Inhaltszusammenfassung zur Seite Nr. 1
INSTALLER/CONSUMER
SAFETY INFORMATION
™
Read and save
these instructions.
This book contains your installation
instructions and should be kept in a
safe place. For you to realize all the Vent-Free Gas Fireboxes
advantages and use of the reliable ser-
vice that has been engineered into your
Model: UV36
fireplace, you must carefully follow all of
the instructions contained in this book
regarding installation and operation of
the fireplace.
These instructions should be read care-
fully in th
Inhaltszusammenfassung zur Seite Nr. 2
UV36 Vent-Free Firebox Table of Contents This book contains your operating instructions and should be kept in a safe place. For you to realize all the advan- tages and use of the reliable service that has been engineered into your fireplace, you must carefully follow all of the instructions contained in this book regarding installation and operation of the fireplace. These instructions should be read carefully in their entirety before beginning installation of the fireplace. It is suggested that
Inhaltszusammenfassung zur Seite Nr. 3
UV36 Vent-Free Firebox Important Information INSTALLER: Please leave these instructions with the To avoid irreparable damage to the appliance or personal in- owner. jury; matches, paper, garbage or any other material must not OWNER: Please retain these instructions for future be placed or thrown on top of the logs or into the flames. reference. To avoid personal injury, do not touch hot surfaces when IMPORTANT: READ THESE INSTRUCTIONS CARE- the appliance is operating. FULLY BEFORE OPERATING.
Inhaltszusammenfassung zur Seite Nr. 4
UV36 Vent-Free Firebox Any ANSI approved vent free log set with a maximum of 39,000 Btu/h or less that will fit into the firebox may be 20 ���" used. (Fig. 1a) The following CFM Specialty Home Products vent free gas logs sets may be used: 11" VL24MN, VL24MP, VL24RN, VL24RP, VFL34MN, VFL34MP, VFL34RN, VFL34RP. 30���" Fig. 1a Firebox dimensions. Fireplace Dimensions T258 Rough firebox dimensions Opening 5/28/04 djt 21���" Depth 35���" 1/2" 14���" Rough Opening Width 36 ���" 1/2” Clearance to
Inhaltszusammenfassung zur Seite Nr. 5
UV36 Vent-Free Firebox Installation Instructions Choosing the Location for Your Fireplace Framing Clearances Figure 2 shows some of the many ways your fireplace The fireplace may be placed directly on a combustible may be installed. Consider the traffic pattern in your floor, against a combustible wall at marked clearances room and the location of doors and windows. Moving or on a raised wooden platform. air from ceiling fans, open doors and hot air grilles may If the fireplace is to be installed
Inhaltszusammenfassung zur Seite Nr. 6
UV36 Vent-Free Firebox Combustible Mantel Clearances Cabinet Installation 8" 6" 24" 1" 3" Noncombustible 20" or Void 12" 12" 21" Standoff Noncombustible 9" 9" Canopy Installation Hex Head Screws 17" Canopy T233 Fig. 3 Combustible mantel clearances. Installing the Firebox 21���" This list of specific instructions will help you make cer- tain that every installation operation is done correctly. 1/2" Complete the installation steps in the sequence shown. 14���" T233 LOCAL BUILDING CODES SHOULD BE
Inhaltszusammenfassung zur Seite Nr. 7
UV36 Vent-Free Firebox Step 3: Level the Firebox Finishing the Fireplace Check the level of the firebox on the top edge of the There are a wide variety of finishing materials avail- fireplace face. Shim if necessary. able for your fireplace from formal wall treatments with Step 4: Secure the Firebox marble and mantels to rustic wood paneling, stone or Four (4) nailing flanges are supplied with the fireplace brick. (found on the fireplace hearth). To level the box and IT IS IMPORTANT THAT THE BL
Inhaltszusammenfassung zur Seite Nr. 8
UV36 Vent-Free Firebox 6a Wallboard with Marble, Slate or Tile Facing 6c Wallboard with Facing and Mantel Finished Wall Stud Finished Wall Stud Header Noncombustible Header Decorative Cover- Must be enclosed with a ing noncombustible material. Noncombustible Must be enclosed with a Decorative Covering noncombustible material. The bottom mantel projection must be located a mini- mum of 9” above the fireplace opening. (Fig. 5b) T235 T234 T235 6d Wallboard with Facing-Not Flush T234 finishi
Inhaltszusammenfassung zur Seite Nr. 9
UV36 Vent-Free Firebox should be caulked around its perimeter to assure a tight seal. The rain cap opening should be positioned Soffit Termination downward. (Fig. 10) Attic The Outside Air Kit is now installed and ready for use. Duct Ceiling Termination 40’ Max. Duct Run Duct KT145 Fig. 9 Secure the inlet collar assembly. Exterior Wall Termination KT145 Duct Ter- Caulking AKU reinstall mination cover plate 9/6/00 djt Exterior Wall Rain Cap 40’ Max. Duct Run Rain Cap Duct Termination Duct
Inhaltszusammenfassung zur Seite Nr. 10
UV36 Vent-Free Firebox 4 1 5 2 3 CFM Specialty Home Products reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. UV36 Vent-Free Firebox Ref. Description UV36 7446 1. Refractory Side Brick (2 per fireplace) 73501 UV36 parts 8/04 2. Refractory Back Brick 74554 3. Screen Panel Assy (2 per fireplace) 70317 4. Canopy 71653 5. Rod, Screen (2 per fireplace) 73652 Contact CFM Specialty Home Products for quest
Inhaltszusammenfassung zur Seite Nr. 11
UV36 Vent-Free Firebox LIMITED LIFETIME WARRANTY PRODUCT COVERED BY THIS WARRANTY All Vermont Castings gas stoves, gas inserts, and gas fireplaces, and all Majestic or Northern Flame brand gas fireplaces equipped with an Insta-Flame Ceramic Burner, or standard steel tube burner. BASIC WARRANTY • Any part and/or component replaced under the provisions of this warranty is covered for six months or the remainder of the original CFM Specialty Home Products (hereinafter referred to collectively as
Inhaltszusammenfassung zur Seite Nr. 12
CFM Specialty Home Products 410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6 • 905-670-7777 www.majesticproducts.com • www.vermontcastings.com