Inhaltszusammenfassung zur Seite Nr. 1
Inspire Electric Fireplace
Model: ICVCEFP01
Trim Models: ICVCTK01 Black Trim Kit,
ICVCTK02 Pewter Trim Kit
INSTALLER / CONSUMER SAFETY INFORMATION
PLEASE READ THIS MANUAL BEFORE
INSTALLING AND USING APPLIANCE
WARNING!
IF THE INFORMATION IN THIS MANUAL IS NOT
FOLLOWED EXACTLY, AN ELECTRICAL SHOCK
OR FIRE MA ���� Y RESULT CAUSING PROPERTY
DAMAGE, PERSONAL ������ ��� � � �� INJURY OR LOSS OF LIFE.
����
FOR YOUR SAFETY
Service must be performed by a qualified service
agency.
DO NOT STORE OR
Inhaltszusammenfassung zur Seite Nr. 2
Inspire Electric Fireplace Thank you and congratulations on your purchase of a CFM Corporation electric fireplace. IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the war- ranty. PLEASE READ THE INSTALLATION & OPERATING INSTRUCTIONS BEFORE USING THIS APPLIANCE Table of Contents Installation Instructions General ..........................................
Inhaltszusammenfassung zur Seite Nr. 3
Inspire Electric Fireplace Installation Instructions General 1. Read all instructions before using this appliance. 13. This appliance, when installed must be electrically 2. This appliance is hot when in use. To avoid burns, do not grounded in accordance with local codes, with the current let bare skin touch hot surfaces. If provided, use handles CSA C22.1 Canadian Electrical codes or for US installa- when moving this appliance. Keep combustible materials, tions, follow local codes and the Nat
Inhaltszusammenfassung zur Seite Nr. 4
Inspire Electric Fireplace Fireplace Dimensions 36” Minimum Shelf Height (To Heater Main Body) (914 mm) 24����” 23���" (615 mm ) (594 mm) 5 �����” 35 �����” (910 mm) 9 ���” (145 mm) Minimum [Heater Main Body Width 32���” (832 mm)] (250 mm) From Floor Do not use this fireplace if any part of it Electrical Specifications has been under water. Immediately call a Voltage 120V ac, 60 Hz qualified service technician to inspect the Total Amps 7.9 Amps fireplace and replace any part of the elec- 9472
Inhaltszusammenfassung zur Seite Nr. 5
Inspire Electric Fireplace Direct (Hard) Wiring Electric Fireplace W ARNING: This procedure must be conducted by a is connected to the main power switch and is termi- qualified electrician, in accordance with National and nated with a straight terminal connector. The neutral local codes. In the U.S.A., the installation must conform wire is connected at the circuit board’s screw clamp to the National Electrical Code, ANSI/NFPA No. 70. In terminal block. The green ground wire is attached Canada
Inhaltszusammenfassung zur Seite Nr. 6
Inspire Electric Fireplace Fireplace Assembly Unpack the Appliance 4. Measure half the width [16 ³⁄₈” (416 mm)] of the heater main body and mark a vertical line to cross The Inspire Electric Heater is supplied in two (2) car- the horizontal line. If the heater main body is to be tons. All instructions should be read before beginning centered on the wall area, mark a vertical center line installation. to cross that horizontal line. Where the horizontal Carton 1 contents and vertical marks
Inhaltszusammenfassung zur Seite Nr. 7
Inspire Electric Fireplace Insert Panel Magnets FP1638 Fig. 3 Place insert panels on either side of trim. FP1637 Magnets 5. Hang the trim to the heater main body’s upper trim Fig. 4 Trim magnet location. ������ support at a slight angle and between the trim insert panels. Slowly, swing the trim down until the mag- �� �������� �������� nets catch to the heater main body. ���� ������ �� ���������� ���� 10009472 7
Inhaltszusammenfassung zur Seite Nr. 8
Inspire Electric Fireplace Operating Instructions Heater Operation The heater is operated by the remote control handset. A master ON/OFF switch is located under the appliance on the left hand side. This is used to turn the appliance Fire On/Flame completely off. Effect Only Fire Off All further operations are controlled by using the remote control handset. (Fig. 5) 1. Ensure the appliance is plugged in and switched on. Low Heat 2. To turn the fire on, press the fire on/flame effect but- High
Inhaltszusammenfassung zur Seite Nr. 9
Inspire Electric Fireplace Maintenance WARNING Before carrying out any maintenance, ensure the appliance is disconnected from the main power supply. If in doubt, seek the assistance of a quali- fied technician. It is advisable to use genuine CFM Corporation replace- ment parts available from your authorized dealer. Removable Panel Light Bulb Replacement 1. Disconnect the appliance from the main power sup- ply. 2. Remove the decorative trim assembly. 3. Remove the pebbles and ember bed. 4. Remov
Inhaltszusammenfassung zur Seite Nr. 10
Inspire Electric Fireplace 1 3 5 4 6 7 8 9 10 CFM Corporation reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. Inspire Replacement Parts Ref. Description Part Number 1. 20W Energy Saving Bulb* B-98830 9472 2. Pebble Pack (not shown) B-81770 Inspire parts 3. Colored Filter B-99670 8/06, 4. Ember Lava Rock B-93420 5. Circuit Board B-99610 6. Transmitter B-100990 7. Fan Heater 1097-99660 8. Flam
Inhaltszusammenfassung zur Seite Nr. 11
Inspire Electric Fireplace 1 YEAR WARRANTY For Vermont Castings Electric Fireplace BASIC WARRANTY: CFM Corporation (hereinafter referred to collectively as 7. All other warranties - expressed or implied - with respect the “Company”) warrants that your new electric fireplace to the product, its components and accessories, or any ob- is free from manufacturing and material defects for a ligations/liabilities on the part of the Company are hereby period of one year from date of installation, su
Inhaltszusammenfassung zur Seite Nr. 12
CFM Corporation 2695 Meadowvale Blvd. • Mississauga, Ontario, Canada L5N 8A3 800-668-5323 • www.cfmcorp.com
