Bedienungsanleitung Aube Technologies TH150 Series

Inhaltszusammenfassung zur Seite Nr. 1

TH150 Series
Installation and User Guide
VAV Thermostat
1. Introduction
The TH150 Series electronic thermostat is designed for low-voltage
pressure-dependent variable air volume (VAV) applications. It
comes in four different models:
• TH150-1A • TH150-1F
Configuration and status display
• TH150-1A2T • TH150-1F2T
Depending on the model, the TH150 thermostat can have up to
three outputs connected to the following control devices:
Heating mode
actuators
Cooling mode
thermal valves (N.O. and N.C.)

Inhaltszusammenfassung zur Seite Nr. 2

3. Typical Applications FIGURE 1: Damper control with electric reheat and auxiliary FIGURE 2: Damper control with electric reheat and auxiliary baseboard heating. hot-water heating FIGURE 3: Damper control with automatic changeover, elec- FIGURE 4: Temperature control of fresh air supply tric reheat and central cooling CAUTION CAUTION Do not connect com- Do not connect mon to ground common to ground FIGURE 5: Changeover and NSB inputs sharing the same FIGURE 6: Changeover and NSB inputs using d

Inhaltszusammenfassung zur Seite Nr. 3

4. Configuration Remove the thermostat from its base and 4.1 Configuration Menus set the SW2 switch to MENU. Reinstall the thermostat. The thermostat is 1A model now in configuration mode. The first digit flashes to indicate that the first item of the menu can now be modified. Default mode & Output 1 Maximum Minimum Application NSB value Output 1 type min. opening setpoint setpoint (section 4.2) (section 5.6) To modify the setting, use the up/down (section 4.3.1) (section 4.3.2) (sect

Inhaltszusammenfassung zur Seite Nr. 4

The following table shows the different default modes, the different 4.2 Application Types output types for Output 1, and their corresponding settings in the The following table shows the different thermostat applications and configuration menu. their corresponding settings in the configuration menu. Menu setting 1A & 1A2T models 1F & 1F2T models Menu setting Description Cool / 0-10 V analog Cool 0 Internal To control the ambient temperature using the internal (max. of 10 min. refresh) (24 V t

Inhaltszusammenfassung zur Seite Nr. 5

4.5 Output 3 (models TH150-1A2T and TH150-1F2T) 4.7 DIP Switches The following table shows the output types for Output 3 and their Three switches at the back of the control module are used to select corresponding settings in the configuration menu. various options. Temperature Display (SW1) Menu setting Description Selects the desired temperature display (°C or °F). 0 Not used Access Mode (SW2) 24 VAC pulsed (triac) / 1 sec. cycle 1 Selects the operation mode (NORM) or the configuration mode (e

Inhaltszusammenfassung zur Seite Nr. 6

5.5 Mode Changeover 6. Technical Specifications The thermostat can switch between heat mode and cool mode Power: 24 VAC either via: Current consumption: 25 mA • the automatic changeover Output signals: Depends on output configurations • the changeover input Output ratings: - Triac output: 0.5 A maximum @ 24 VAC 5.5.1 Automatic changeover - Analog output (SCR connection): 0 - 10 V, 10 kW minimum In automatic changeover, the thermostat detects when the system - Analog output (SSR connection): 0 -