Bedienungsanleitung Aqua Logic AQL2-WB-RF-PS-4

Inhaltszusammenfassung zur Seite Nr. 1

NiCad Battery Disposal (AQL-Tx-RF-PS-x/AQL2-Tx-RF-P-4 models)
Wireless Remote Display
At the end of the battery's useful life, it must be recycled or disposed of properly.
for
Contact your local county, or state hazardous waste management authorities for
information on recycling or disposal programs in your area.
FCC Statement
Aqua Logic Aqua Logic Aqua Logic
Aqua Logic Aqua Logic
This device complies with part 15 of the FCC rules. Operation is subject to the
Automation and Chlorination
followin

Inhaltszusammenfassung zur Seite Nr. 2

Compatibility LIMITED WARRANTY Goldline warrants its Aqua Rite, Aqua Rite Pro, Aqua Trol, Aqua Logic This product is compatible with all Aqua Logic PS controls operating with software and Pro Logic products (products with Goldline part numbers starting with AQ-RITE-, AQ-RT- revision r2.00 or higher and using an AQL2-BASE-RF Base Station operating with PRO, AQ-TROL-, AQ-LOGIC-, AQL-P-, AQL-PS-, AQL-CL-, PL-P-, PL-PS-, and HPC-2) to be software revision r3.00 or higher. Note that this product wil

Inhaltszusammenfassung zur Seite Nr. 3

c. Screw the baseplate in the desired position (screws supplied by installer). d. Plug the power supply’s output connector into the mating connector on the back of the AQL2-Wx-RF-PS-x. e. Reattach the wireless remote display/keypad to the baseplate. f. Plug the power supply into a 120VAC outlet. Bezel (use is optional) Fig. 1 Fig. 2 back of baseplate Push Screwdriver blade through slot and pull up cover Installation - AQL2-Tx-RF-PS-x and AQL2-Tx-RF-P-4 Table Top models 1. Base Station required:

Inhaltszusammenfassung zur Seite Nr. 4

control unit to shorten the distance between it and any wireless remote. See Teach Wireless Fail. the "Remote Mounting of the Base Station" section of the base station 10. Please try again. manual for more details. This is usually caused by a button being held down for more than 3 seconds, 2. Powering the AQL2-Tx-RF-PS-x/AQL2-Tx-RF-P-4: These models use a re- falsely triggering the Teach Wireless mode. It can also be displayed if the Aqua chargeable built-in battery pack which will require

Inhaltszusammenfassung zur Seite Nr. 5

5. Display backlight turns off after a period of time: Installation - all models Models running off wall power: The display backlight should always illuminate 1. Teach the unique Aqua Logic ID code: The base station attached to the Aqua when you press any key on the unit. If it turns off after a period of time, you can Logic control unit has a unique ID code that ensures that your unit will not affect stop this by pressing the menu key (possibly multiple times) until "Settings other systems in

Inhaltszusammenfassung zur Seite Nr. 6

OPERATION Battery dead! Please charge now! This display is shown briefly, immediately before the unit shuts down. The Table Top Operation - all models models will not operate again (to protect the battery) until it is plugged into the The wireless remote display/keypad communicates with the base station on the Aqua charger. It can be used immediately while connected to the charger. Logic control unit using RF (radio frequency) technology. All of the display informa- tion is transmitted from t