Inhaltszusammenfassung zur Seite Nr. 1
User’s Guide
Mobile Phone
R310s
Inhaltszusammenfassung zur Seite Nr. 2
Contents Preparing Your Phone for Use 3 Turning Your Phone On and Off 11 Display Information and Key Functions 13 Making and Receiving Calls 16 During a Call 19 Using the Menus 21 Your Personal Phone Book 29 Using the Call List 39 Your Voice Mail Service 42 Personalizing Your Phone 44 Text Messages (SMS) 53 Diverting Incoming Calls 65 Security for Your Phone and Subscription 68 Handling More than One Call Simultaneously 78 Setting Network Preferences 84 Knowing the Call Time/Call Cost 88 Using T
Inhaltszusammenfassung zur Seite Nr. 3
Please note! Some of the services in this manual are not supported by all net- works. This also applies to the GSM International Emergency Number 112. Please contact your network operator or service provider if you are in doubt whether you can use a particular service or not. Note! You should read the Guidelines for Safe and Efficient Use and the Warranty chapters before using your mobile phone. The symbol on our products signifies that they have been certified according to the EMC directive
Inhaltszusammenfassung zur Seite Nr. 4
Preparing Your Phone for Use Front Antenna Indicator light Earpiece Volume keys Display Power On/Off Keypad Microphone Wash the phone gently in cold water under a water tap. Do not immerse the phone in water. 3 Not for Commercial Use Ericsson Mobile Communications AB
Inhaltszusammenfassung zur Seite Nr. 5
Back Hook for clip Back cover lid Rubber plug (to Security screws protect system connector) Assembly You need to do the following to use your phone: insert the SIM card attach the battery to the phone charge the battery The SIM Card When you register as a subscriber with a network operator, you get a SIM (Subscriber Identity Module) card. The SIM card contains a computer chip that keeps track of your phone number, the services included in your subscription, and your Phone Book inform
Inhaltszusammenfassung zur Seite Nr. 6
Inserting the SIM Card Before you can insert the SIM card you need to remove the back cover and the battery. 1. Release the back cover by screwing the secu- rity screws anti-clock- wise. Remove the cover from the phone. 2. Remove the battery by pulling the upper rub- ber pull-tab, as shown in the picture. 3. Release the SIM card holder by sliding it in the direction of the arrow. 4. Open the SIM card holder. 5 Not for Commercial Use Ericsson Mobile Communications AB
Inhaltszusammenfassung zur Seite Nr. 7
5. Slide the SIM card into the holder. Make certain that the cut cor- ner is in the top right- hand corner. 6. Lock the holder by pressing it down and sliding it in the direc- tion of the arrow in the picture. 7. Place the battery against the phone and press the battery against the phone until it is properly attached. 8. Attach the back cover to the phone by screw- ing the security screws clockwise. 6 Not for Commercial Use Ericsson Mobile Communications AB
Inhaltszusammenfassung zur Seite Nr. 8
The PIN Most SIM cards are supplied with a security code, also known as PIN (Personal Identity Number), which you need to access the network. Every time you turn on your phone, you are asked to enter your PIN. You will find your PIN in the information from your operator. Some operators may have services that require a second PIN, your PIN2. You should be careful with your PIN, since it is your pro- tection against unauthorized use of your subscription. The Battery Your phone comes with a li
Inhaltszusammenfassung zur Seite Nr. 9
tery you use and your position in the network. Please note that these times are approximate and you may have 20% less time than is shown in the display. Note! The phone turns itself off when the battery can no longer power it satisfactorily. Charging the Battery 1. Make sure that the bat- 3. Connect the charger to tery and the back the mains. cover are attached to 4. Connect the other end the phone. of the cable to the 2. Open the rubber plug phone as shown in the protector that covers pi
Inhaltszusammenfassung zur Seite Nr. 10
while until you get an indication of charging in the dis- play. An Ericsson-approved battery is indicated by Ericsson Opti- mized Charging each time you start charging the battery. For the best charging, talk and standby times in the long run, we recommend that you use only Ericsson-approved batter- ies with your phone. Batteries that are not Ericsson-approved are charged slowly for safety reasons. These are indicated by the message ‘Alien battery - Slow charging only’ in the display during
Inhaltszusammenfassung zur Seite Nr. 11
Washing the phone Wash the phone gently in cold water under a water tap. Do not immerse the phone in water! Note! If water gets behind the back cover, or inside the rubber plug, open the cover or plug and shake the water out. This is not a problem, as the battery protects the inside of the phone, and the system connector is water- proof. 10 Not for Commercial Use Ericsson Mobile Communications AB
Inhaltszusammenfassung zur Seite Nr. 12
Turning Your Phone On and Off Turning your Phone on Press and hold the NO key until you hear a tone. If “PIN:” Appears in the Display Some SIM cards are protected with a PIN code. If PIN: appears in the display after you have turned on the phone: 1. Enter your PIN. If you make a mistake while entering your PIN, erase the wrong number by pressing the C key. 2. Press YES. Note! If your PIN is entered incorrectly three times in a row, the SIM card is blocked. You can unblock it by using yo
Inhaltszusammenfassung zur Seite Nr. 13
Initial Settings The first time you turn on your phone, you may want to choose the ring signal type and set the clock and date. For more information about these and other settings, see “Per- sonalizing Your Phone” on page 44. Display Language Most modern SIM cards automatically set the display lan- guage to the language of the country where you bought your SIM card, (Automatic). If this is not the case, the preset language is English. To change the display language, see “Display Language” o
Inhaltszusammenfassung zur Seite Nr. 14
Display Information and Key Functions In standby mode, the display shows the name of your oper- ator, the time, the signal strength and the battery power. Other icons appear if you receive any messages, divert all your incoming calls, set the alarm clock and so on. In this chapter, you will also learn about the key functions. Display Information The table below shows and explains each icon which may appear in standby. Icon Name Explanation Signal strength meter Tells you the strength of the
Inhaltszusammenfassung zur Seite Nr. 15
Silent indicator All audible signals are turned off, except the alarm and timer. SMS indicator You have received a text message. Voice mail indicator You have received a voice message, depending on your subscription. Line 1 indicator Line 1 is in use for outgo- ing calls – if you subscribe to the Two Line Service Line 2 indicator Line 2 is in use – if you subscribe to the Two Line Service. Ciphering indicator Ciphering is currently not being provided by the network. Home zone indicator
Inhaltszusammenfassung zur Seite Nr. 16
Key: Use: To enter the menu system. uuuu and dddd To move (scroll) through menus, lists and text. To erase numbers and letters from the dis- C (Clear) play. To mute the microphone during a call, press and hold down the key. To set the phone silent, press and hold the key from standby. To delete an item from a list. Number keys To enter the digits 0-9. The 0 key enters the international prefix (+) if held down. To call your Voice Mail, press and hold the 1 key. To enter the phone book, pres
Inhaltszusammenfassung zur Seite Nr. 17
Making and Receiving Calls In this chapter, we assume that you have turned on your phone and that you are within range of a network. If you are abroad, you may use other networks, provided your home network has an agreement that allows you to do this. See “Setting Network Preferences” on page 84. Making a Call 1. Enter the area code and the phone number. 2. Press YES. Note! Some countries may not use area codes. While a call is in progress, a time counter automatically starts and you can
Inhaltszusammenfassung zur Seite Nr. 18
For more information, see “Using the Call List” on page 39. Automatic Re-Dialling If the connection failed when you first User busy called and the display shows Retry?, you Retry? can re-dial the number by pressing YES. Your phone automatically re-dials (up to 10 times) until the call is answered. When the call is successfully connected, you hear a ring signal. until you press a key or receive a call. Note! You do not need to take the phone to your ear until you hear the ring signal. Au
Inhaltszusammenfassung zur Seite Nr. 19
Receiving a Call When you receive a call, the phone rings Answer? and the display shows Answer? If your subscription includes the Calling Line Identification (CLI) service and the caller’s network sends the number, you see the caller’s number in the dis- play. If the caller’s number and name are stored in the phone book, the caller’s name is also shown. If the incoming call is a restricted number, the display shows Withheld. If the incoming call is a number without any CLI service, Unknown
Inhaltszusammenfassung zur Seite Nr. 20
During a Call Your phone has several functions, which you might find helpful while a call is in progress. Changing the Listening Volume You can easily change the listening volume during a call by pressing any of the volume keys on the side of the phone. To change the listening volume during a call Press UP to increase the volume. Press DOWN to decrease the volume. Muting the Microphone If you wish, you may turn the microphone off during a call. To turn the microphone off temporarily during
