Inhaltszusammenfassung zur Seite Nr. 1
installation & operating Manual
The TL300 Top Loading Wood Stove
EPA Certified by
r5
OMNI-Test Laboratories
SaFeTY noTice
PLeaSe read ThiS enTire ManuaL beFore You inST aLL and uSe Your neW rooM hea Ter. FaiLure
To FoLLoW inSTrucTionS Ma Y reSuLT in ProPerTY daMage, bodiLY injur Y, or even dea Th.
For uSe in The u.S. and canada. SuiT abLe For inST aLLa Tion in a MobiLe hoMe(uS onLY).
iF ThiS Wood-burning ST ove iS no T Pro Per LY inSTa LLed , a hou Se Fire MaY re SuLT. For Your Sa FeTY,
Inhaltszusammenfassung zur Seite Nr. 2
2 Harman TL300
Inhaltszusammenfassung zur Seite Nr. 3
index Introduction 4 Specifications 5 Installation 8 Venting 10 Operation/Building a Fire 16 Maintenance 19 Options 21 Service Parts 22 Warranty 26 Please read this entire manual before you install and use your new heating appliance. Failure to follow instructions may result in property damage, bodily injury, or even death. Hearth & Home Technologies, Inc. 352 Mountain House Road Halifax, PA 17032 ~ U.S.A. Harman TL300 3
Inhaltszusammenfassung zur Seite Nr. 4
introduction Thank you for purchasing the Harman TL300 Wood Stove. We are confident that you will enjoy the warmth and convenience of your Harman Stove for decades to come. With the TL300 you will notice even heat throughout your home and long burn times. This is possible because of Harman’s special FireDome Non-Catalytic Combustion System, designed into the TL300 to promote clean burning and even heat output. This equates to unvarying heat over a longer period of time without the temperatur
Inhaltszusammenfassung zur Seite Nr. 5
734 mm 675 mm Specifications Weight 525 Lbs Flue Size 6 inch Log Length Recommended 18 in. / 20 in. Max Heating Capacity 1,500 - 3000 sq. ft. Average Emissions 1.1 Grams Per Hr. Emissons on Low 0.8 Grams Per Hr. Outside Air Size 3 or 4 inch SAFETY NOTICE: IF THIS STOVE IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT. FOR YOUR SAFETY, FOLLOW THE INSTALLATION DIRECTIONS. CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION INSPECTION REQUIREMENTS IN YOUR AREA. The Ha
Inhaltszusammenfassung zur Seite Nr. 6
Specifications Top Load Door Top Load Opening Front Load Door Grate Top Load Door Handle Andirons Air Control Ash Door Front Load Door Latch Ash Door Latch 6 Harman TL300
Inhaltszusammenfassung zur Seite Nr. 7
Specifications The Stove General Considerations Doors Draft Your stove has a large glass-paneled door for loading and Before you install and/or operate your TL300 wood stove, fire viewing, a separate smaller door for removing ashes, and please read the entire contents of this manual. Pay particular a top loading door. attention to the explanation of draft and its effect on stove Front Door performance, in the installation section. By following the Before opening, always check for wood, emb
Inhaltszusammenfassung zur Seite Nr. 8
installation 44" (1100 mm) Clearances Clearance is the empty space required between the stove 8" (200 mm) or chimney connector and the nearest combustible surface or object, such as walls, ceilings, floors, or furniture. Clearance distances may only be reduced by using methods approved by either the CAN/CSA B365 standard (Canada) or NFPA 211 (U.S.) Contact your building authority for information 8" 8" if you are interested in reducing clearance distances below (200 mm) (200 mm) those pr
Inhaltszusammenfassung zur Seite Nr. 9
installation/clearances Single Wall Pipe - Parallel Installation 15"* 375 mm 31" (775 mm) 31" 2' (50 mm) 23" (775 mm) (575 mm) 20" (500 mm) 17" 425 mm Top vent vented out back wall Top Vent to vented out side wall Top vent ceiling and sidewall Damper Open Damper Closed o o with 90 elbow. with 90 elbow clearances 24" 18" 23" 17" (600 mm) (450 mm) (575 mm) 425 mm) 31" (775 mm) 20" (500 mm) Single Wall Pipe - Top Vent - Parallel Installation Double Wall Pipe - Parallel Installation 11"*(2
Inhaltszusammenfassung zur Seite Nr. 10
venting Chimney Connectors and Chimneys No part of the chimney connector may pass through an attic or roof space, closet or other concealed space, or through a Draft floor or ceiling. Whenever possible, avoid passing the connec- Draft is widely misunderstood. It is important that you, tor through a combustible wall; if you must, use an approved the stove operator, realize that draft is a variable effect, not wall pass-through, described later in this section. a given quantity. Stoves and
Inhaltszusammenfassung zur Seite Nr. 11
venting Non-combustible cover, one Closest side only. If two covers are Combustible Minimum 2" (50mm) Hole with a minimum used, each must be mounted Material Clearance to Brick on non-combustible spacers clearance of 18" (450 mm) at least 7/8" (21mm) away between connector and wall. Minimum 12" from the wall. Liner (300mm) to Brick Fire Clay Thimble Chimney Connector 1" (25mm) Masonry Chimney Built to Clearance NFPA 211 Specifications. Minimum 12" (300mm) to Combustibles AN APP
Inhaltszusammenfassung zur Seite Nr. 12
venting Existing Masonry Chimneys If you plan on using a pre-existing masonry chimney, have it thoroughly inspected and cleaned. Any faults which make the chimney unsafe and unusable must be repaired prior to use. These can include improper height, structural defects, blockages, inadequate clearance to combustibles, unsealed openings into other rooms of the house, signs of creosote or smoke leakage, a loose or absent clean-out door, or absence of a liner. Do not connect to any air distrib
Inhaltszusammenfassung zur Seite Nr. 13
venting Standard Ceiling Installation with Cathedral Ceiling Installation with Factory Built Chimney Factory Built Chimney Harman TL300 13
Inhaltszusammenfassung zur Seite Nr. 14
venting Chimney Breach Fireplace Conversion with Non-Combustible Wall Minimum Clearance to Unprotected Ceiling 18" Chimney Connector Sealed at Thimble Flue Liner with Re- quired Air Space Minimum of three Sheet Airtight Metal Screws per Joint of insulated Chimney Connector Clean-out Mantel and Trim Protection Damper Closed and Sealed with Floor Protection* Non-Combus- tible Material. Combustible Floor * Floor Protection in Accordance with Solid Fuel Appliance Listing 14 Harman TL300
Inhaltszusammenfassung zur Seite Nr. 15
venting Chimney Breach Fireplace Conversion with Combustible Wall Minimum Clearance from Chimney Connector to Un- protected Ceiling 15"** Flue Liner with Required Air Space Listed or Approved Thimble Assembly Combustible 1" Clearance for Exterior Wall Chimney or 2" Clearance for Interior Chimney and 2" Clearance for NFPA 211-Type Sheetrock Airtight Approved Thimbles insulated Clean-out Mantel & Trim Protection Damper Closed and Sealed with Noncombustible Material. Floor Protection*
Inhaltszusammenfassung zur Seite Nr. 16
operation Two important controls - the top load door handle and The Combustion Process the air control lever regulate the operation and output Combustion in the Harman TL300 is precisely con- of the stove. trolled and is divided into two parts. Top loading door handle/damper interlock.The top During combustion, primary air enters at the bot- loading door handle is linked to the bypass damper and tom front of the stove and travels up channels at either serves two purposes. Move the handle fo
Inhaltszusammenfassung zur Seite Nr. 17
building a Fire Building and Maintaining the Fire Do not use chemicals or fluids to start the fire. Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to start or “freshen up” a fire in this heater. Keep all such liquids well away from the heater while it is in use. Begin with the bypass damper open, and the air control lever at the maximum setting, all the way to the right. Be sure the ash pan door is closed and latched. Start with a b
Inhaltszusammenfassung zur Seite Nr. 18
building a Fire Building and Maintaining the Fire Cont. Always remember to open the bypass damper when Avoid overfiring your stove. you are loading, this allows the exhaust gases to pass Overfiring is a potentially hazardous situation which can lead to overheating of combustible materials, dam- directly into the flue outlet and reduces the chance of age to the stove, and in extreme cases, cause a fire. smoke spillage into the room. Overfiring is caused by: Reloading: Once you have prepa
Inhaltszusammenfassung zur Seite Nr. 19
Maintenance Glass - Replacement Like all fine equipment, your TL300 requires some If the stove’s glass is cracked or broken, you must routine maintenance and inspection. Follow the guide- replace it before operating your stove. Remove pieces lines in this section to assure safe, efficient operation. carefully. Replace glass only with Harman replacement glass; do not use substitutes. To replace the glass panel, you will need to The Stove remove the door. To do this, open the door, lift it
Inhaltszusammenfassung zur Seite Nr. 20
Maintenance Gaskets The Chimney System Gaskets are used at strategic positions when building Creosote the Harman TL300 for controlling the path that incom- When wood is burned slowly, it produces tar and other ing and outgoing air and gases take through the stove. organic vapors, as well as soot, which combine with You must check these gaskets from time to time and expelled moisture to form creosote. The creosote vapors replace them when necessary. The gaskets are made condense in the re
