Inhaltszusammenfassung zur Seite Nr. 1
BERRINGTON
SOLID FUEL BOILER
STOVE
INSTALLATION AND OPERATING INSTRUCTIONS
This appliance is hot while in operation and retains its heat for a long period of time after use. Children, aged
or infirm persons should be supervised at all times and should not be allowed to touch the hot working surfaces
while in use or until the appliance has thoroughly cooled.
Inhaltszusammenfassung zur Seite Nr. 2
TABLE OF CONTENTS PAGE NO. 1. General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 2. Pre Installation Assembly. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 3. Flues . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 4. Flue Pipes . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 3
BERRINGTON SOLID FUEL STOVE INSTALLATION & OPERATING INSTRUCTIONS GENERAL Fig.3 When installing, operating and maintaining your Berrington Stove respect basic standards of fire safety. Read these instructions carefully before commencing the installation. Failure to do so may result in damage to persons and property. Consult your local Municipal office and your insurance representative to determine what regulations are in force. Save these instructions for future reference. The installation
Inhaltszusammenfassung zur Seite Nr. 4
2300 with a minimum continuous draught of 15 Pascals. Fig.4 Poor draught will result in poor performance. Similarly an excessive draught will result in the appli- ance over firing or being difficult to control. An excessive draught may require a flue draught sta- biliser to be fitted. Do not connect this appliance to a chimney serving another appliance. The minimum required chimney height is 4.5 metres from the floor on which the appliance is installed. An existing masonry chimney should be insp
Inhaltszusammenfassung zur Seite Nr. 5
These air vents must also be fire proofed as per Fig. 5 Building Regulations. Air vents traversing cavity walls should include a continuous duct across the cavity. The duct should 6” Cast Iron be installed in such a manner as not to impair the Bend weather resistance of the cavity. Joints between air vents and outside walls should be sealed to prevent the ingress of moisture. Existing air vents should be of the correct size and unobstructed for the appli- ance in use. If there is an air extr
Inhaltszusammenfassung zur Seite Nr. 6
FLOOR PROTECTION It is recommended that this appliance is installed on a solid, level, non combustible hearth conforming to current Building Regulations. Fig.7 The appliance is suitable for continuous operation on solid mineral fuel and intermittent operation on wood logs. This appliance has been tested using seasoned wood logs and manufactured briquetted smokeless fuel (Ancit) for closed appliances, sized between 20g and 140g. Other fuels are commer- cially available. Wood logs up to 400 mm l
Inhaltszusammenfassung zur Seite Nr. 7
SPECIFICATION Fig 8 Dimensions A B C D E F G H I J K Metric (mm) 660 648 330 114 114 419 446 305 251 654 488 NOTE: Dimensions stated below may be subject to a slight +/- variation. SPECIFICATIONS TECHNICAL DATA Metric Depth 495mm Boiler Tapping: 1” BSP Flue Outlet 152mm Boiler Capacity: 12.7 Litres Fire Door Size 455x230mm Log Size 400mm Maximum Operating Water Pressure 2.0 Bar Nominal Output: Wood Logs Solid Mineral Fuel Room: 3.2kW 3.4kW Water: 4.8kW 4.5kW Typical refuelling intervals to ob
Inhaltszusammenfassung zur Seite Nr. 8
PLUMBING WATER CIRCUIT TEMPERATURE The return water temperature should be maintained REGULATIONS at not less than 40°C so as to avoid condensation on the boiler and return piping. Fitting a pipe thermo- The plumbing must be in accordance with all stat to the return pipe of the gravity circuit and wiring relevant regulations and practices. It must include a it into the pump control will ensure rapid circulation gravity circuit with expansion pipe, open to the of the hot water. atmosphere. Th
Inhaltszusammenfassung zur Seite Nr. 9
Fig.11 (closed to maximum). Setting 4 will provide the most heat from the appliance. The zero position may not always be in the 12 o’clock position but the knob will only rotate once between fully open and fully closed. (See Fig.10) LOW / SLUMBER BURN To achieve an overnight or a low burn rate, close the air wash slider fully by sliding the lever left using the ashpan tool and rotate the primary air control knob in an anticlockwise direction until the lowest burning rate is found without the f
Inhaltszusammenfassung zur Seite Nr. 10
IMPORTANT NOTES Now that your Solid Fuel Stove is installed and no doubt you are looking forward to many comforts it will provide, we would like to give you some tips on how to get the best results from your stove. 1. We would like if you could take some time to read the operating instructions/hints, which we are confident, will be of great benefit to you. 2. Do not burn fuel with a high moisture content, such as a damp or unseasoned timber. This will only result in a build up of tar in the st
Inhaltszusammenfassung zur Seite Nr. 11
LIGHTING 1. Before lighting the stove, ensure that any build up of ashes in the fire box has been removed and that the ashpan has been emptied. 2. Open the firebox and cover the grate with crumpled pieces of paper. 3. Lay pieces of kindling on top of the paper towards the back of the fire box. 4. Open the primary air inlet by turning the control knob to setting 4. 5. Open the secondary air control by sliding the control lever located over the top of the fire door to the right. (See Fig.11). 6.
Inhaltszusammenfassung zur Seite Nr. 12
DE-ASHING Fig.13 When ash build-up becomes excessive in the fire chamber shake the firebars by inserting the operat- ing tool into the round slot on the right side of the stove, twisting clockwise and anti-clockwise. A poker is also provided for de-ashing. Fig.12 TO CLEAN CHIMNEY OUTLET These parts are heavy and must be allowed to cool before removal. Remove baffle underneath the boiler cross flow chamber by lifting it upwards and pulling it outwards and insert cleaning brush. Replace baffle be
Inhaltszusammenfassung zur Seite Nr. 13
3. Use only products recommended by the Fig.15 Vitreous Enamel Association, these products carry the Vitramel label. Association 4. DO NOT USE ABRASIVE PADS OR OVEN CLEANSERS CONTAINING CITRIC ACID ON ENAMELLED SURFACES. ENSURE THAT THE CLEANSER MANUFACTUR- ERS INSTRUCTIONS ARE ADHERED TO. FIRE SAFETY GLASS CLEANING To provide reasonable fire safety, the following The glass will self clean when there is sufficient heat should be given serious consideration. generated by the burning fuel.
Inhaltszusammenfassung zur Seite Nr. 14
BERRINGTON SOLID FUEL BOILER STOVE EXPLODED VIEW Aga, Station Road, Ketley, Telford, Shropshire, TF1 5AQ, UK Ref: N00430AXX Rev: 001 DP070308 13 23. Air Wash Box 1. RH Side 24. Air Wash Casting 2. Leg 25. Inner Top 3. LH Side 26. Air Control Knob 4. Front Frame 27. Spacer To Door Handle 5. Base Panel 28. Door Catch 6. Hob 29. AGA Stove Badge 7. Ashtray Front 30. Fire Fence 8. Boiler 31. Boiler Cleaning Door 9. Shaker Bar Sleeve 32. Glass 10. Air Slide Sub Assy 33. Ashpit Door Handle 11. Ashpa
