Inhaltszusammenfassung zur Seite Nr. 1
Owner’s Manual
Model
DF203A
IMPORTANT SAFETY INFORMATION: Always read this manual first
before attempting to install or use this fireplace. For your safety, always
comply with all warnings and safety instructions contained in this manual
to prevent personal injury or property damage.
7209520100R02
Inhaltszusammenfassung zur Seite Nr. 2
Table of Contents Welcome & Congratulations . . . . . . . . . . . . . . . . .3 ImPort Ant InstruCtIons . . . . . . . . . . . . . . .4 Fireplace Installation .......................7 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . .13 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15 replacement Parts . . . . . . . . . . . . . . . . . . . . . . . .17 Always use
Inhaltszusammenfassung zur Seite Nr. 3
Welcome & Congratulations thank you and congratulations for choosing to purchase an electric fireplace from Electalog, the world leader in electric fireplaces. Please carefully read and save these instructions. CAUTION: read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty. Please record your model and serial numbers below for future reference: mo
Inhaltszusammenfassung zur Seite Nr. 4
IMPORTANT INSTRUCTIONS for examination, electrical or ① read all instructions before mechanical adjustment, or repair. using this heater. ⑥ Do not use outdoors. ② This heater is hot when in use. t o avoid burns, do not let ⑦ This heater is not intended for bare skin touch hot surfaces. use in bathrooms, laundry areas The trim around the heater outlet and similar indoor locations. becomes hot during heater never locate this heater where operation. Keep combustible it may fal
Inhaltszusammenfassung zur Seite Nr. 5
IMPORTANT INSTRUCTIONS soft surfaces, like a bed, where fire. If you must use an extension openings may become blocked. cord, the cord must be no. 14 AWG minimum size and rated no ⑫All electrical heaters have less than 1875 Watts. hot and arcing or sparking parts inside. Do not use in areas where ⑮Do not burn wood or other gasoline, paint, or flammable materials in the Compact liquids are used or stored or Fireplace. where it will be exposed to ⑯Do not strike the front glass. flamma
Inhaltszusammenfassung zur Seite Nr. 6
IMPORTANT INSTRUCTIONS ! NOTE: This equipment • Consult the dealer or an has been tested and found to experienced radio/tV comply with the limits for Class B technician for help. digital device, pursuant to part 15 operation is subject to the of the FCC rules.these limits are following two conditions: (1) designed to provide reasonable this device may not cause protection against harmful interference and; (2) this device interference in a residential must accept any interference,
Inhaltszusammenfassung zur Seite Nr. 7
Fireplace Installation Unpacking Instructions Figure 2 the fireplace insert is packed with the front glass panel separated and uninstalled from the fireplace. Care must be taken to unpack the fireplace so as not to damage the front glass. 1. stand the packaged fireplace upright as indicated on the carton (Figure 1). 2. open the top of the carton Figure 3 and locate which side the glass is placed. 3. remove remote control and all plastic bags containing hardware etc. 4. Lay carton
Inhaltszusammenfassung zur Seite Nr. 8
Fireplace Installation ! NOTE: Although the wood into the corresponding glass frame can be discarded, the support track at the top of the screws and washers should be viewable fireplace. kept to attach the firebox to a 3. Place glass retaining brackets Dimplex mantel or surround (if as shown in Figure 5. the applicable). side of the bracket which lines up with the 2 supplied screws Fireplace Assembly should slide in between the The only assembly required is to edge of the glass
Inhaltszusammenfassung zur Seite Nr. 9
Fireplace Installation is preferred but not essential in WARNINg: Ensure the power all cases. A dedicated circuit will cord is not installed so that it is be required if, after installation, pinched or against a sharp edge the circuit breaker trips or fuse and ensure that the power cord is blows on a regular basis when the stored or secured to avoid tripping heater is operating. Additional or snagging to reduce the risk appliances on the same circuit of fire, electric shock o
Inhaltszusammenfassung zur Seite Nr. 10
Fireplace Installation Construction and electrical outlet Plug the unit into a 15 Amp/120 wiring must comply with local VAC outlet. If the cord does not building codes and other applica- reach, you may use a no. 14 ble regulations to reduce the risk AWG minimum size extension of fire, electric shock and injury cord rated for a minimum of 1875 to persons.Do not attempt to wire Watts. your own new outlets or circuits. Mantel Installation t o reduce the risk of fire, electric For use wi
Inhaltszusammenfassung zur Seite Nr. 11
Operation t o access the controls, swing position the heater operates if the down the front cover panel thermostat calls for heat. located on the lower front of the C. Heater Thermostat Control fireplace (refer to diagram below). To adjust the temperature to (Figure 8) your individual requirements, A. Main ON/OFF Switch turn the thermostat control the switch has two on positions clockwise all the way to turn on the heater. When the room marked with and “Manual”. reaches the desi
Inhaltszusammenfassung zur Seite Nr. 12
Operation and then place the Main on/ CAUTION: If you need to OFF Switch in the remote continuously reset the heater, Control position. unplug the unit and call technical support at 1-888-346-7539. 3. Within 10 seconds of changing the switch position, ! NOTE: The heater may emit press the on button located a slight, harmless odor when on the remote control first used. this odor is a normal transmitter (Figure 9). this condition caused by initial heating will synchronize the re
Inhaltszusammenfassung zur Seite Nr. 13
Operation the hand held transmitter (Figure 9). 2. Correctly install one 12 Volt (A23) battery in the battery holder. 3. Close the battery cover. Maintenance to open the unit to replace light WARNINg: Disconnect bulbs. power before attempting any maintenance or cleaning to Bulb Requirements reduce the risk of fire, electric Quantity of 2 clear chandelier or shock or damage to persons. candelabra bulbs with an J-12 (small) socket base, 60 watt Light Bulb Replacement rating. Exam
Inhaltszusammenfassung zur Seite Nr. 14
Maintenance 6. Insert new bulb(s). Compact Fireplace 7. Install the light access cover Surface Cleaning and install the screws. use warm water only to clean painted surfaces of the Compact glass Cleaning Fireplace. Do not use abrasive the glass is cleaned in the factory cleaners. during the assembly operation. During shipment, installation, Servicing handling, etc., the front glass panel may collect dust particles; Except for light bulb replacement these can be removed by dusting
Inhaltszusammenfassung zur Seite Nr. 15
Warranty such products to be free from defects in One Year Limited Warranty material and workmanship for a period Products to which this limited warranty of 12 months from the date of the first applies purchase of such product. This limited warranty applies to your newly The limited 12 month warranty period purchased Electralog electric compact also applies to any implied warranties that fireplace. t his limited warranty applies may exist under applicable law. some only to purchas
Inhaltszusammenfassung zur Seite Nr. 16
Warranty • Electralog will in its sole discretion In no EVEnt WILL ELECtrALoG, either repair or replace such or Its DIrECtors, oFFICErs, defective product or part without or AGEnts, BE LIABLE to tHE charge. If Electralog is unable to PurCHAsEr or AnY tHIrD PArtY , repair or replace such product or WHEt HEr In Contr ACt , In tort , part, or if repair or replacement is or on An Y ot HEr BAs Is , For not commercially practicable or AnY InDIrECt , sPECIAL, PunItIVE, cannot be timely made,
Inhaltszusammenfassung zur Seite Nr. 17
Replacement Parts Log Set Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0487550100RP Flicker motor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2000220100RP Heater Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2200490800RP Thermostat . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2300150100RP Cutout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2300270100RP 3 Position on/off switch . . . . .
