Inhaltszusammenfassung zur Seite Nr. 1
Owner’s
Manual
Ceiling Fan Installation Instructions
Total fan weigh
with light
For 5OBR52 Series Fans
READ AND SAVE THESE INSTRUCTIONS
Quality Ceiling fans
Inhaltszusammenfassung zur Seite Nr. 2
Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70- 1996), including fire-rated construction. 2. Use this unit only in the manner intended by the manufacurer. If you have any questions contact the manufacturer. 3. After making the wire connections,
Inhaltszusammenfassung zur Seite Nr. 3
7 9 8 Align hole in downrod with hole in Install keeper into cross pin. Install downrod into yoke. yoke and install cross pin. 10 12 11 Remote Transmitter Dip swtiches Remote Receiver Dip switches Set dip switches on the Remote Transmitter and Remote Receiver to the same settings. This must be done so the Raise fan with downrod assembled to units will communcate properly. If you have other fans you the ceiling bracket and hang fan can set to control from one transmitter by setting both Tighten
Inhaltszusammenfassung zur Seite Nr. 4
19 20 21 Take plate with glass and place over the 2 screws and twist to hold in Place floating brackets onto blades Tighten all 3 screws securely. place. Replace screw removed. aligning holes in blade with the float- ing bracket. 22 23 24 Check the motor for plastic shipping sta- bilizer tabs and remove if they are pres- Loosen 2 screws and remove 1 Attach blade arms to blades using ent. The screws, washers and motor pads screw to allow bottom fan plate to are pre-installed to the blade holders.
Inhaltszusammenfassung zur Seite Nr. 5
31 32 33 Place light kit over screws and twist light kit with key hole slots into Install the 100 watt halogen bulb. Attach glass by locating dimples in place. Replace screw removed and Do not touch bulb surface as oily light kit with the groves in glass and then tighten all 3 screws securely. residue from skin can cause the bulb twisting clockwise till tight. to explode. 36 34 35 Install wall control unit to outlet box Attach cover of remote by placing Remove cover by snaping off from using m
Inhaltszusammenfassung zur Seite Nr. 6
Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning: Before servicing or cleanin
Inhaltszusammenfassung zur Seite Nr. 7
9/21/04 REV.0 New made from 5AHR manual
