Inhaltszusammenfassung zur Seite Nr. 1
Model No. PATL41306.0
Serial No.
USER'S MANUAL
Serial Number
Decal
QUESTIONS?
If you have questions, or if any
parts are missing or damaged,
PLEASE CONTACT OUR CUS-
TOMER SERVICE DEPARTMENT
DIRECTLY.
Call toll-free:
800-830-7240
E-mail:
service@goodfamily.cc
Goodfamily’s Web site:
www.goodfamily.cc
ICON’s Web site:
www.iconfitness.com
CAUTION
Read all precautions and instruc-
tions in this manual before using
this equipment. Save this manual
Goodfamily is an authorized dealer of this trea
Inhaltszusammenfassung zur Seite Nr. 2
TABLE OF CONTENTS IMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7 HOW T
Inhaltszusammenfassung zur Seite Nr. 3
IMPORTANT PRECAUTIONS WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons, read the following important precautions and information before operating the treadmill. 1. It is the responsibility of the owner to ensure 12. Keep the power cord away from heated sur- that all users of this treadmill are adequately faces. informed of all warnings and precautions. 13. Never move the walking belt while the power 2. Use the treadmill only as described. is turned off. Do not op
Inhaltszusammenfassung zur Seite Nr. 4
27. To reduce the risk of electric shock, do not re- 23. DANGER: Always unplug the power move the cover or the back of the television. cord immediately after use, before cleaning the There are no user serviceable parts inside. treadmill, and before performing the mainte- Refer servicing to qualified service personnel. nance and adjustment procedures described in this manual. Never remove the motor hood un- 28. Upon completion of any service or repairs to less instructed to do so by an authorized
Inhaltszusammenfassung zur Seite Nr. 5
Power Lines Ground Standoff Clamp Insulators Service Entrance Mast To External Antenna Conductors Terminal of Treadmill Antenna Lead-in Wire Service Entrance Ground Antenna Wire Equipment Discharge Unit Ground Wire Power Service Grounding Electrode System (e.g. Ground Ground Bonding Interior Metal Water Pipe) Clamps Clamps Jumper Optional Antenna Grounding Electrode Driven 8 Feet (2.44m) Into The Earth (If Required By Local Codes). WARNING: Before beginning this or any exercise program, consult
Inhaltszusammenfassung zur Seite Nr. 6
BEFORE YOU BEGIN ® Thank you for selecting the revolutionary PROFORM ing this manual, please see the front cover of this man- 585 PERSPECTIVE treadmill. The 585 PERSPEC- ual. To help us assist you, please note the product TIVE treadmill offers an impressive array of features model number and serial number before contacting us. designed to make your workouts at home more enjoy- The model number of the treadmill is PATL41306.0 able and effective. And when you’re not exercising, the The serial numb
Inhaltszusammenfassung zur Seite Nr. 7
1 3 Handrail Bolt (64)–4 ASSEMBLY Star Washer Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not Extension Leg Bolt (96)–4 (84)–2 dispose of the packing materials until assembly is completed. Note: The underside of the walking belt is coated Wheel Nut (13)–2 Extension Leg Bolt (96)–4 with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This i
Inhaltszusammenfassung zur Seite Nr. 8
2. With the help of a second person, carefully raise the 2 Uprights (84) to a vertical position. Console Have the second person hold the console assembly near Assembly the Uprights (84) as shown. Look under the console as- sembly and locate the Console Wire Harness (78). Remove the tie securing the Upright Wire Harness (77) to the right Upright (84). Next, connect the Upright Wire Harness to the Console Wire Harness (78). Make sure to 78 connect the connectors properly (see the inset draw- 77
Inhaltszusammenfassung zur Seite Nr. 9
5. Orient the Latch Housing (73) so the large hole is on the 5 indicated side. Attach the Latch Housing to the left Upright (84) with two Latch Screws (3); start both Latch 84 Screws and then tighten them. Remove the knob from the pin. Make sure that the collar 73 and the spring are on the pin. (Note: If there are two col- Knob lars, place one on each side of the spring.) Next, insert Spring the pin into the Latch Housing (73). Then, tighten the knob back onto the pin. 3 Plug in the power cord
Inhaltszusammenfassung zur Seite Nr. 10
8. Note the location of the 75 ohm antenna terminal on the 8 treadmill. For the television to operate properly, an an- tenna, a CATV cable, or a VCR must be connected to the 75 ohm antenna terminal (see page 11). 75 Ohm Antenna Terminal 9. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread- mill. Note: Extra hardware may be inc
Inhaltszusammenfassung zur Seite Nr. 11
Before the personal television can be used, you must connect an antenna, a 75 ohm CATV cable, or a VCR to the 75 ohm antenna terminal on the treadmill frame. Note: No antenna, cable, or adapter is included. HOW TO CONNECT AN ANTENNA 300 Ohm Flat Wire Indoor Antenna 1. See the large drawing near the bottom of this page. Connect the 300 ohm flat wire from the antenna to a 1. Place a VHF 300 ohm to 75 ohm adapter. antenna in the Screwdriver desired loca- 2. Push the 300 ohm to 75 ohm adapter onto t
Inhaltszusammenfassung zur Seite Nr. 12
HOW TO USE THE CHEST PULSE SENSOR HOW TO PUT ON THE CHEST PULSE SENSOR • Store the chest pulse sensor in a warm, dry place. Do not store the chest pulse sensor in a plastic bag The chest pulse sensor consists of two components: or other container that may trap moisture. the chest strap and the sensor unit (see the drawing • Do not expose the chest pulse sensor to direct sun- below). Insert the tab on one end of the chest strap into light for extended periods of time; do not expose it to the ho
Inhaltszusammenfassung zur Seite Nr. 13
OPERATION AND ADJUSTMENT THE PRE-LUBRICATED WALKING BELT Your treadmill features a walking belt coated with high-performance lubricant. IMPORTANT: Never apply sili- cone spray or other substances to the walking belt or the walking platform. Such substances will deterio- rate the walking belt and cause excessive wear. HOW TO PLUG IN THE POWER CORD This product must be earthed. If it should malfunction or break 1 down, earthing provides a path of least resistance for electric cur- Socket on Tread
Inhaltszusammenfassung zur Seite Nr. 14
Key Clip FEATURES OF THE CONSOLE cific fitness goals. For example, lose unwanted pounds or train for a long-distance run. iFIT programs automat- The treadmill console offers an impressive array of ically control the treadmill while the voice of a personal features designed to make your workouts more effec- trainer coaches you and motivates you through every tive and enjoyable. When the manual mode of the con- step of your workout. iFIT Cards are available sepa- sole is selected, the speed and in
Inhaltszusammenfassung zur Seite Nr. 15
Km/H. As you exercise, change the speed of the HOW TO TURN ON THE POWER walking belt as desired by pressing the Speed in- crease and decrease buttons. Each time a button Plug in the power cord (see page 13). is pressed, the speed setting will change by 0.1 Km/H; if a button is held down, the speed setting Next, locate the on/off will change in increments of 0.5 Km/H. Note: After switch near the power the buttons are pressed, it may take a moment for On cord. Make sure that the the walking belt
Inhaltszusammenfassung zur Seite Nr. 16
The right display—This Next, hold the handgrip pulse sensor with your display will show the dis- palms resting on the metal contacts; avoid mov- tance that you have walked ing your hands. When your pulse is detected, the or run, the speed of the heart-shaped indicator in the right display will walking belt, the incline flash each time your heart beats, one or two level of the treadmill, your dashes (– –) will appear, and then your heart rate pace (in minutes per kilo- will be shown. For the most
Inhaltszusammenfassung zur Seite Nr. 17
When only three seconds remain in the first seg- HOW TO USE A PRESET PROGRAM ment of the program, both the Current Segment column and the column to the right will flash, and Insert the key into the console. a series of tones will sound. If the speed and/or in- 1 cline of the treadmill is about to change, the speed See HOW TO TURN ON THE POWER on setting and/or the incline setting will flash in the page 15. right display to alert you. When the first segment ends, all speed settings in the matrix
Inhaltszusammenfassung zur Seite Nr. 18
Next, remove the key from the console and put it in Follow your progress with the displays. 4 a secure place. Note: If the displays and various indicators remain lit after the key is removed, See step 5 on pages 15 and 16. the console is in the “demo” mode. See HOW TO USE THE INFORMATION MODE on page 24 Measure your heart rate if desired. 5 and turn off the demo mode. See step 6 on page 16. When you are finished using the treadmill, switch the on/off switch to the “off” position Turn on the fan
Inhaltszusammenfassung zur Seite Nr. 19
If heart rate program 22, HOW TO USE A HEART RATE PROGRAM 23, or 24 is selected, a pro- file of the target heart rate During heart rate program 21, your heart rate will re- settings of the program will main near a target heart rate setting that you select. appear in the matrix in the During heart rate programs 22, 23, and 24, your heart left display. rate will reach approximately 85% of your age-pre- dicted maximum heart rate. (Note: Your age-predicted maximum heart rate is calculated by subtrac
Inhaltszusammenfassung zur Seite Nr. 20
If heart rate program 22, setting with the Speed or Incline buttons. However, 23, or 24 is selected, the when the console compares your heart rate to the target heart rate setting for target heart rate setting, the speed of the treadmill the first segment will be may automatically change to bring your heart rate shown in the flashing closer to the target heart rate setting. Current Segment column of the matrix. The target heart If your pulse is not detected during the program, rate settings for
