Bedienungsanleitung Casio 3095

Inhaltszusammenfassung zur Seite Nr. 1

MA0707-EA
Operation Guide 3095
About This Manual
• Depending on the model of your watch, display text
appears either as dark figures on a light background or
light figures on a dark background. All sample displays
in this manual are shown using dark figures on a light
background.
• Button operations are indicated using the letters shown
in the illustration.
• Each section of this manual provides you with the
information you need to perform operations in each
mode. Further details and technical i

Inhaltszusammenfassung zur Seite Nr. 2

Operation Guide 3095 To specify the week counting method Measuring Elapsed Time 1. In the Timekeeping Mode, hold down A until the Use the following procedure to perform a basic elapsed time operation with the Week number seconds start to flash, which indicates the setting stopwatch. screen. 2. Press C nine times to display the week count method To measure elapsed time screen. 1. While the stopwatch is stopped and reset to all zeros, 3. Use D and B to cycle through the week counting Split time

Inhaltszusammenfassung zur Seite Nr. 3

Operation Guide 3095 Using Auto-start To perform a countdown timer operation • If you use Auto-start to start a stopwatch operation, the watch will interpret the In the Countdown Timer Mode, press D to start the TR1 countdown. beginning of the Auto-start countdown as the starting point of the elapsed time • When the TR1 countdown reaches zero, the TR2 countdown will start automatically. operation and will start recording elapsed time record data from there. • To pause the countdown timer that cu

Inhaltszusammenfassung zur Seite Nr. 4

Operation Guide 3095 To configure Hourly Time Signal settings About the Auto Light Switch 1. In the Alarm Mode, use D to display the Hourly Time While the auto light switch is enabled, illumination turns on whenever you position Start time Signal (SIG) screen. your wrist as described below in any mode. 2. Hold down A until the Hourly Time Signal start time starts to flash. This is the setting screen. Moving the watch to a position that is parallel to the ground and then tilting it • This also w

Inhaltszusammenfassung zur Seite Nr. 5

Operation Guide 3095 To turn the button operation tone on and off City Code Table In any mode (except when a setting screen is on the display), hold down C to toggle the button operation tone City UTC City Other major cities in same time zone Code Differential on (mute indicator not displayed) and off (mute indicator PPG Pago Pago –11.0 displayed). HNL Honolulu –10.0 Papeete • Holding down C to turn the button operation tone on or ANC Anchorage –09.0 Nome off also causes the watch’s current mode