Inhaltszusammenfassung zur Seite Nr. 1
DO NOT
DISCARD
R
3100 WOOD STOVE SERIES
Advanced Combustion Control (ACC)
Tested and Portland
O-T L
Owner’s Manual
Listed by Oregon USA
C US
Installation and Operation
OMNI-Test Laboratories, Inc.
Models:
31M-ACC-MBK
31ST-ACC
Step Top Uni-Body Model
Millennium Model
(Pedestal Model Shown)
CAUTION
DO NOT DISCARD THIS MANUAL
• Read, understand and • Leave this manual with
• Important operating
follow these instructions party responsible for
and maintenance
for safe installation and use and op
Inhaltszusammenfassung zur Seite Nr. 2
R 3100 Wood Stove Series (ACC) and Welcome to the Quadra-Fire Family! Hearth & Home Technologies welcomes you to our tradi- our stoves, inserts and fireplaces. And yet we are old-fash- tion of excellence! In choosing a Quadra-Fire appliance, ioned when it comes to craftsmanship. Each unit is meticu- you have our assurance of commitment to quality, durabil- lously fabricated and surfaces are hand-finished for lasting ity, and performance. beauty and enjoyment. Our pledge to quality is comple
Inhaltszusammenfassung zur Seite Nr. 3
R 3100 Wood Stove Series (ACC) TABLE OF CONTENTS Section 1: Listing and Code Approvals Section 8: Operating Instructions (Cont’d) A. Appliance Certifications ......................4 H. Baffle & Blanket Placement ................0 B. Mobile Home Approved ......................4 I. Blower Operating Instructions .............0 C. Glass Specifications ............................4 J. Opacity (Smoke) .................................30 D. BTU & Efficiency Specifications ..........4 K. Fre
Inhaltszusammenfassung zur Seite Nr. 4
R 3100 Wood Stove Series (ACC) Listing and Code Approvals 1 D. BTU & Efficiency Specifications A. Appliance Certification 100 Millennium & Step Top Uni-Body Model: EPA Certified: 1.1 grams per hour (ACC) Number: 69 EPA Certification Laboratory: OMNI Test Laboratories, Inc. Issued: 2006 Number and Date: 061-S-66-6 Report No & Date: 79.51% Efficiency: Listed Room Heater, Solid Fuel Type Type: 11,800 to 2,000 BTU Output: Standard: UL1482 and ULC S627-00 and Heating Capacity: up to1,800 sq
Inhaltszusammenfassung zur Seite Nr. 5
R 3100 Wood Stove Series (ACC) Getting Started 2 B. Fire Safety A. Design, Installation & Location Considerations Consideration must be given to: To provide reasonable fire safety, the following should be given serious consideration: • Safety • Convenience 1. Install at least one smoke detector on each floor of • Traffic flow your home to ensure your safety. They should be • Chimney and chimney connector required located away from the heating appliance and close to the sleeping areas.
Inhaltszusammenfassung zur Seite Nr. 6
R 3100 Wood Stove Series (ACC) C. Negative Pressure To minimize the affects of negative air pressure the following Draft is the pressure difference needed to vent appliances must be considered: successfully. Considerations for successful draft include: • Install the outside air kit. Install the intake on the • Preventing negative pressure side of the house towards prevailing winds during the • Location of appliance and chimney heating season. • Ensure adequate outdoor air is supplied
Inhaltszusammenfassung zur Seite Nr. 7
R 3100 Wood Stove Series (ACC) F. Tools And Supplies Needed D. Flue Draft Considerations Location of the appliance and chimney will affect perfor- Before beginning the installation be sure that the following mance. As shown in Figure 6.1 on page 6 the chimney tools and building supplies are available. should: • Be installed through the warm space enclosed by the Reciprocating saw Framing Material building envelope. This helps to produce more draft, Pliers Hi-Temp Caulking Material espec
Inhaltszusammenfassung zur Seite Nr. 8
R 3100 Wood Stove Series (ACC) Spark Arrestor Cap H. Typical Stove Systems Fireclay Flue Liner Concrete Cap With Air Space Stove system with masonry chimney consists of: Rafter • Stove Flashing • Chimney Connector (stove pipe) 1" (25mm) Clearance With Firestop • Thimble Ceiling Joist Eave • Masonry Chimney • Hearth Pad Floor Protection Combustible Wall Thimble, 12" (305mm) Of Brick Sheathing Outside Air Rear Vent Outside Air Floor Termination Cap Protector Airtight
Inhaltszusammenfassung zur Seite Nr. 9
R 3100 Wood Stove Series (ACC) Dimensions and Clearances 3 25 in. (65mm) A. Appliance Dimensions C L 9-15/16 in. 12-1/2 in. (27mm) (18mm) NOTE: Flue Collar size is 6 inch (152mm) diameter (ID) 10-15/16 in. (271mm) 15-1/16 in. 14-15/16 in. (8mm) (7mm) 18-15/16 in. Millennium Model 0 in. (475mm) (762mm) Figure 9.1 Front View 26-11/16 in. (668mm) 24-5/16 in. (618mm) 6-11/16 in. (170mm) C L 11-1/2 in. 16 in. (406mm) (292mm) C L 4-1/2 in (108mm) Outside Air Connection 20-/4 in. (527mm)
Inhaltszusammenfassung zur Seite Nr. 10
R 3100 Wood Stove Series (ACC) Appliance Dimensions (Cont’d) 3100 Step Top Pedestal Model 3100 Step Top Leg Model 25 in. (65mm) C 12-1/2 in. L 9-5/16 in. (18mm) (27mm) 14-15/16 in. 19-1/16 in. (79mm) (484mm) -1/8 in. 10-15/16 in. 15-1/16 in. (841mm) (278mm) (8mm) 4-1/4 in. (870mm) 18 in. (457mm) 2-7/8 in. (606mm) Figure 10.1 Figure 10.3 26-11/16 in.(678mm) 6-11/16 in. (170mm) 24-5/16 in. (618mm) -1/2 in. 15-/8 in. (91mm) (89mm) C 3-11/16 in. (94mm) L Back of Stove to Glass 2-/8 i
Inhaltszusammenfassung zur Seite Nr. 11
R 3100 Wood Stove Series (ACC) B. Clearances to Combustibles (UL and ULC) BACKWALL / SIDEWALL ALCOVE SIDE VIEW NOTE: Clearances may only be reduced by means approved by the regulatory authority having jurisdiction A B G A C D B H 90° OFF TOP * UP & OUT CEILING G CLEARANCE CORNER INSTALLATION STOVE TO CEILING CLEARANCE E ALCOVE TOP VIEW F C E D F MINIMUM CLEARANCES TO COMBUSTIBLE MATERIALS In Inches & (Millimeters) NOTE: All "A" , "C" and "F" Dimensions are to the inside diameter o
Inhaltszusammenfassung zur Seite Nr. 12
R 3100 Wood Stove Series (ACC) Installation 4 In Canada, similar floor protection must be provided 18 A. Hearth Protection Requirements inches (457mm) in front and 8 inches (20mm) from the FLOOR PROTECTION: Floor protector must be non-com- sides and rear of the stove. *See exception. bustible material, extending beneath heater and to the front, *ExCEPTION: Non-combustible floor protections must sides and rear as indicated. The floor must be non-com- extend beneath the flue pipe when in
Inhaltszusammenfassung zur Seite Nr. 13
R 3100 Wood Stove Series (ACC) Step-Top Uni-Body Model For the Step Top Pedestal Model In US installations, it is For the Step Top Leg Model In US installations, it is nec- necessary to install a floor protector of a minimum of /8 inch essary to install a floor protector of a minimum thickness of (9.5mm) thick metal clad millboard or equivalent a minimum of 1-1/4 inch (2mm) or 1/2 inch of “k” value of 0.84 thick metal 16 inches (406mm) in front of glass and 8 inches (20mm) clad millboard o
Inhaltszusammenfassung zur Seite Nr. 14
R 3100 Wood Stove Series (ACC) B. Outside Air Kit Installation WARNING A source of air (oxygen) is necessary in order for combus- Fire Risk. tion to take place. Whatever combustion air is consumed Asphyxiation Risk. by the fire must be replaced. Air is replaced via air leak- Do not draw outside combustion air from: age around windows and under doors. In homes that have • Wall, floor or ceiling cavity tightly sealed doors and windows, an outside air source is needed. An optional Outside Air
Inhaltszusammenfassung zur Seite Nr. 15
NOTE: The blower cord is equipped with a pronged (grounding) plug for your protection against shock hazard. Do not remove. R 3100 Wood Stove Series (ACC) C. Blower (Optional) CAUTION 1. Remove the bolts (1/4”-20 Phillips head) on the outer skin at the bottom rear of appliance. Shock Risk. 2. Align holes in mounting flange of blower with bolt holes in • Do NOT remove grounding prong from plug. appliance. Blower should be positioned at bottom of rear • Plug directly into properly gro
Inhaltszusammenfassung zur Seite Nr. 16
R 3100 Wood Stove Series (ACC) Chimney Requirements 5 A. Venting Components B. Chimney Systems Chimney Connector: Prefabricated Metal Chimney It is also known as flue pipe or stove pipe. The chimney • Must be a 6 inch (152mm) diameter (ID) high temperature connector joins the stove to the chimney. It must be a 6 inch o chimney listed to UL 10 HT (2100 F) or ULC S629M. (152mm) minimum diameter 24 gauge mild steel black or • Must use components required by the manufacturer for 26 gauge b
Inhaltszusammenfassung zur Seite Nr. 17
R 3100 Wood Stove Series (ACC) Thimble C L Site constructed for masonry chimney installation: ceiling Components 13.5” below ceiling to top of opening • A minimum length of 12 inches [05mm] (longer for Wall or top of opening is a min.of thicker walls) of solid insulated factory-built chimney 4.5” below min.clearance Minimum18.0” specified by connector mfg. length constructed to UL 10 Type HT 6 inch (152mm) NFPA 211 1.5 2x2 framing stud inside diameter. Chimney needs to extend a min
Inhaltszusammenfassung zur Seite Nr. 18
R 3100 Wood Stove Series (ACC) Solid Pack Chimney with Metal Supports as a C. Installing Chimney Components Thimble (Cont’d) Chimney Connector Single wall connector or stove pipe. Min. Chimney Clearance to This must be at least 24 gauge mild steel or 26 gauge blue Wall Spacer and Min. Clearance Combustibles - 2 inch (51mm) steel. The sections must be attached to the appliance and to 2 inch (51mm) each other with the crimped (male) end pointing toward the 1 inch (25mm) Air stove. All join
Inhaltszusammenfassung zur Seite Nr. 19
R 3100 Wood Stove Series (ACC) D. Chimney Termination Requirements NOTE: Follow manufacturers instructions for clearance, securing, • Chimney performance may vary. flashing and terminating the chimney. • Trees, buildings, roof lines and wind conditions affect performance. • Must have an approved and listed cap • Chimney height may need adjustment if smoking or • Must not be located where it will become plugged by overdraft occurs. snow or other material • Must terminate at least feet (
Inhaltszusammenfassung zur Seite Nr. 20
R 3100 Wood Stove Series (ACC) Mobile Home Installation 6 You must use a Quadra-Fire Outside Air Kit Part OAK-ACC and (depending on floor installation, SparkArestor Cap Part SRV7033-041) for installation in a mobile home. 1. An outside air inlet must be provided for combustion See Storm Collar page 14 for installation information. 2. Appliance must be secured to the mobile home structure Roof Flashing by bolting the pedestal through hearth pad and into floor. . Appliance must be groun
