Inhaltszusammenfassung zur Seite Nr. 1
Stockton 3/4/5/6/7/8/11
Free Standing Stove
Models: 7118/7101/7102/7119/7160/7127/7130/7161/7100/7162/7117/7120/7163/7103/7104/
7105/7113/7113lC/7128/7114/7106/7106lC/7106HC/7116/7116lC/7116HC
Instructions for Use,
Installation and servicing
For use in GB & Ie (Great Britain and Republic of Ireland).
This appliance has been certified for use in countries other than those stated. To install this appliance in these countries, it is essential to obtain the translated
instructions and in some cases
Inhaltszusammenfassung zur Seite Nr. 2
CoVeRING THe FolloWING Models: 7118/7101/7102/7119/7160/7127/7130/7161/7100/7162/7117/7120/7163/7103/7104/ 7105/7113/7113lC/7128/7114/7106/7106lC/7106HC/7116/7116lC/7116HC APPlIANCe CoMMIssIo NING CHeCKlIsT 3 CoMMIssIoNING 24 UseR INsTRUCTIoNs 4 MAINTeNANCe & seRVICING 25 General Points 4 Using the Appliance for the first time 5 Annual Service 25 Recommended Fuels 5 Removal of Log Guard 26 Lighting the appliance 6 Removal of Fire Brick 26 Running the appliance 7 Removal of Baffle 26
Inhaltszusammenfassung zur Seite Nr. 3
APPlIANCe CoMMIssIoNING CHeCKlIsT To assist us in any guarantee claim please complete the following information:- dealer appliance was purchased from Name: ................................................................................................................................................................. Address: ............................................................................................................................................................... ............
Inhaltszusammenfassung zur Seite Nr. 4
UseR INsTRUCTIoNs 1. GeNeRAl PoINTs 1.1 Before use of this appliance please read these instructions fully. 1.2 All local regulations, including those referring to national and european standards need to be complied with when installing the appliance. 1.3 Only use for domestic heating in accordance with these operating instructions. Data Plate 1.4 You must burn only approved fuels. Do not use with liquid fuels or as an incinerator. PR7540 1.5 Appliance surfaces become very hot when in us
Inhaltszusammenfassung zur Seite Nr. 5
UseR INsTRUCTIoNs WARNING Properly installed, operated and maintained this appliance will not emit fumes into the room. Occasional fumes from de-ashing and refuelling may occur. Persistent fume emission is potentially dangerous and must not be tolerated. If fume emission does persist: • Open doors and windows to ventilate the room •Allow fire to burn out or safely dispose of fuel from the appliance • Check for chimney blockage and clean if required
Inhaltszusammenfassung zur Seite Nr. 6
UseR INsTRUCTIoNs Poor quality timber: — Causes low combustion efficiency 4. lIGHTING THe APPlIANCe — Produces harmful condensation 4.1 For best results: — Reduces effectiveness of the airwash and life of the appliance • S e t a i r c o n t r o l s , S e e D i a g r a m 6 do not burn construction timber, painted, impregnated / treated wood, manufactured board products or pallet wood. 3.2 solid fuel: • Burn only anthracite or manufactured briquette smokeless fu
Inhaltszusammenfassung zur Seite Nr. 7
UseR INsTRUCTIoNs 5.2 Burning solid fuel: To burn solid fuel efficiently in a wood version the multi- fuel kit should be fitted. Multi-fuel kit part numbers: Appliance Part No. Stockton 5 (all) 7108 Stockton 6 (all) 7117 Stockton 7 7109 Stockton 8 7111 PR8004 Stockton 8 Slimline 7111SL • Close the door if desired. Only for use with recommended fuels, see Installation • Use a sparkguard if running with the doors open section for full fitting details. • S e t a i r c
Inhaltszusammenfassung zur Seite Nr. 8
UseR INsTRUCTIoNs 1) To safely remove the smoke, gases and fumes from the 5.5 When in use, burning the appliance at high output for a house. short period also reduces tars and creosote. 2) To provide a sufficient amount of draught (suction) in the 5.6 You must burn only anthracite or smokeless fuels appliance ensuring the fire keeps burning. suitable for use in closed appliances. Draught is caused by the rising hot air in the chimney when the appliance is lit. 5.7 do not burn bituminous
Inhaltszusammenfassung zur Seite Nr. 9
UseR INsTRUCTIoNs do not re-light the appliance until the problem is solved. 8. oVeR NIGHT BURNING 7. AsH ReMoVAl 8.1 It is possible to get the appliance to burn over night. In order to do this: 7.1 All Fuels when Multi-fuel kit is fitted: • De-ash prior to final refuelling • Riddle, See Diagram 11 • Set air controls to low combustion settings This will blacken the glass over night but it will clear when operated at high output for a short period. • Use smokeless fu
Inhaltszusammenfassung zur Seite Nr. 10
UseR INsTRUCTIoNs 13.3 Ensure adequate access to cleaning doors where it is not 11. GeNeRAl CleANING possible to sweep through the chimney. 11.1 Allow appliance to cool thoroughly to avoid risk of burns: 13.4 If the appliance is believe to have previously served an • Clean regularly, according to the level of use open fire the chimney must be swept a second time within • Give attention to the baffle system, flue ways and a month of regular use after installation. removin
Inhaltszusammenfassung zur Seite Nr. 11
UseR INsTRUCTIoNs • Glass blackening 15. seAsoNAl Use • Thick, brown and sticky tar oozes from the pipe joints 15.1 Clean and service the appliance if it is not used during the This is caused by burning damp wood and burning your warmer periods of the year as detailed in the Maintenance appliance at too low a temperature; and Servicing section • Use wel l season ed wood and operate the appliance in the ideal temperature range 15.2 Set the air controls 50% open t
Inhaltszusammenfassung zur Seite Nr. 12
TeCHNICAl sPeCIFICATIoN sToCKToN Model Stockton 3 - 7118 Stockton 4 - 7101/7102 Stockton 5 - 7119/7160/7108/7127/Stockton 5ML - 7130 Stockton 6 - 7100/7162/Stockton 6HL - 7117 Stockton 7 - 7120/7163 Stockton 8 - 7103/7104/7105/7113/7113LC/7113HC/7114/7128 Stockton 11 - 7106/7106LC/7106HC/7116/7116LC/7116HC Wood Nominal Heat Output kW 3.75 4.0 4.9 4.9 6.0 6.0 7.0 8.0 7.0 11.0 kW Solid Fuel 3.75 4.0 4.9 4.9 6.0 6.0 7.0 8.6 7.0 N/A mm Wg Flue Draught at Nominal Heat Output All Fuels 1.25 1.25 1.25
Inhaltszusammenfassung zur Seite Nr. 13
TeCHNICAl sPeCIFICATIoN sToCKToN dIMeNsIoN s 1. sTANdARd FeATURes B • Primary air (under grate air for full multi-fuel use) C • Airwash (for wood burning / clean glass) • Preset secondary air control (to ensure complete burning of H (dia) flue gases) • Riddling grate system for clean de-ashing (when fitted with D multi-fuel kit) • Removable door handle tool • Top or rear flue exit option A A A 2. PACKING lIsT E • User Instructions G • Installer I
Inhaltszusammenfassung zur Seite Nr. 14
TeCHNICAl sPeCIFICATIoN sToCKToN dIMeNsIoN s description Model A B C d e F G H (dia) stockton 3 7118 510 389 291 90 405 338 96 125 7101 stockton 4 572 389 291 90 465 338 112 125 7102 7119 stockton 5 544 481 294 90 436 335 120 125 7127 7160 stockton 5 lC 684 503 294 90 436 335 120 125 7161 stockton 5Ml 7130 600 481 294 90 493 294 175 125 7100 stockton 6 609 456 339 90 501 380 120 125 7162 stockton 6 Hl 7117 1020 456 338 90 913 380 263 125 7120 stockton 7 580 536 341 105 455 385 121 150 7
Inhaltszusammenfassung zur Seite Nr. 15
sITe ReQUIReMeNTs 1.5 You must sweep and inspect the flue when the appliance is 1. FlUe oR CHIMNeY installed. 1.6 You must check the flue draught with all windows and 1.1 The flue or chimney system must be in good condition. doors closed and any extraction fans in this or adjoining It must be inspected by a competent person and passed for rooms running at maximum speed. (See next section for use with the appliance before installation additional ventilation requirements) Products of combus
Inhaltszusammenfassung zur Seite Nr. 16
sITe ReQUIReMeNTs 1. FlUe oUTleT PosITIoNs Horizontal Terminal Measurement Flue 150mm Vertical max Measurement Adjacent Building Insulation The vertical measurement is the lowest from either the point of discharge or 150mm above insulation. Position on Roof Minimum Clearances IMPORTANT: Seek specialist On ridge or within 600mm 600mm above ridge A advice if installing in a dwelling with a thatched roof Elsewhere on roof 2300mm horizontally from roof surface and: B a) 1000mm above highest p
Inhaltszusammenfassung zur Seite Nr. 17
sITe ReQUIReMeNTs WAlls NeXT To A HeARTH Thickness W Solid, non-combustible material e.g. masonry or concrete H 150mm minimum C 150mm C minimum PR7204 Position of Appliance & Hearth in relation to walls Requirement for the walls distance of hearth from wall distance of Appliance to wall Min thickness of Wall Min height of wall 'C' 'W' 'H' 0mm 0mm - 50mm 200mm Height of appliance + 300mm Or 1200mm from the hearth (take largest 0mm 51mm - 300mm 75mm dimension) 0 - 150mm 150mm + 75mm 1200mm 150
Inhaltszusammenfassung zur Seite Nr. 18
PRe-INsTAllATIoN CHeCKs 1. FlUe Model Stockton 3 - 7118 Stockton 4 - 7101/7102 Stockton 5 - 7119/7160/7161/7127/Stockton 5ML - 7130 Stockton 6 - 7100/7162/Stockton 6HL - 7117 Stockton 7 - 7120/7163 Stockton 8 - 7103/7104/7105/7113/7113LC/7113HC/7114/7128 Stockton 11 - 7106/7106LC/7106HC/7116/7116LC/7116HC Without Liner System Flue/Chimney mm 150 150 150 150 150 150 150 180 Round (diameter) Size inch 6 6 6 6 6 6 6 7 Without Liner System (square) mm 135 135 135 135 135 135 135 165 Minimum Dimens
Inhaltszusammenfassung zur Seite Nr. 19
PRe-INsTAllATIoN CHeCKs 3. VeNTIlATIoN 3.1 This appliance requires ventilation to supply combustion air. Any room containing the appliance must have a permanent 2 air vent opening with a total free area of at least 550mm per kW of appliance rated output above 5kW. 3.2 Increase air supply provisions where a room contains multiple appliances. 3.3 If vents open into adjoining rooms or spaces there must be an air vent of at least the same size direct to the outside. 3.4 Permanent air vents shou
Inhaltszusammenfassung zur Seite Nr. 20
INsTAllATIoN INsTRUCTIoNs leGAl ReQUIReMeNTs Before installation of this product please read these instructions fully. It is very important to understand the requirements of the national Building Regulations* and standards**, along with any local regulations and working practices that may apply. Should any conflict occur between these instructions and these regulations Top Rear then the regulations must apply. PR8007 PR8008 Your local Building Control Office can advise regarding the • F
