Bedienungsanleitung Haier Little Sea-ox FCD-JTHC80A-III (E), FCD-JTHC100A-III(E)

Inhaltszusammenfassung zur Seite Nr. 1

Little Sea-ox
Haier Household Electric Water Heater
User's Manual
Group
Qingdao Economic and Technological Development District
Haier Water Heater Co.,Ltd.
Please read this manual before usage
Retain it for future reference

Inhaltszusammenfassung zur Seite Nr. 2

Friendly Hints Pre-safe expert 1. If water supply cutoff occurs in your home, please disconnect the power. Before This mark is the designation for Pre-Safe Expert of Haier connecting power again, please open mixing valve to the mostest pitch of the hot water, Water Heater Company, which indicates use of the company's watch the showerhead until water comes out (indicating tank is full) and close mixing patented technology inside the product. It ensures you a safe valve. This can ensure a lon

Inhaltszusammenfassung zur Seite Nr. 3

Cleaning and Maintenance Before Usage Dear User, Internal Cleaning: To ensure high working efficiency, heating elements and tank liner Thanks for choosing Haier water heater product. of water heater shall be cleaned once in three years. Take care not to damage Haier products have good quality and excellent performance.To facilitate you to use the protection layer on heating elements and tank liner inner surface. According to product, please read the manual and operate accordingly.Pleas

Inhaltszusammenfassung zur Seite Nr. 4

Dimensions Operation Instructions For the first use after installation, due to there's no water within the tank, first the city (Fig. 1) water inlet valve and mixing valve must be opened. Close the mixing valve when water flows out continuously from the showerhead or other outlets (the tank is full). Check Front View Bottom View Cutaway View connections are free of water leakage, and insert the power plug. a1 d1 Turn the knob to set your desired water heating temperature, which can be steples

Inhaltszusammenfassung zur Seite Nr. 5

Installation Safety Precautions Connection and Use of Safety Valve: After switching on the water heater, a little water will drip from the safety valve pressure relief vent due to normal expansion. The vent shall always keep open to the air. Avoid being blocked. Connect one end of the hose to the safety valve vent and the other end to the sewage The water heater shall use a.c. 220 V / 50 drain. The hose can be cut short or extended as necessary. To avoid splash, the hose Hz power supply fro

Inhaltszusammenfassung zur Seite Nr. 6

Setting Environment Installation Installation must be made by installers of or designated by our company after-service department. The water heater shall be wall-mounted. Before installation, make sure water heater rear wires are fit firmly. Determine an installation location. Make four holes 12mm, 65 mm deep in the wall. Insert and fix expansion hooks and expansion bolts in corresponding wall holes. Lift the water heater. Insert wall rack onto the hooks and bolts. Fit flat washers, rear wires