Inhaltszusammenfassung zur Seite Nr. 1
Model 5KFP1335
W10505785Av1.indd 1 7/12/12 9:31 AM
Inhaltszusammenfassung zur Seite Nr. 2
FOOD PROCESSOR INSTRUCTIONS Table of Contents FOOD PROCESSOR SAFETY Important Safeguards .......................................................................................................5 Electrical Requirements ...................................................................................................6 Electrical Equipment Waste Disposal ...............................................................................6 PARTS AND FEATURES Food Processor Parts ....................
Inhaltszusammenfassung zur Seite Nr. 3
FOOD PROCESSOR SAFETY IMPORTANT SAFEg UARDS When using electrical appliances, basic safety precautions should always be followed, including the following: 1. Read all instructions. 2. To protect against risk of electrical shock, do not put Food Processor in water or other liquid. 3. This appliance is not intended for use by persons (including children) with reduced physical sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruct
Inhaltszusammenfassung zur Seite Nr. 4
FOOD PROCESSOR SAFETY IMPORTANT SAFEg UARDS 15. Never feed food by hand. Always use the food pusher. 16. Do not attempt to defeat the cover interlock mechanism. 17. This product is designed for household use only. SAVE Th ESE INSTRUCTIONS Electrical Requirements Voltage: 220-240 Volts Frequency: 50/60 Hertz Wattage: 300 Watts NOTE: If the plug does not fit in the outlet, contact a qualified electrician. Do not modify the plug in any way. Electrical Equipment Waste Disposal This appliance is ma
Inhaltszusammenfassung zur Seite Nr. 5
PARTS AND FEATURES Food Processor Parts 3-Piece Food Work bowl Cover Pusher with 3-in-1 Feed Tube Accessory Case 3.1 L (13-Cup) Work bowl Externally Adjustable Slicing Control base 950 mL (4-Cup) Mini-bowl and Mini-blade Egg Whip Externally Adjustable Reversible (2 mm and 4 mm) Slicing Disc (Thin to Thick) Shredding Disc Dough blade Stainless Steel Slicing Drive Disc Adapter Adapter Adapter Multipurpose blade 7 W10505785Av1.indd 7 7/12/12 9:31 AM English
Inhaltszusammenfassung zur Seite Nr. 6
PARTS AND FEATURES Important Food Processor Features Externally Adjustable Slicing Control 3-Piece Food Pusher KitchenAid’s exclusive externally adjustable Three pushers are nested inside of each slicing disc allows you to adjust slicing other. Remove the medium pusher from the thickness from thin to thick, without having large pusher to reveal a medium-size feed to remove the blade assembly. With the tube for continuous processing. slicing disc installed, simply slide the Slicing For con
Inhaltszusammenfassung zur Seite Nr. 7
ACCESSORIES Disc Assembly Overview There are two different disc adapters included with the food processor. One is used exclusively with the adjustable slicing disc. The other is used with the Reversible Shredding Disc and all other optional discs. Adjustable Reversible Shredding Disc Slicing Disc Slicing Disc Adapter Adapter Drive Drive Adapter Adapter Properly assembled 9 W10505785Av1.indd 9 7/12/12 9:31 AM English
Inhaltszusammenfassung zur Seite Nr. 8
ACCESSORIES Accessories Selection g uide Action Setting Food Accessory Cheese Multipurpose Stainless Steel blade Chocolate Fruit Fresh Herbs Nuts Mince Chop Puree Tofu OR Vegetables Mini-bowl and Mini Multipurpose Meat Stainless Steel blade Pasta Sauce Pesto Salsa Mix Sauces Cake Batter Pie Dough Fruit (soft) Adjustable Slicing Disc Potatoes Tomatoes Vegetables (soft) Slice Slice Thin Thick Cheese Chocolate Fruit (hard) Vegetables (hard) Potatoes Reversible Shredding Disc Veg
Inhaltszusammenfassung zur Seite Nr. 9
PREPARINg Th E FOOD PROCESSOR FOR FIRST USE 2. Lift out the mini-bowl. before First Use Before using your Food Processor for the first time, wash the work bowl, work bowl cover, mini-bowl, feed tube pushers, discs, and blades either by hand or in the dishwasher (see “Cleaning the Food Processor”). Removing the Work bowl Storing Parts Cover from the Work bowl Once washed, disassembled discs, shafts, and blades should be stored in the provided Your Food Processor is shipped with the w
Inhaltszusammenfassung zur Seite Nr. 10
SETTINg U P YOUR FOOD PROCESSOR Attaching the Work bowl Attaching the Work bowl Cover 1. Place the Food Processor on a dry, level countertop with the controls NOTE: Be sure to install the desired facing forward. Do not plug in the Food accessory before attaching the work Processor until it is completely assembled. bowl cover. 2. Place the work bowl on the base, aligning the raised portion with the indentation on 1. Place the work bowl cover on the work the base. The center hole sh
Inhaltszusammenfassung zur Seite Nr. 11
SETTINg U P YOUR FOOD PROCESSOR Installing the Adjustable TIP: You may need to turn the disc/drive adapter until it drops down into place. Slicing Disc 4. Install the work bowl cover, being sure it IMPORTANT: The adjustable slicing disc locks into place. can only be installed in one direction. 1. With the work bowl installed, place the drive adapter on the power shaft of the base. 2. Holding the adjustable slicing disc by the 2 finger grips, align the pins onto the Adjusting the Slici
Inhaltszusammenfassung zur Seite Nr. 12
SETTINg U P YOUR FOOD PROCESSOR Installing the Shredding Disc 3. With the work bowl installed, slide the drive adapter onto the power shaft. IMPORTANT: When using the reversible shredding disc, have the desired side TIP: You may need to turn the disc/drive (medium/fine) facing UP. adapter until it drops down into place. 1. Holding the disc by the 2 finger grips, insert the disc adapter into the hole in the bottom of the disc. 4. Install the work bowl cover, being sure it locks into pl
Inhaltszusammenfassung zur Seite Nr. 13
SETTINg U P YOUR FOOD PROCESSOR Installing the Multipurpose Installing the Mini-bowl and blade or Dough blade Mini-blade 1. Place the mini-bowl inside the work bowl IMPORTANT: The multipurpose blade over the power shaft. Rotate the mini- and dough blade can only be used with the bowl until the tabs on the top edge of the work bowl. bowl drops into the indents on the top of the work bowl. 1. Place the blade on the power shaft. 2. Rotate the blade so it falls into place on the power shaft
Inhaltszusammenfassung zur Seite Nr. 14
SETTINg U P YOUR FOOD PROCESSOR Installing the Egg Whip Using the 3-in-1 Feed Tube The 3-in-1 feed tube IMPORTANT: The egg whip can only be features a 3-piece used with the work bowl. food pusher. Use the entire food pusher 1. Be sure the egg whip is properly to process large assembled. If the two pieces have been items, or use the disassembled for cleaning, align the pin on inner portions to the egg whip adapter with the slot on the create medium-sized egg whip, and rotate to lock
Inhaltszusammenfassung zur Seite Nr. 15
USINg Y OUR FOOD PROCESSOR Using the Speed 1/Speed 2 Control 1. To turn on the Food Processor, press the Speed 1 button (low speed, for soft food) or the Speed 2 button (high speed, for hard food). The Food Processor will run continuously and the indicator light will glow. 2. To stop the Food Processor, press the O (OFF) button. The indicator light will go out and the blade or disc will stop within a few seconds. 3. Wait until the blade or disc comes to a complete stop before rem
Inhaltszusammenfassung zur Seite Nr. 16
USINg Y OUR FOOD PROCESSOR 5. If using the mini-bowl, grasp and remove the bowl using the finger grips located along the top edge of the bowl. Removing Processed Foods 1. Press the O (OFF) button. 2. Unplug the Food Processor before disassembling. 3. Turn the work bowl cover to the left and remove. 6. Turn the work bowl to the left to unlock it from the base. Lift to remove. 4. If using a disc, remove it before removing the bowl. Holding the disc by the 2 finger grips, lift it str
Inhaltszusammenfassung zur Seite Nr. 17
CARE AND CLEANINg 5. If washing the Food Processor parts by hand, avoid the use of abrasive cleansers or scouring pads. They may scratch or cloud the work bowl and cover. Thoroughly dry all parts after washing. 6. To prevent damage to the locking system, always store the work bowl and work bowl cover in the unlocked 1. Press the O (OFF) button. position when not in use. 7. Wrap the power cord around the work 2. Unplug the Food Processor before cleaning. bowl. Secure the plug by cli
Inhaltszusammenfassung zur Seite Nr. 18
TIPS FOR gREAT RESULTS To chop nuts or make nut butters: Using a Slicing or Shredding Process up to 3 cups (710 mL) of nuts to Disc desired texture, using short pulses, 1 to 2 To slice or shred fruits seconds each time. For a coarser texture, or vegetables that are process smaller batches, pulsing 1 or 2 long and relatively small times, 1 to 2 seconds each time. Pulse more in diameter, such as celery, carrots, and often for finer texture. For nut butters, bananas: process continuousl
Inhaltszusammenfassung zur Seite Nr. 19
TIPS FOR gREAT RESULTS To slice cooked meat or poultry, • Do not overfill work bowl or mini-bowl. including salami, pepperoni, etc.: For thin mixtures, fill work bowl up to 1/2 to 2/3 full. For thicker mixtures, fill Food should be very cold. Cut in pieces to work bowl up to 3/4 full. For liquids, fill fit feed tube. Process food using firm, even up to the maximum level as described pressure. in the section “Using Your Food To shred spinach and other leaves: Processor - Maximum Liq
Inhaltszusammenfassung zur Seite Nr. 20
TIPS FOR gREAT RESULTS • When preparing a cake or cookie batter, • Use the spatula to remove ingredients use the multipurpose blade to cream from the work bowl. fat and sugar first. Add dry ingredients last. Place nuts and fruit on top of flour mixture to prevent overchopping. Process nuts and fruits, using short pulses, until blended with other ingredients. Do not overprocess. • When shredded or sliced food piles up on one side of the bowl, stop the processor and redistribute the food
