Inhaltszusammenfassung zur Seite Nr. 1
Inhaltszusammenfassung zur Seite Nr. 2
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 Henny Penny Blast Chiller/Freezer BFR/BCR-350 BCC/BCR-175 BCC/BCR-140
Inhaltszusammenfassung zur Seite Nr. 3
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 LIMITED WARRANTY FOR HENNY PENNY APPLIANCES Subject to the following conditions, Henny Penny Corporation makes the following limited warranties to the original purchaser only for Henny Penny appliances and replacement parts: NEW EQUIPMENT: Any part of a new appliance, except lamps and fuses, which proves to be defective in material or workmanship within two (2) years from date of original installation, will be repaired or replaced wit
Inhaltszusammenfassung zur Seite Nr. 4
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 TABLE OF CONTENTS Section Page Section 1. INTRODUCTION ................................................................................................................... 1-1 1-1. Henny Penny Blast Chiller ........................................................................................... 1-1 1-2. Features ....................................................................................................................... 1-
Inhaltszusammenfassung zur Seite Nr. 5
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 SECTION 1. INTRODUCTION 1-1. BLAST CHILLER/ The Henny Penny Blast Chiller are designed to carry out fast refrigeration of food products. The units are electronically con- trolled for easy use and for consistent operation. The BCC/BCR-140, will chill up to 140 lbs (65 kg) of product, the BCC/BCR-175 will chill up to 175 lbs (80 kg), and the BCR-350 will chill up to 350 lbs (160 kg) of product. The BFR-350 chills and freezes up to 3
Inhaltszusammenfassung zur Seite Nr. 6
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 1-5. SAFETY The Henny Penny Blast Chiller has may safety features incorpo- rated. However, the only way to ensure a safe operation is to fully understand the proper installation, operation, and maintenance procedures. The instructions in this manual have been prepared to aid you in learning the proper procedures. Where information is of particular importance or safety related, the words WARNING, CAUTION, and NOTE are used. Their usa
Inhaltszusammenfassung zur Seite Nr. 7
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 SECTION 2. INSTALLATION 2-1. INTRODUCTION This section provides the installation for the Henny Penny Blast Chiller. NOTE Installation of this unit should be performed only by a qualified service technician. Do not puncture the skin of the Blast Chiller with drills or screws, as component damage or electrical shock could result. Also, if the unit is shipped with a compressor, Do Not lay the unit on its side. If the unit h
Inhaltszusammenfassung zur Seite Nr. 8
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 2-2. UNPACKING 4. Open door and remove packing from the inside of the unit. (Continued) 5. Peel off any protective covering from the exterior of the cabinet. 6. Your Blast Chiller is now ready for operation. If the blast chiller has been laid on its side, the unit must be sitting upright for at least an hour before applying power to the unit. Check all components for signs of being loose or damaged, and make sure the system
Inhaltszusammenfassung zur Seite Nr. 9
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 2-3. ELECTRICAL Refer to the table below for electrical ratings for both models. (Continued) Model No. Volts Watts Amps Freq. Phase BCC-140 200 4700 18 50/60 3 208-240 4700 18 60 3 230 4700 20 50 1 BCC-175 200 5800 20 50/60 3 208-240 5800 20 60 3 400 5800 9 50 3N BCR-140 208-240 2400 12 60 1 230 2400 10 50 1 200 2400 12 50-60 1 BCR-175 200 2400 12 50/60 1 208-240 2400 12 60 1 230 2400 12 50 1 BFR & 200 4100 15 50/60 3 BCR-350
Inhaltszusammenfassung zur Seite Nr. 10
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 2-5. REFRIGERANT INFORMATION Design Pressure Refrigerant Type Amount of Refrig. High Low BCC-140 R404A 6 lbs. (2.7 kg) 406 psig 102psig (28 bar) (7 bar) BCC-175 R404A 5.5 lbs. (2.4 kg) 406 psig 102 psig (28 bar) (7 bar) 2-6. REFRIGERATION BCC/BCR-140 o o CAPACITIES -4 F (-20 C) at 6,800 BTU/hr (2.0 kw) o o 32 F (0 C) at 16,000 BTU/hr (4.7 kw) BCC/BCR-175 o o -4 F (-20
Inhaltszusammenfassung zur Seite Nr. 11
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 SECTION 3. OPERATION 3-1. INTRODUCTION This section provides operating procedures for the Blast Chiller. Sections 1, 2, and 3 should be read, and all instructions should be followed before operating the cabinet. This section contains an explanation of all controls and compo- nents and information on operating procedures and daily maintenance. If the blast chillers (that have compressors shipped with them) have been laid on its side,
Inhaltszusammenfassung zur Seite Nr. 12
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 3-2. OPERATING CONTROLS (Continued) Fig. Item Description Function No. No. 3-1 7 Select Button The Select button is used to choose between a timing cycle or a cycle using the food probe. 3-1 8 Fan LED The Fan LED is a green light which illuminates when the fan is running. 3-1 9 Compressor LED The Compressor LED is a green light which illuminates when the compressor is running. 3-1 10 End-of-Cycle LED The End-of-Cycle LED is a green l
Inhaltszusammenfassung zur Seite Nr. 13
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 3-3 100
Inhaltszusammenfassung zur Seite Nr. 14
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 3-3. BASIC OPERATION The Henny Penny Blast Chillers can chill food products with a core temperature of 149ºF (65ºC), down to 40ºF (4ºC) within 4 hours (room ambiant temperature may impact time it takes to reach the desired temperature). But, for the above statements to be accurate, the following conditions must be met: a. The food product must not be thicker than 1¾ to 2 inches (40 to 50 mm.) b. Meats should be placed directly onto
Inhaltszusammenfassung zur Seite Nr. 15
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 3-3. BASIC OPERATION 5. Press the Select button to choose the food probe mode or (Continued) the timing mode. With the Frigiprobe mode selected, the digital display will alternately show the core temperature of the product, and the elapsed time of the cycle. If the timing mode is selected, the digital display will alternately show the air temperature and the time (hours and minutes) remain- ing in the cycle. NOTE The buzze
Inhaltszusammenfassung zur Seite Nr. 16
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 3-3. BASIC OPERATION A temperature conversion chart is provided for your (Continued) convenience: 200 3-6
Inhaltszusammenfassung zur Seite Nr. 17
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 3-4. DE-ICING Henny Penny recommends to perform the de-icing process after every 3 cycles, and at the end of each day. This will eliminate any ice that may have formed around the evaporator during the chilling cycle. Failure the follow this procedure will increase the time it takes to cool the product and may lead to unsafe product. 1. Remove all product from the unit. 2. Close the door. 3. Press the ON/OFF button to turn the unit
Inhaltszusammenfassung zur Seite Nr. 18
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 3-5. CLEANING Daily: 1. Remove all electrical power supplied to the unit by turning off the wall circuit breaker. 2. Remove all product from the unit. 3. Remove the racks and pans from the unit and clean with soap and water at a sink. 4. Clean all surfaces with a soft cloth, soap and water. DO NOT USE ABRASIVE CLEANSERS. DO NOT use abrasives, such a steel wool, or abrasive cleaners, such as, chlorine, bromine, iodine, or ammonia che
Inhaltszusammenfassung zur Seite Nr. 19
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 3-5. CLEANING (Continued) 3. Use a vacuum cleaner, or soft brush to remove the dust, or other obstructions from the condenser. 4. Finish cleaning with compressed air if possible. DO NOT use a wire brush to clean the condenser, or damage to the condenser could result. 5. Replace the front panel, and reconnect the electrical supply, and unit is now ready for use. 3-6. SEASONAL OR 1. Remove all electrical power supplied to the uni
Inhaltszusammenfassung zur Seite Nr. 20
Henny Penny Model BCC/BCR-140, BCC/BCR-175, BFR/BCR-350 3-7. PROGRAMMING Information about the operation settings can be accessed by pressing the Alarm button. These settings can also be changed while in the different steps. The following information can be accessed: NOTE After pressing the Alarm button, a delay will occur before the desired number will appear in the display, and the number in the left column will show for 2 seconds. You then only have 12 seconds to change the setting
