Bedienungsanleitung Lennox Hearth STRIKER S160

Inhaltszusammenfassung zur Seite Nr. 1

HEARTH PRODUCTS
KITS AND ACCESSORIES
P/N 506033-33
FACEPLATE KITS
Rev. NC, 03/200
INSTALLATION INSTRUCTIONS FOR INSTALLING FACEPLATE KITS
FOR USE WITH MODELS S 60, SS2 0, ST2 0, S260, ST3 0, C 60, C2 0,
C260, E260 AND C3 0 WOOD STOVES AND WOOD FIREPLACE INSERTS
KIT CONTENTS
Faceplate Kit (Includes Faceplate, Handle and Nameplate)
For Models: C260, E260, C30, S260 and ST30
1 ea. Arch or Traditional Faceplate (item #4)
Cat. No. Model Description
1 ea. Spring Handle (item #5)
1 ea. T

Inhaltszusammenfassung zur Seite Nr. 2

INSTALLATION INSTRUCTIONS Step . Remove Spring Handle - Twist spring handle clockwise and pull down at the same time to remove from handle rod (see Figures 2 and 3). Allen head screws indicated by arrows Figure 4 Spring Handle Figure 2 Allen Head Screw and Washer Rotate spring handle clockwise to remove Allen Wrench Figure 5 Step 3. Remove Faceplate - Be advised that the faceplate also functions as a glass retainer (see Figure 6). Make sure to apply inward pres- sure on the glass while rem

Inhaltszusammenfassung zur Seite Nr. 3

Step 4. Install New Faceplate - Slide the faceplate over the handle rod while the handle rod is at a 90° position (see Figures 7 and 8). Move the handle rod up and down and slightly in and out when Door Rope sliding the faceplate onto the handle rod. .25 IMPORTANT, ALWAYS PRESS INWARD ON THE GLASS WHILE Screws and THE FACEPLATE IS NOT RETAINING THE GLASS, OTHERWISE Washers THE GLASS MAY FALL OUT AND BREAK. Door Back Handle Rod Glass Glass Gasket Figure 7 Faceplate Figure 9 Step 6. Reinsta

Inhaltszusammenfassung zur Seite Nr. 4

NAMEPLATE OPTIONS This instruction sheet explains how to install a nameplate onto a wood- burning stove or insert. Your new Country Collection™ wood-burning appliance includes a nickel Country nameplate in the manual packet and a nickel Lennox™ nameplate installed on the appliance. Smoke Hood REPLACEMENT KIT CONTENTS (See Figure 12) The contents below ship separately with Cat. # H8079 and H8080 Figure 11 1 ea. Instruction Sheet 2 ea. #6 x 1” Carriage Bolt (item #1) 2 ea. #6 Nut (item #2) 1