Inhaltszusammenfassung zur Seite Nr. 1
Window (Room) Air Conditioner
User Manual
RWC-3217
RWC-4717
S SW WIIN NG G
F
HR
FAN
SPEED
TIMER ON/OFF MODE
Thank you very much for purchasing Air Conditioner.
Before installing and using this appliance, please read this User
Manual carefully, and keep it for future reference.
Inhaltszusammenfassung zur Seite Nr. 2
CONTENTS Safety Precautions 2 3 Parts Name Operating Instructions 5 Care and Maintenance 8 Operation Tips 9 10 Trouble Shooting 11 Installation Instructions 1
Inhaltszusammenfassung zur Seite Nr. 3
HRHRFF FF HRHR ONOFF ONOFF HRHRFF ONOFF HRHRFF ONOFF FF HRHR ON/OFF / / / / Safety Precautions Symbols in this User's Manual are interpreted as shown below: Be sure not to do. Be sure to follow the instruction. The feature of the appliance, Grounding is necessary. instead of a fault. Warning: Incorrect handling could Pay attention to such a situation. cause a serious hazard, such as death, serious injury,etc. Use correct power supply according to the Do not use the power supply circuit Kee
Inhaltszusammenfassung zur Seite Nr. 4
FAN SPEED S SW WI IN NG G T IM ER MODE FF HRHR ON/OFF Parts Name Front view For remote control model Exterior Air Inlet Air Outlet Vertical Air Vane Horizontal Air Vane Exterior Air Inlet ÅÅË®×ì Power Cord Interior Fresh air lever Control Panel Remote Controller Air Inlet Grille Fig. 1 Note: The figure in this manual are based on the external view of a standard model. Consequently, the shape may differ from that of the air conditioner you have selected. 3
Inhaltszusammenfassung zur Seite Nr. 5
FAN SPEED S SW WI IN NG G T IM ER MODE / FF HRHR ONOFF Parts Name 1.Accessories Back view Outside Air Outlet Drainage Tip ÅÅË®×ì Exterior Air Inlet Fresh air lever Air Filter handle Fresh air lever Fresh air lever Shut the fresh air door to achieve the best cooling effect and open it to introduce fresh air into the room if the air is foul inside . Push in SHUT OPEN Pull out Fig.1 Fig.2 4
Inhaltszusammenfassung zur Seite Nr. 6
CC Operating Instructions Remote Control Model You can easily operate this air conditioner by pressing relevant button on the control panel as well as the remote controller. Control Panel ON/OFF button The air conditioner will be started when it is energized or will be stopped when it is in operation, if you press this button. S SW WIIN NG G MODE button Each time MODE button is pressed, the operation F mode is changed in sequence: HR FAN COOLING FAN ONLY ENERGY SAVING COOLING SPEED NOTE:
Inhaltszusammenfassung zur Seite Nr. 7
Operating Instructions Remote Controller The remote controller transmits signals to the system. POWER Buttom 1 10 The appliance will start when it is energized or will stop when it is in operation, if you press this button. 1 8 Power Timer MODE Buttom 2 2 9 Used to select the operation mode. Mode Swing Power Saver Buttoms 7 5 3 Mid Auto Used to set room temperature in COOLING Fan Speed 6 4 mode or used to set time in TI MER mode. High Low _ + 3 HIGH Buttom 4
Inhaltszusammenfassung zur Seite Nr. 8
A SPEE F N D / FF HRHR ONOFF S SW WI IN NG G T IM ER MO DE Operating Instructions Remote control How to Insert the Batteries Remove the battery cover according to the arrow direction. Insert new batteries making sure that the (+) and (-) of battery are matched correctly. Reattach the cover by sliding it back into position. Note: Use 2 LR6 AA(1.5volt) batteries. Do not use rechargeable batteries. Re- place batteries with new ones of the same type when the display beco- mes dimor effectiv
Inhaltszusammenfassung zur Seite Nr. 9
HRHR ONOFF FF / Care and Maintenance Front panel maintenance Air filter maintenance Unplug from power source Stop operation and take out air filter. Take out air filter as shown Unplug from power source after switch off the air conditioner. S SW WIIN NG G FAN SPEED TIMER MODE Wipe with a soft and dry cloth Use lukewarm water (below 40 C) to clean Clean and reinstall the air filter. if the air conditioner Use a dry and is very dirty. soft cloth to clean it. If the dirt is conspicuous, w
Inhaltszusammenfassung zur Seite Nr. 10
Operation Tips Operating condition Noise pollution The protective device maybe trip and stop The noise level of air conditioner sounds the appliance in the cases listed below. higher at night than in the daytime. o Outdoor air temperature is over *43 c COOLING o Room temperature is below 18 c Please set (LOW FAN SPEED) or (FAN ONLY) mode at night in order *For Tropical (T3) Climate condition models, the to decrease noise. temperature point is 52 instead of 43 . If the air conditioner ru
Inhaltszusammenfassung zur Seite Nr. 11
FF HRHR ONOFF HRHRFF ONOFF FF HRHR ONOFF HRHRFF ONOFF FF HRHR ON/OFF / / / / Trouble Shooting 1.Accessories The following cases may not always be a malfunction, please check it before asking for service. Analysis Trouble If the protector trip or fuse is blown. Does not run Please wait for 3 minutes and start again, protector device may be preventing unit to work. . If batteries in the remote controller exhausted. If the plug is not properly plugged. Is the air filter dirty? Are the intakes an
Inhaltszusammenfassung zur Seite Nr. 12
Installation Instructions Installation accessories 1.Accessories Note: All mentioned accessories are prepared or purchased by user. RWC-3217 50 600 10 3 2 20 5 1. buffer 2.leveling pad 3. seal foam pad 4. decorating strip 15 Note: All mentioned accessories are prepared or purchased by user. RWC-4717 50 750 2 10 5 3 20 15 1. Buffer 2.leveling pad 3. seal foam pad 4. decorating strip 11 375 468 40 40 700 550 454 550
Inhaltszusammenfassung zur Seite Nr. 13
Installation Instructions Installation Requirements 2. Installation requirements 1.Accessories Leave a space more than 100 cm at the rear of the appliance and ensure the outdoor air intake not be blocked. A wooden frame as shown in fig.1 is advisable if the appliance is installed through a window. The installation bracket as shown in fig.2 should not be welded with the window sash. The square hole should be smooth enough if the appliance is installed through a wall. A space as shown in fig.3
Inhaltszusammenfassung zur Seite Nr. 14
HRHRFF ON/OFF HRHRFF FF HRHR ON/OFF ON/OFF Installation Instructions 1.Accessories Installation Steps 1.Accessories Test the appliance by plugging the power supply cord in a correct outlet of power source before installation. A clearance of 20 mm is advisable between the appliance cabinet and the wall. Fix the indoor air intake panel with the cabinet by employing two screws which packed in the packing bag as shown in Fig.5. Put the buffers on the installation bracket as shown in Fig.6. Adjust
Inhaltszusammenfassung zur Seite Nr. 15
NEC Australia Pty. Ltd ABN 86 001 217 527 Home Electronics Group NEC Service Centres NEW South Wales Sydney 184 Milperra Rd, Revesby 2212 (02) 9780 8688 Newcastle 120 Parry Street, Newcastle 2302 (02) 4926 2466 Victoria Melborne 480 Princes Highway, Noble Park 3174 (03) 9554 6245 Queensland Brisbane 116 Ipswich Rd, Woollongabba 4102 (07) 3361 5858 Southport
