenfassung zur Seite Nr. 14
15. Tighten nine #8 x 3/4" Screws (2) into the 15 Console Base Back (93) in the indicated loca- tions, starting with the center Screw. Start First 93 2 2 2 2 2 2 2 16. Slide the Handrail Covers (79, 80) forward until 16 they match up with the Console Base (64). Console Attach the Handrail Covers with the four #8 x 1 Assembly 1/4" Screws (107) that you removed in steps 9 and 10. Do not overtighten the Screws. Tighten four #8 x 3/4" Screws (2) into the con- sole assembly in the locations
Inhaltszusammenfassung zur Seite Nr. 15
17. Raise the Frame (56) to the position shown. 17 56 Orient the Storage Latch (53) so that the large barrel and the latch knob are oriented as shown. Attach the lower end of the Storage Latch (53) to 12 6 the Base (94) with a 3/8" x 2" Bolt (3) and a 3/8" Nut (12). Attach the upper end of the Storage Latch (53) to the Frame (56) with a 3/8" x 1 3/4" Bolt (6) and a 3/8" Nut (12). Latch Knob Lower the Frame (5 6) (see HOW TO LOWER 53 THE TREADMILL FOR USE on page 25). Large Bar
Inhaltszusammenfassung zur Seite Nr. 16
THE CHEST HEART RATE MONITOR HOW TO PUT ON THE HEART RATE MONITOR • Do not expose the heart rate monitor to direct sunlig ht for extended periods of time; do not expose The heart rate it to temperatures above 122° F (50° C) or below 14° monitor consists of F (-10° C). a chest strap and a Chest sensor. Insert the • Do not excessively bend or stretch the sensor when Strap Tabs tab on one end of using or storing the heart rate monitor. the chest strap into the hole in one e
Inhaltszusammenfassung zur Seite Nr. 17
OPERATION AND ADJUSTMENT HOW TO CONNECT THE POWER CORD nominal 120-volt circuit capable of carrying 15 or more amps. To avoid overloading the circuit, do Use a Surge Suppressor not plug other electrical devices, except for low- power devices such as cell phone chargers, into Your treadmill, like other electronic equipment, can be the surge suppressor or into an outlet on the same damaged by sudden voltage changes in your home’s circuit. IMPORTANT: The treadmill is not compat- power. Voltage
Inhaltszusammenfassung zur Seite Nr. 18
CONSOLE DIAGRAM FEATURES OF THE CONSOLE You can even listen to your favorite workout music or audio books with the console’s stereo sound system The treadmill console offers an impressive array of while you exercise. features designed to make your workouts more effec- tive and enjoyable. When you use the manual mode, To turn on the power, see page 19. To use the man- you can change the speed and incline of the treadmill ual mode, see page 19. To use an onboard workout, with the touch of a but
Inhaltszusammenfassung zur Seite Nr. 19
HOW TO TURN ON THE POWER HOW TO USE THE MANUAL MODE IMPORTANT: If the treadmill has been exposed to 1. Insert the key into the console. cold temperatures, allow it to warm to room tem- perature before you turn on the power. If you do See HOW TO TURN ON THE POWER at the left. not do this, you may damage the console displays or other electrical components. 2. Select the manual mode. Plug in the power cord (see If the manual mode is not selected, press the page 17). Next, locate the Manual
Inhaltszusammenfassung zur Seite Nr. 20
5. Foll ow your progress with the displays. Press the Home button to return to the default menu (see THE INFORMATION MODE on page As you walk or run on the treadmill, the display can 24 to set the default menu). If necessary, press the show the following workout information: Home button again. • The elapsed time When an iFit Live module is connected, the wireless sym- • The distance that you h ave walked or run bol at the top of the display will show the strength of you
