Bedienungsanleitung Lennox Hearth RAVELLE 30

Inhaltszusammenfassung zur Seite Nr. 1

HEARTH PRODUCTS
KITS AND ACCESSORIES
775,253M
ARCH AND CLASSIC FACE AND INSET KITS
Rev. A, 06/2010
MODELS RAVELLE™ 30 AND RAVELLE 42
TM
INSTALLATION INSTRUCTIONS FOR INSTALLING ARCH AND CLASSIC FACE KITS
FOR USE WITH THE RAVELLE 30 AND RAVELLE 42 DIRECT VENT GAS FIREPLACES
KIT CONTENTS (See Figure 1):
Please ensure that all these parts are in one of the two boxes.
Classic Face -
See complete list of kits available on Page 4.
Required to
Complete Face: Insets
1 ea. Face, (Large box) Item #1
1

Inhaltszusammenfassung zur Seite Nr. 2

GENERAL INFORMATION All of these parts may scratch and bend, great care should be used in handling them. If you encounter any problems, need clarification of these instructions or are not qualified to properly install this kit, contact you local distribu- tor or dealer. Read this instruction sheet in its entirety before beginning the installation. ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND OPERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO THESE INSTRUCTIONS. TURN OFF THE FIREPL

Inhaltszusammenfassung zur Seite Nr. 3

Step 4. Included in the face box are two mounting brackets that attach to the top of the face. There is a left and a right hand bracket. When Ravelle 30 the bracket is installed on the face the lower left hand corner of the bracket will have an angled edge that will be facing towards Arch Face Bracket the outside of the face. The mounting brackets for the Ravelle™ 30 Arch face uses the smaller brackets with a measurement of 2 inches across the top (See Figure 4B, item #1). The mounting b

Inhaltszusammenfassung zur Seite Nr. 4

Face Installation Step 7. The bracket shown in Figure 7 is installed on the face during the face assembly (see the instructions on the previous page). The captive A number of different faces are available for the Ravelle 42 fireplace, screws, shown in Figure 7, on this bracket need to be screwed into however all the faces are installed in a similar manner. A total of four captive nuts on the fireplace as follows; Align the face for plumb screws, two upper and two lower, attach the face to