Inhaltszusammenfassung zur Seite Nr. 1
Owner’s
Manual
Ceiling Fan Installation Instructions
Total fan
weight
For 5RDR Series Fans
BLADES NOT INCLUDED
READ AND SAVE THESE INSTRUCTIONS
Quality Ceiling fans
Inhaltszusammenfassung zur Seite Nr. 2
Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70- 1999), including fire-rated construction. 2. Use this unit only in the manner intended by the manufacurer. If you have any questions contact the manufacturer. 3. After making the wire connections,
Inhaltszusammenfassung zur Seite Nr. 3
7 9 8 Lower upper glass disk onto fan housing and Secure mounting neck to the mounting plate Lift mounting neck to mounting Plate and align with 6 screws to become a complete mounting align 3 holes in glass with 3 holes in fan hous- screws. ing. bracket. 10 11 12 Remove pin from downrod and save for later step 14. Push the yoke Pull lead wires and safety cable out Install 3 screws to hold glass to fan cover onto downrod. Thread lead from the yoke about 3”. housing. Do not overtighten as this w
Inhaltszusammenfassung zur Seite Nr. 4
21 19 20 Tighen all 6 screws for arch arms Install arch mount by using screw Align holes in arch arm and slot for and nut removed in step 16. Place securely. tab with holes and tab on fan body. screw through tab and tighten nut Start all screws in the arch arm and screw securely. brackets. 22 24 23 Plug in electrical connections there Push the yoke cover down into Tighen the 3 screws holding the arch are 2 double plugs from arch assem- place. arms securely. bly one for the fan and one for the up
Inhaltszusammenfassung zur Seite Nr. 5
33 31 32 Canadian mounting only House Fan Safety Cable white white black black orange blue Green Lag Screw Make wiring connections as indicated above. White from fan to white from remote marked Make wire connections to power source using N. Orange from fan to Orange from remote wire nuts provided. Make sure that no filiments marked Light/up. Blue from fan to blue from For Canadian installation in both flush and are outside of the wirenut. After making the remote marked down light. Black from f
Inhaltszusammenfassung zur Seite Nr. 6
43 44 Light dim- Fan speed mer for up control but- and down tons lights Fan reverse Fan on / off button To control fan speed select from High, Medium or low speed buttons. To turn the fan off press the Fan on / off button. To dim upper lights press and hold U/L botton. To dim Lower lights Attach front cover to wall control press and hold D/L button. To turn off either with screws provided. up or down light press and quickly release either U/L or D/L button. Press button marked REV to revers
Inhaltszusammenfassung zur Seite Nr. 7
Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning: Before servicing or cleanin
