Bedienungsanleitung Manitowoc Ice Q-0420

Inhaltszusammenfassung zur Seite Nr. 1

22” Q-Model Ice Machine Insulation
Installation Instructions
Material List Q-0320/Q-0420 Ice Machines

Quantity
1 Armaflex Insulation 6’ x 2” ID x 3/8” wall thickness
1 Armaflex Insulation 6’ x 3/4” ID x 3/8” wall
(used on evaporator inlet/outlet and dump valve drain line)
1 Bulkhead Insulation Back 9” x 21 1/2” x 3/4”
1 Bulkhead Insulation Back 3” x 21 1/2” x 3/8”
2 Side Wall Insulation 9” x 10” x 3/8”
1 Vacu

Inhaltszusammenfassung zur Seite Nr. 2

5. Place two beads of black silicone sealant (1” in from the edge) on the front and both sides of the vacuum-formed base. 6. Remove wood blocks and lower the ice machine onto the vacuum-formed base (check side and back alignment). Push the center of the vacuum-formed base tight to the ice machine base. Secure the vacuum-formed base to the ice machine water trough with tape. Remove tape after silicone sealant has set. 7. Seal the front edge of the base insulation to the bin with white sil

Inhaltszusammenfassung zur Seite Nr. 3

9. Install additional insulation on entire suction line 4. Apply bead of silicone before applying insulation 5. Align insulation slits with base ribbing 7. Seal insulation to base with silicone sealant 10. Insulate drain line 7. Use black silicone sealant to seal insulation to the base, foam insulation to foam insulation joints, and any voids where insulation meets or overlaps. Add bulkhead corner insulation covers where the rear bulkhead and side panel corners meet. 8. Verify no mo