Bedienungsanleitung Dimplex CUH05B31T

Inhaltszusammenfassung zur Seite Nr. 1

PRACTICAL USER’S GUIDE
FOR THE
DIMPLEX COMPACT UNIT HEATER
MODEL: CUH05B31T
7208960100R00

Inhaltszusammenfassung zur Seite Nr. 2

QUICK REFERENCE GUIDE 1. Prior to the fi rst use of the heater verify the circuit breakers for the heater are on. 2. The heater may emit a slight, harmless odor when fi rst used. This odor is a normal condition caused by the initial heating of internal heater parts and will not occur again. 3. If you have any technical questions, questions regarding the operation of your heater, or require service for your heater contact Dimplex North America customer service at 1-888-DIMPLEX

Inhaltszusammenfassung zur Seite Nr. 3

IMPORTANT INSTRUCTIONS PLEASE RETAIN THIS USER’S GUIDE FOR FUTURE REFERENCE When using electrical appliances, basic precautions should always be followed to reduce the risk of fi re, electric shock, and injury to persons, including the following: 1. Read all instructions before using this heater. 2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3

Inhaltszusammenfassung zur Seite Nr. 4

HEATER LOCATION AND CLEARANCES The heater is to be installed in a fi xed location. The discharge air should wipe the walls without blowing directly on them. (FIGURE 1) Ensure the air discharge is parallel to or away from walls. NOTE: To prevent personal injury always use a licensed electrician to install new outlets or circuits. CAUTION: When turning and/or tilting the heater do not block the exhaust opening. INSTALLATION WALL/CEILING HANGER BRACKET (FIGURE 2) NOTE: To prevent personal injury

Inhaltszusammenfassung zur Seite Nr. 5

The following steps are shown in FIGURE 3: 1. Locate a stud or other suitable support and install hanger bracket on wall or ceiling. Select location so control knob on back of heater will be reached easily. * 2. Insert carriage bolt into square opening of heater handle. 3. Slide spacer over the carriage bolt shaft and insert in hanger bracket opening and hold them in position. 4. Slide lock washer and thread on nut onto carriage bolt, turn and tighten with wrench. * DO NOT INST

Inhaltszusammenfassung zur Seite Nr. 6

LOW HI Thermostat Control Knob FIGURE 4 MAINTENANCE AND CLEANING WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fi re, electric shock or damage to persons. Allow at least 30 minutes for the heater to cool before attempting any maintenance or cleaning. To clean the exterior surface, use a solution of water and mild detergent, apply with damp sponge. Wipe dry with a dry cloth. DO NOT re-energize unit until it has dried thoroughly. WARRANTY Dimple