Inhaltszusammenfassung zur Seite Nr. 1
Owner’s
Manual
Ceiling Fan Installation Instructions
Total fan weigh
with light
For 5LNR52XXD Series Fans
READ AND SAVE THESE INSTRUCTIONS
Quality Ceiling fans
Inhaltszusammenfassung zur Seite Nr. 2
Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70- 1999), including fire-rated construction. 2. Use this unit only in the manner intended by the manufacurer. If you have any questions contact the manufacturer. 3. After making the wire connections,
Inhaltszusammenfassung zur Seite Nr. 3
7 8 9 Remove upper motor housing. Replace upper motor housing. Place blades in the side slots of the motor. Line up the 3 holes and install washers and screws securely. 10 11 12 Slide canopy and yoke cover onto the Align the 6 holes on the yoke and Align hole in downrod with hole in downrod. Thread the leadwires and replace with the screws saved from yoke and install cross pin. Install safety cable through the downrod as earlier step. Tighten securely. downrod into yoke. Install keeper shown. i
Inhaltszusammenfassung zur Seite Nr. 4
21 19 20 Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread Loosen 2 screws and remove 1 Raise canopy to the mounting bracket apart with the grounded conductor and the screw. Save screw removed. and twist to lock into place. Tighten 2 equipment-grounding conductor on one side of screws securely. the outlet box and ungrounded conductor on the other side of the outle
Inhaltszusammenfassung zur Seite Nr. 5
31 HAND HELD INSTALL 32 Place face plate over battery compartment and Remove cover by snaping off from top or bot- buttons. Place remote over 2 pins on front tom. Remove battery cover. Install 12V battery cover. Attach cover of remote by placing over 4 into wall remote. Duracell MN21 / Eveready A23 pins and snaping into place. / GP 23A all 12V. 33 WALL MOUNT INSTALL 34 Attach front cover to wall control with screws provided. Snap battery Install wall control unit to outlet box cover in place. u
Inhaltszusammenfassung zur Seite Nr. 6
Remote Control Transmitter Features: LED LIGHT MEDIUM SPEED HIGH SPEED LOW SPEED FAN OFF SETTING LIGHT ON/OFF SET- (Turns fan off only) TING AND DIMMER (Press and hold to dim light infinitively) FAN SPEED Depress “l dot” for low speed, “2 dots” for medium or “3 dots” for high. To turn fan off press square”. LIGHT DIMMER To turn light on, press light dimmer once quickly. To turn off press once quickly while light is on. To dim light hold down button “light dimmer”. The light will cycle from brig
Inhaltszusammenfassung zur Seite Nr. 7
Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning: Before servicing or cleanin
Inhaltszusammenfassung zur Seite Nr. 8
6/21/06 REV.0 New made from 5GMR manual
