Inhaltszusammenfassung zur Seite Nr. 1
DO NOT
DISCARD
R
Owner’s Manual
Installation and Operation
Model(s):
QFP38-NG
QFP38-LP
CAUTION
DO NOT DISCARD THIS MANUAL
• Read, understand and follow • Leave this manual with
• Important operating and
these instructions for safe party responsible for
maintenance instructions
installation and operation. use and operation.
included.
WARNING WARNING
HOT SURFACES!
If the information in these instruc-
Glass and other surfaces are hot during
tions is not followed exactly, a
operation and coo
Inhaltszusammenfassung zur Seite Nr. 2
Read this manual before installing or operating this appliance. Please retain this owner’s manual for future reference. This owner’s manual should be retained for future reference. A. Congratulations We suggest that you keep it with your other important Congratulations on selecting a Quadra-Fire gas fi replace, an documents and product manuals. elegant and clean alternative to wood burning fi replaces. The The information contained in this owner’s manual, unless Quadra-Fire gas fi replace you
Inhaltszusammenfassung zur Seite Nr. 3
Safety Alert Key: • DANGER! Indicates a hazardous situation which, if not avoided will result in death or serious injury. • WARNING! Indicates a hazardous situation which, if not avoided could result in death or serious injury. • CAUTION! Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. • NOTICE: Used to address practices not related to personal injury. Table of Contents A. Congratulations 2 5 Framing and Clearances B. Limited Lifetime Warra
Inhaltszusammenfassung zur Seite Nr. 4
14 Finishing A. Facing Material 54 B. Facing Template Removal 55 C. Mantel and Wall Projections 56 15 Appliance Setup A. Remove Fixed Glass Assembly 57 B. Remove the Shipping Materials 57 C. Clean the Appliance 57 D. Install the Refractory 57 E. Install Logs, Ember Bed 58 F. Install Andirons, Lava Rock, Rockwool 60 G. Complete Log Installation 60 H. Accent Lighting Set Up 61 I. Adjust the Air Shutter 62 J. Adjust the Vertical Baffl e 62 K. Fixed Glass Assembly 63 L. Install Door Fronts 63 16
Inhaltszusammenfassung zur Seite Nr. 5
B. Limited Lifetime Warranty Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/09 5
Inhaltszusammenfassung zur Seite Nr. 6
B. Limited Lifetime Warranty (continued) 6 Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/09
Inhaltszusammenfassung zur Seite Nr. 7
Listing and Code Approvals 1 1 A. Appliance Certifi cation D. High Altitude Installations NOTICE: If the heating value of the gas has been reduced, MODELS: QFP38-NG, QFP38-LP these rules do not apply. Check with your local gas utility or LABORATORY: Underwriters Laboratories, Inc. (UL) authorities having jurisdiction. TYPE: Vented Gas Fireplace Heaters When installing above 2000 feet elevation: STANDARD: ANSI Z21.88b-2008 • CSA 2.33b-2008 • In the USA: Reduce input rate 4% for each 1000 f
Inhaltszusammenfassung zur Seite Nr. 8
Inspection Note: The following requirements reference various The state or local gas inspector of the side wall horizon- Massachusetts and national codes not contained in this tally vented gas fueled equipment shall not approve the document. installation unless, upon inspection, the inspector ob- serves carbon monoxide detectors and signage installed H. Requirements for the Commonwealth of in accordance with the provisions of 248 CMR 5.08(2)(a)1 Massachusetts through 4. For all side wall
Inhaltszusammenfassung zur Seite Nr. 9
User Guide Operating Instructions 2 2 A. Gas Fireplace Safety If you expect that small children or vulnerable adults may come into contact with this fi replace, the following precau- tions are recommended: WARNING • Install a physical barrier such as: HOT SURFACES! - A decorative fi rescreen. Glass and other surfaces are hot during operation and cool down. - Adjustable safety gate. Hot glass will cause burns. • Install a switch lock or a wall/remote control with child • Do not touch glass un
Inhaltszusammenfassung zur Seite Nr. 10
C. Clear Space E. Fixed Glass Assembly See Section 15.K. WARNING! DO NOT place combustible objects in front of the fi replace or block louvers. High temperatures may start F. Before Lighting Fireplace a fi re. See Figure 2.3. Before operating this fi replace for the fi rst time, have a Avoid placing candles and other heat-sensitive objects on qualifi ed service technician: mantel or hearth. Heat may damage these objects. • Verify all shipping materials have been removed from inside and/or undern
Inhaltszusammenfassung zur Seite Nr. 11
H. System Description The Remote Control System consists of three elements: • Transmitter • Receiver • Fan Control Module (FCM) I. Fan Control Module • Fan Control Module (FCM) controls the following items remotely: - Fan (six speeds) - 120V Out - Aux Out (accent lighting) VOLTAGE SUPPLY CORD MODULE ON/OFF SWITCH COMMUNICATION BUS (3 PIN) AUX OUTLET PLUG (Accent Lighting) FAN OUTLET PLUG Figure 2.4 Fan Control Module Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/09 11
Inhaltszusammenfassung zur Seite Nr. 12
J. Receiver • The receiver is powered by four AA batteries. • The receiver accepts commands via radio frequency from the transmitter to operate the appliance in accordance with the system confi guration. • The receiver three position slider switch can be set to one of three positions: - ON (manual override) - REMOTE (remote control) - OFF 12 PIN terminal PRG Key 3 Positions Slider Figure 2.5 Receiver Body K. Initializing the System for the First Time Install the four AA batteries into the rece
Inhaltszusammenfassung zur Seite Nr. 13
L. Transmitter (Remote Control with LCD Display) • The transmitter is powered by three AAA batteries. • A MODE key is provided to index between the features. • A THERMOSTAT key is used to turn on/off or index through thermostat functions (Figures 2.6 and 2.7). Blue LCD display ON/OFF Key THERMOSTAT Key UP/DOWN Arrow Key MODE Key Figure 2.6 Transmitter Child safety lock-out Transmission Low battery alarm Thermostat OFF/ON/SMART Room Temperature Set Point Temperature/Level/State Split Flow Flame
Inhaltszusammenfassung zur Seite Nr. 14
M. Operating Procedure with Split Flow (dual burner control) • The rear burner is controlled by the split fl ow function. To activate this function use the MODE key to index to the SPLIT FLOW icon. (Figure 2.8.) • Press the UP ARROW key to turn the rear burner on. • Press the DOWN ARROW to turn the rear burner off. A single “beep” will confi rm the reception of the command. Figure 2.8 Split Flow 14 Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/09
Inhaltszusammenfassung zur Seite Nr. 15
Temperature Indication Display With the system in the OFF position, press the THERMOSTAT key and the MODE key at the same time. Look at the LCD screen on the transmitter to verify that a C or F is visible to the right of the room temperature display. (Figure 2.9.) Figure 2.9 Remote Control Display in Farenheit & Celsius Turn on the Appliance Press the ON/OFF key on the transmitter. The transmitter display will show all active icons on the screen. At the same time the receiver connects, the the
Inhaltszusammenfassung zur Seite Nr. 16
Remote Flame Control The fl ame control has six fl ame levels. With the system on, and the fl ame level at the maximum in the appliance, press- ing the DOWN ARROW key once will reduce the fl ame height by one step until the fl ame is turned off. The UP ARROW key will increase the fl ame height each time it is pressed. If the UP ARROW key is pressed while the system is on but the fl ame is off, the fame will come on in the hight position. (Figure 2.11.) A single “beep” will confi rm reception of the co
Inhaltszusammenfassung zur Seite Nr. 17
Room Thermostat (Transmitter Option) The remote control can operate as a room thermostat. The thermostat can be set to a desired temperature to control the comfort level in a room. To activate this function, press the THERMOSTAT key. The LCD display on the transmitter will change to show that the room thermostat is ON and the set temperature is now displayed. (Figure 2.12.) To adjust the set temperature, press the UP ARROW or DOWN ARROW keys until the desired set tempemperature is displayed o
Inhaltszusammenfassung zur Seite Nr. 18
Fan Speed Control Your appliance is equipped with a hot air circulating fan and the speed of the fan can be controlled by the system. The fan speed can be adjusted through six speeds. To activate this function use the MODE key to index to the Fan Control icon (Figure 2.14). Use the UP ARROW/DOWN ARROW keys to turn on, off or adjust the fan speed. A single “beep” will confi rm reception of the command. Figure 2.14 Fan Speed Control Remote Actuated 120V Auxiliary Outlet (accent lighting) The auxi
Inhaltszusammenfassung zur Seite Nr. 19
Key Lock This function will lock the keys to avoid unsupervised operation. To activate this function, press the MODE and UP ARROW keys at the same time. (Figure 2.16.) To de-activate this function, press the MODE and UP ARROW keys at the same time. Figure 2.16 Key Lock Function N. Low Battery Power Detection Transmitter The life span of the remote control batteries depends on various factors: quality of batteries used, the number of ignitions of the appliance, the number of changes to the room
Inhaltszusammenfassung zur Seite Nr. 20
Q. Lighting Instructions (IPI) • For normal use, activate/deactivate your fi replace with the remote control. • The IPI system may be operated with four AA batteries. • If your fi replace must be deactivated for serviced or an extended period of time, follow the instructions below. 20 Quadra-Fire • QFP38 Series • 4061-300 Rev i • 9/09 This appliance needs fresh air for safe operation and must be installed so there are provisions for FOR YOUR SAFETY READ BEFORE LIGHTING adequate combustion an
