Inhaltszusammenfassung zur Seite Nr. 1
DO NOT
DISCARD
Pour demander un exemplaire en français de ce Manuel
Para obtener un ejemplar en Español de este
du propriétaire, visitez www.heatnglo.com.
Manual del propietario, visite www.heatnglo.com.
Owner ’ s Manual
Installation and Operation
Models:
6000CL-IPI-S
6000CL-IPILP-S
6000CL-IPI-T
6000CL-IPILP-T
8000CL-IPI-S
8000CL-IPILP-S
8000CL-IPI-T
8000CL-IPILP-T
NOTICE
DO NOT DISCARD THIS MANUAL
• Important operating • Read, understand and follow • Leave this manual with
and maintenance th
Inhaltszusammenfassung zur Seite Nr. 2
Read this manual before installing or operating this appliance. Please retain this owner’s manual for future reference. This owner’s manual should be retained for future A. Congratulations reference. We suggest that you keep it with your other Congratulations on selecting a Heat & Glo gas fireplace, an important documents and product manuals. elegant and clean alternative to wood burning fireplaces. The information contained in this owner’s manual, unless The Heat & Glo gas fireplace you
Inhaltszusammenfassung zur Seite Nr. 3
Safety Alert Key: • DANGER! Indicates a hazardous situation which, if not avoided will result in death or serious injury. • WARNING! Indicates a hazardous situation which, if not avoided could result in death or serious injury. • CAUTION! Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. • NOTICE: Used to address practices not related to personal injury. T able of Contents A. Congratulations . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 4
13 Finishing A. Mantel and Wall Projections . . . . . . . . . . . . . . . . . . . . . . . 53 B. Facing Material . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 53 C. Doors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 54 D. Elevated Hearth Systems . . . . . . . . . . . . . . . . . . . . . . . . . 57 14 Appliance Setup A. Remove Fixed Glass Assembly . . . . . . . . . . . . . . . . . . . . 58 B. Remove the Shipping Materials . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 5
B. Limited Lifetime W arranty Hearth & Home Technologies Inc. LIMITED LIFETIME WARRANTY Hearth & Home Technologies Inc., on behalf of its hearth brands (”HHT”), extends the following warranty for HHT gas, wood, pellet, coal and electric hearth appliances that are purchased from an HHT authorized dealer. WARRANTY COVERAGE: HHT warrants to the original owner of the HHT appliance at the site of installation, and to any transferee taking ownership of the appliance at the site of installation with
Inhaltszusammenfassung zur Seite Nr. 6
B. Limited Lifetime W arranty (continued) WARRANTY CONDITIONS: • This warranty only covers HHT appliances that are purchased through an HHT authorized dealer or distributor. A list of HHT authorized dealers is available on the HHT branded websites. • This warranty is only valid while the HHT appliance remains at the site of original installation. • Contact your installing dealer for warranty service. If the installing dealer is unable to provide necessary parts, contact the nearest HHT author
Inhaltszusammenfassung zur Seite Nr. 7
L i s t i n g a n d C o d e A p p r o v a l s 1 A. Appliance Certification D. High Altitude Installations NOTICE: If the heating value of the gas has been reduced, MODELS: 6000CL-IPI, 6000CL-IPILP , these rules do not apply. Check with your local gas utility 8000CL-IPI, 8000CL-IPILP or authorities having jurisdiction. LABORATORY: Underwriters Laboratories, Inc. (UL) When installing above 2000 feet elevation: TYPE: Direct Vent Gas Appliance Heater • In the USA: Reduce input rate 4
Inhaltszusammenfassung zur Seite Nr. 8
Inspection N o t e : The following requirements reference various The state or local gas inspector of the side wall horizon- Massachusetts and national codes not contained in this tally vented gas fueled equipment shall not approve the document. installation unless, upon inspection, the inspector ob- serves carbon monoxide detectors and signage installed H. Requirements for the Commonwealth of in accordance with the provisions of 248 CMR 5.08(2)(a)1 Massachusetts through 4. For all
Inhaltszusammenfassung zur Seite Nr. 9
User Guide O p er a t i n g I n s t r u c t i o n s 2 • Keep remote controls out of reach of children. A. Gas Fireplace Safety • Never leave children alone near a hot fireplace, whether operating or cooling down. W ARNING • Teach children to NEVER touch the fireplace. HOT SURF ACES! Glass and other surfaces are hot during • Consider not using the fireplace when children will be operation AND cool down. present. Hot glass will cause burns. Contact your dealer for more information, or vis
Inhaltszusammenfassung zur Seite Nr. 10
CLEAR SPACE 3 FT. IN FRONT OF FIREPLACE C. Fan Kit (optional) F . Fixed Glass Assembly If desired, a fan kit may be added. Contact your dealer to See Section 14.I. order the correct fan kit. G. Remote Controls, W all Controls and W all D. Clear Space Switches WARNING! DO NOT place combustible objects in front Follow the instructions supplied with the control installed of the fireplace or block louvers. High temperatures may to operate your fireplace: start a fire. See Figure 2.2
Inhaltszusammenfassung zur Seite Nr. 11
H. IPI Battery T ray/Battery Installation TM The IntelliFire Plus system has a battery backup option. Battery longevity and performance will be affected by the service temperatures of this appliance. NOTICE: Batteries should only be used as a power source SELECTOR in the event of an emergency such as an outage. SWITCH I. Control Module Operation 1. The control module has an ON/OFF/REMOTE selector switch that must be set. See Figure 2.3. OFF Position: Appliance will ignor
Inhaltszusammenfassung zur Seite Nr. 12
K. Lighting Instructions (IPI) FOR YOUR S AFETY LIGHTING READ BEFORE LIGHTING INSTRUCTIONS (IPI) W A R N I N G : If you do not follow these instructions exactly, a fire or explosion 1. This appliance is equipped with an ignition may result causing property damage, personal injury or loss of life. device which automatically lights the burner. DO NOT try to light the burner by hand. A. This appliance is equipped with an • Immediately call your gas supplier from a neighbor’s phone. Follow
Inhaltszusammenfassung zur Seite Nr. 13
L. After Fireplace is Lit Initial Break-in Procedure • The fireplace should be run three to four hours continuously on high. • Turn the fireplace off and allow it to completely cool. • Remove fixed glass assembly. See Section 14.I. • Clean fixed glass assembly. See Section 3. • Replace the fixed glass assembly and run continuously on high an additional 12 hours. This cures the materials used to manufacture the fire- place. NOTICE! Open windows for air circulation during fire- place break-in.
Inhaltszusammenfassung zur Seite Nr. 14
M a i n t e n an c e an d S er v i c e 3 Doors, Surrounds, Fronts Any safety screen or guard removed for servicing must be replaced prior to operating the fireplace. Frequency: Annually By: Homeowner When properly maintained, your fireplace will give you many years of trouble-free service. We recommend an- T ools needed: Protective gloves, stable work surface nual service by a qualified service technician. • Assess condition of screen and replace as necessary. A. Maintenance T asks
Inhaltszusammenfassung zur Seite Nr. 15
B. Maintenance T asks-Qualified Service Burner Ignition and Operation T echnician Frequency: Annually The following tasks must be performed by a qualified ser- By: Qualified Service Technician vice technician. T ools needed: Protective gloves, vacuum cleaner, whisk Gasket Seal and Glass Assembly Inspection broom, flashlight, voltmeter, indexed drill bit set, and a manometer. Frequency: Annually • Verify burner is properly secured and aligned with pilot By: Qualified Service Technici
Inhaltszusammenfassung zur Seite Nr. 16
C. Refractory , Grate and V alve Assembly Removal It may become necessary to remove the refractory, grate and valve assemblies. This task should be performed by a qualified service technician. The refractory, grate and base refractory do not need to be removed to service the burner assembly. Note: Refractory is Fragile. Handle with care. Figure 3.3 Side Refractory Removal Note: The refractory must be removed before removing the grate. Figure 3.2 Side Refractory Removal To remove t
Inhaltszusammenfassung zur Seite Nr. 17
Note: The base refractory must be removed to access screws. BASE REFRACTORY Figure 3.6 V alve Assembly Removal D. Burner Identification/V erification The burner may be accessed for identification and veri- fication purposes. This task should be performed by a qualified service technician. The base refractory, valve plate, refractory panels and grate do not need to be re- moved to access the burner assembly. The logs and fi- ber burner top need to be removed to access the burner. Disconn
Inhaltszusammenfassung zur Seite Nr. 18
Installer Guide G e t t i n g S t a r t ed 4 A. T ypical Appliance System NOTICE: Illustrations and photos reflect typical installations and are for design purposes only. Illustrations/diagrams are not drawn to scale. Actual product may vary from pictures in manual HORIZONTAL TERMINATION CAP N o t e : Dual venting configurations (SECTION 10.L ) A R E N O T allowed. Appliance M U S T be vented E I T H E R vertically O R horizontally. VERTICAL TERMINATION CAP (SECTION 10.I) NON-CO
Inhaltszusammenfassung zur Seite Nr. 19
B. Design and Installation Considerations D. Inspect Appliance and Components Heat & Glo direct vent gas appliances are designed to • Carefully remove the appliance and components from operate with all combustion air siphoned from outside of the packaging. the building and all exhaust gases expelled to the outside. • The vent system components and decorative doors and No additional outside air source is required. fronts may be shipped in separate packages. Installation MUST comply with l
Inhaltszusammenfassung zur Seite Nr. 20
F r a m i n g a n d C l e a r an c e s 5 NOTICE: Illustrations reflect typical installations and are A. Selecting Appliance Location FOR DESIGN PURPOSES ONLY. Illustrations/diagrams When selecting a location for the appliance it is important to are not drawn to scale. Actual installation may vary due to consider the required clearances to walls (see Figure 5.1). individual design preference. WARNING! Risk of Fire or Burns! Provide adequate clearance around air openings and for service
