Bedienungsanleitung ritetemp 8030C

Inhaltszusammenfassung zur Seite Nr. 1

Operation 8030C
Calibration
NOTE: Your thermostat comes from the factory calibrated to + or - 1oF actual
temperature. It is an accurate instrument. If you want your thermostat to display
the same temperature as another thermometer in your home, you can adjust its
calibration.
To change the calibration:
The unit must be in the HEAT or COOL mode.
Press the MENU button.
Press the Temp Up/Temp Down arrows to adjust the temperature reading.
CALIBRATE DISPLAY ON will appear.
Press HOME to sa

Inhaltszusammenfassung zur Seite Nr. 2

Operation 8030C Using a TOUCH SCREEN Time Touch Screen Time Slot Please take a moment to try out of day Menu Day button your touch screen itself. Program To select a function on the button touch screen, place your finger Current on the main temp display and Room Temperature give a short firm push. Try a "tap" of the finger or stylus. Your input Reset must last long enough for the button system to determine it is not an Target Temperature accidental 'bump'. Using

Inhaltszusammenfassung zur Seite Nr. 3

MENU screen Displayed when the MENU button is pressed from the HOME screen. 3 Set oC -oF Lock Program Return 1 Set Day Touch this to Touch for 5 sec HOME Touch this area to set set temperature to lock or unlock the day of the week. display. 2 Set Time Touch this area to set the time of day. Left arrow goes back, right arrow goes forward. -T FACTOR Temperature Swing CALIBRATE DISPLAY set Filter Timer set Calibration indicator Calibration This comes on if you Use this to calibrate your LC

Inhaltszusammenfassung zur Seite Nr. 4

1 Configure Press MENU to configure the thermostat (from HOME screen). Set day of the week - Touch the Day of the week area to cycle through the days of the week to select the current day. Set time of day - Touch the Time of Day arrows to move the time selection forward or backward until it displays the Backward Forward current time. Touch and hold for faster setting. Set oC -oF display Touch the oF and it will toggle to oC. Set audible chirp - Touch the the musical note icon to sele

Inhaltszusammenfassung zur Seite Nr. 5

3 Program NOTE: 60 Second Rule-During programming, if a button is not pushed in 60 seconds, the unit will return to the home screen. Everything you have changed while programming will automatically be saved. Press PROGRAM to go to the programming screen. Select HEAT with the HEAT/Cool MODE switch. Select the day you want to program- Touch the Day of the week area to cycle through the days of the week to select the desired day. Select the time slot you want to program - Touch the Time

Inhaltszusammenfassung zur Seite Nr. 6

Manual The 8030C has 3 manual override commands. These are accessed by touching the Current Temp Display at the HOME screen (center of screen). Target Temperature Return HOME HOLD Touch this area to set a comfortable target temp for the system to hold until you return and remove HOLD. TEMPORARY Manual Override indicator Temp Up / Temp Down arrows Shows you have temporarily Touch these to raise and lower modified the Target Temp. the manual override Target Temp. PG 9 MANUAL Temporary Overr

Inhaltszusammenfassung zur Seite Nr. 7

4 Special Features Swing Swing setting determines the temperature difference from ON to OFF that the thermostat will command the HVAC system to run. With the MODE switch in HEAT or COOL, press the MENU button. Touch the SWING icon and the current setting of temp swing is shown on the display (default at 3 ). To change the swing, touch the left or right arrows. The furnace will cycle more at the lower numbers as it tries to keep your set point constant. Filter The 8030C has a feature